Sure Wave CQZ506-B Bluetooth Speaker User Manual
Sure Wave (HongKong) Limited Bluetooth Speaker
User Manual
CQZ502-B iLight Bluetooth Speaker
Instruction Manual (Read before proceeding)
Power for Bluetooth speaker:
Works on internal rechargeable Lithium-ion battery. Please charge your speaker fully
before first use. To charge the battery :
Using the power adaptor (included), insert the jack into the micro hole named
“Charging” in the back of the unit, a red light aside will indicate the charging situation.
When battery is full, the red light will turn off automatically.
Power for lamp:
Using the power adaptor (included), insert the jack into the micro hole named
“Charging” in the back of the unit.
Bluetooth Speaker Operation:
Turn on the unit by pushing the “Bluetooth ON/OFF” switch at the back to ON position.
A Blue light will start blinking to indicate the speaker is in paring mode and searching
for your Bluetooth mobile device.
Open the Bluetooth function on your device and search the speaker named
“SBT5004”. After selecting this speaker, your device will pair without a pin. (If your
device need pair pin, enter the pin “0000” directly from your device and hit “OK”) .The
Blue light will begin to flash more slowly after the pair is complete.
Start playing music on your device. Keep your device within 33 feet (10m) of your
speaker.
Adjust the volume of your device to a comfortable level.
Turn off the unit when not used.
Light Operation:
Turn on the unit by pushing the switch “POWER ON/OFF” switch at back to “ON”
position.
Turn off the light by switching to “OFF” position.
Charging Port:
Using the power adaptor (included), insert the jack into the micro hole named
“Charging” in the back of the unit.
To charge your digital device, use a USB cable and insert the jack into to the big hole
named “USB 5V” in the back and insert the other side to your digital device.
Caution:
This is not a toy. Please keep away from small children.
Please keep away from water/heat.
Low power may cause poor connection even no working of Bluetooth.
Do not overcharge the battery.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation