Sweda WT7760 Runner Wireless Hands Free Beanie User Manual Instruction manual WT7760 final

Sweda Company LLC Runner Wireless Hands Free Beanie Instruction manual WT7760 final

User Manual

Instruction Manual for WT7760Size: 330X145mm1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC StatementRF Warning StatementThe device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. beanieMade in ChinaPress and hold the + button to increase the volume. When the device is at maximum volume,you will get a voice prompt “ Max Volume”Press and hold the - button to decrease the volume. When the device is at minimum volume, you will get a voice prompt “ Min Volume”Do not expose the wireless beanie to liquids or moistureDo not tamper with, drop, disassemble, open or crush the beaniebeaniebeaniebeaniebeanie.Pull out the wireless module before washing the beaniebeanieConnect the beanie to a computer or USB charge device using a micro USB cable.The LED light will turn RED while charging and turn OFF when fully charged.If the battery has less than 15% charge remaining, the Headphone will auto power off.When the battery has less than 20% charge remaining, you will hear a voice prompt “please charge”Press the “play/pause” button for approximately three seconds to turn the beanie ON. Once it is ON, a Blue LED light will start flashing, followed by voice prompts: power on. Press the “ play/pause” button for approximately three seconds to turn the beanie OFF.Once it is OFF, the LED light will turn off too, followed by voice prompts: power off. Speaker Output Power:10mwPairing name: RunnerWireless moduleChip Version: 2.1+ EDRWireless beanieRunnerRunnerRunnerWireless BeanieLi-ion batteryWireless BeanieWireless

Navigation menu