Sure Wave CQZ501-B iColor Lighting Bluetooth Speaker User Manual
Sure Wave (HongKong) Limited iColor Lighting Bluetooth Speaker
User Manual
CQZ501-B iColor Lighting Bluetooth Speaker
Instruction Manual (Read before proceeding)
Power:
Works on internal rechargeable Lithium-ion battery. Please charge your speaker fully
before first use. To charge the battery :
Using a DC 5V adaptor (not included) or USB cable (included), insert the jack into the
3.5mm DC hole located in the back of the unit.
A red light in the front will indicate the charging situation. When battery is full, the red
light will turn off automatically.
Bluetooth Speaker Operation
Turn on the unit by pushing the power ON/OFF switch in the back to ON position.
Green light in front indicates the power situation.
Turn on the Bluetooth Function of unit by pushing the Bluetooth ON/OFF switch in the
back to ON position. A Blue light will start blinking to indicate the speaker is in paring
mode and searching for your Bluetooth mobile device.
Open the Bluetooth function on your device and search the speaker named “SB-01”.
After selecting this speaker, your device will pair without a pin. (If your device need
pair pin, enter the pin “0000” directly from your device and hit “OK”) .The Blue light
will begin to flashing four times every 3 seconds after pair is complete.
Start playing music on your device. Keep your device within 33feet (10m) of your
speaker.
Adjust the volume of your device to a comfortable level.
Turn off the unit when not in used.
Color Light Operation
Turn on the color light by touching the circular button in the front when the unit is
power on.
Translucent cabinet changes in 7 colors gradually every 5 seconds.
Turn off the color light by touching the circular button again.
Universal Speaker Operation
For other music devices without Bluetooth, use the auxiliary audio input cable. Insert
the 3.5mm jack into the “AUX-IN” hole and the earphone hole on your device.
Turn on the unit and start playing music.
Caution:
This is not a toy. Please keep away from small children.
Please keep away from water / heat.
Low power may cause poor connection even no working of Bluetooth.
Do not over charge the battery.
FCC STATEMENT
1. This device complies with Part 15 or the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. FCC Radiation
Exposure Statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without RF striction.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 or the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications, However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
--- Reorient or relocate the receiving antenna.
--- Increase the separation between the equipment and receiver.
--- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--- Consult the dealer or an experienced radio/ TV technician for help.