Syabas Technology 1OTT OTT User Manual 1OTT
Syabas Technology Hong Kong, Limited OTT 1OTT
User Manual
2nd Screen Video
Share your iOS or Android devices by mirroring the screen to your TV.
Step 1. Install miracast from apps market.
Step 2. On your Miracast capable device, search for and connect to the 1OTT. This is done
different ways depending on your device's software. When the device starts to establish a
connection, you should see the following screen.
Step 3. Some devices may require you to enter a personal identification number (PIN). If
that's the case, a PIN will be displayed on the screen like so. If your device does not require a PIN,
you should see your screen mirrored on the TV now.
Please refer to http://support.cloudmedia.com/article.aspx?ID=1160 for a more detail guide.
The product shall only be connected to a USB interface of version
USB2.0
Adapter shall be installed near the equipment and shall be easily
accessible.
The plug considered as disconnect device of adapter
Adapter: DC 5V /1A
Input: AC 100-240V 50/60Hz 0.2A
Output: DC 5.0 V 1A
Warning：
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with
any other antenna or transmitter
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance of 20cm the radiator your body. This device
and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter