Syncomm Technology RADIOPORTB1990 RADIO PORT User Manual Manual

Syncomm Technology Corp. RADIO PORT Manual

User Manual

SYNCOMM Proprietary 1SYNCOMM Radio Port operation manual 1.Environment Radio Port Antenna RS232 Cable: one set Power module or Power supply: one set PC or Notebook: one set RP PC Power Module Antenna Wire RS-232 Figure 1-1 Connection view of operation environment Attention issues: (1). Please make sure the antennas are connected with Radio port before power on (2). If no power module, you could use power supply
SYNCOMM Proprietary 22.Explication of operation (1). Firstly, setup the environment as figure 1-1. (2). Run Hyper Terminal, setup it and prepare for monitor RP’s state. (Please refer the third item for how to setup hyper terminal) (3). Setup the parameter of RP. (Please refer the fourth item for setup various parameter in RP) 3.Explication of how to setup Hyper Terminal) Step 1: Run Hyper terminal Figure 3-1 the path for executing Hyper Terminal After ran the Hyper Terminal you could see the status as below. If you couldn’t find Hyper Terminal, you must re-install it Hyper Terminal
SYNCOMM Proprietary 3 Figure 3-2 the screen after ran Hyper Terminal Step 2: Setting connection port In figure 3-2,select “file”, select “content”, then get the screen as below Figure 3-3 Select connection port Step3: Port setting Set the port that you connect PC and RP use RS232
SYNCOMM Proprietary 4Set the data transfer rate (bits/second), bits per unit, parity check, stop bits, data flow control as below. Figure 3-4 Hyper Terminal port setting 4.Various parameter setting After we done all the preceding action, we turn on the power of RP and watch the windows of Hyper Terminal (1). At first, the word “login” show on the window, and please input the password 123
SYNCOMM Proprietary 5 (2). Enter main menu (3). Input “rd” & press “Enter” to enter Research mode, there are three kinds of mode, normal mode, research mode, and test mode
SYNCOMM Proprietary 6 (4). Input 2 to enter RF test menu (5). After enter RF Test menu, you can control to turn on of turn off transmitter
SYNCOMM Proprietary 7(6). If you Select 3, you can set the output power of transmitter, the range from 0 to 255, mapping to output power level from 0 to 800 mW, you can use this way to setting output power level to correct output power level. (7). Select 4, you can set the operation frequency of transmitter, range from 0 to 599, mapping to 1.93 GHz to 1.99GHz
SYNCOMM Proprietary 8

Navigation menu