Sure Wave CQZ407-B iSilicone l Bluetooth Speaker User Manual
Sure Wave (HongKong) Limited iSilicone l Bluetooth Speaker
User Manual
CQZ407-B Bluetooth speaker
FCC ID: 2AAPLCQZ407-B
Instruction Manual (Read before proceeding)
Power
z Using a DC 5V adaptor（not included）or USB cable (included), insert the plug into the
micro USB port located on the back of the unit.
z A red light in the back will indicate the charging situation. When battery is full, the red
light will turn off automatically.
Bluetooth Speaker Operation
z Turn on the unit by pushing the ON/OFF switch on the back. A Blue light will start
blinking to indicate the speaker is in pairing mode and searching for your Bluetooth
mobile device.
z Bluetooth speaker device name is “SB-01”. After selecting this speaker, your device
will pair without a password. (If required, enter the password “0000” to finalize the
paring).The Blue light will begin to flashing slowly after pairing successfully.
z Start playing music on your device. Keep your device barrier free within 33feet (10m)
of your speaker.
z Adjust the volume of your device to a comfortable level.
z Turn off the unit when not in used.
Universal Speaker Operation
z For other music devices without Bluetooth, use the attached audio input cable. Insert
the 3.5mm jacks into the “AUX-IN” hole and the earphone hole on your device.
z Turn on the unit and start playing music.
Caution:
z This is not a toy. Please keep away from small children.
z Please keep away from water / heat.
z Low power may cause poor connection even no working of Bluetooth.
z Do not over charge the battery.
z Battery pack shall not be exposed to excessive heat such as sunshine, fire or the like
FCC Statement
z This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
z Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help
Because the outside of the product is easy to take off, so the label is placed on the inside
shell of the product.