Sysgration AXM-915S Optical Mouse User Manual MOUSE User s Manual
Sysgration Ltd. Optical Mouse MOUSE User s Manual
Manual
2.4G Wireless Mouse Users’ Guide
Installation 1
. Wireless Mouse with cursor
1 batterie AA
Guida per l’utente
1X guida alla garanzia
Installation 2（setting up your wireless mouse）
1. lnstalling the battery,if the mouse is on,slide the on/off switch located on the side of
mouse to the”off position.
2. lnsert the supplied battery,making sure the positive(+)and negative(-)ends of the
battery match the polarity indicators the battery compartment
3. slide the battery cover back into position until it clicks into place
4. turn on the presenter
Note:
FCC statement:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on. The user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to computer
or peripheral devices).
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.