Sure Wave CQL1437-B Round Bluetooth Speaker User Manual
Sure Wave (HongKong) Limited Round Bluetooth Speaker Users Manual
Users Manual
CQL1437-B Bluetooth Speaker
Instruction Manual (Read Before Proceeding)
Power:
Works on internal rechargeable Lithium battery. Please charge your speaker fully
before first use. To charge the battery:
Using a Micro USB cable (included), insert the jack into the ”Charging” hole located at
the back of the unit and then plug the USB connecter into the USB port on a computer
for charging.
A red light on the bottom will indicate the charging situation. When battery is full, the
red light will turn off automatically.
Bluetooth Speaker Operation
Turn on the unit by pushing the switch at back to “on” position. A Blue light aside will
start blinking to indicate the speaker is in paring mode and searching for your
Bluetooth mobile device.
Open the Bluetooth function on your device and search the speaker named “XXX”.
After selecting this speaker, your device will pair without a password. (If required,
enter the password “0000” to finalize the paring).The Blue light will begin flashing
slowly after pair is complete.
Start playing music on your device. Keep your device within 33 feet (10 meter) of your
speaker.
Adjust the volume of your device to a comfortable level. Turn on the unit and start
playing music.
For other music devices without Bluetooth, use the auxiliary audio input cable. Insert
the 3.5mm jacks into the “AUX-IN” hole located inside the battery compartment, and
the earphone hole on your device.
Turn off the unit when not used.
Caution:
This is not a toy. Please keep away from small children.
Please keep away from water/heat.
Low power may cause poor connection even no working of Bluetooth.
Do not overcharge the battery.
Battery pack shall not be exposed to excessive heat such as sunshine, fire or the like.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure requirement. The device can
be used in portable exposure condition without RF striction