T L Parker RDX-U1 UHF mobile transceiver User Manual RDXUserGuide
T L Parker Ltd UHF mobile transceiver RDXUserGuide
User manual
OPERATION
The RDX series RF modules are designed for integration into various radio systems products.
The module has no user controls as such and is designed for use in applications such as low
power control stations and mobile relay /mobile repeater stations, where other 3rd party circuitry
will provide for user interface and controls.
The modules are based on Motorola ASTRO XTS3000 series poratble radios.
The modules interface connector provides standard input/output audio interfaces, logic indication
of squelch conditions, and logic level selection of the pre-programmed channels/personality modes,
in addition to serial bus control. Various parameters including RF Power is programmable via a
Motorola XTS3000 Radios Service Software (RSS) from 1-3Watts on 800MHz models, 1-4watts on
UHF modules and 1-5 watts on VHF models.
NOTE: RF Power output MUST be set so as to not
exceed the permissable FCC regulatory level prior to the units deployment.
The module is designed to connect to a unity gain 1/4 wave antenna. Other antennas may only
be used providing they ensure the installation continues to comply with FCC licensing requirements.
DC POWER:
The RDX series modules are designed for operation from a nominal 7.5VDC source. The unit will operate
within specification over a voltage range from 6.0 to 8.4Volts DC. Current consumption for the module
is 120mA on standby.
Installation:
The RDX modules must be installed using best RF engineering practice. The units are shielded to minimize
RF interference from other co-located transceivers but attention should be made to frequency planning to
ensureunwanted interfernce, intermodulation or Receiver desensitization occurs. There small compact size,
low current consumption make them ideal for incorporation into emergency battery powered portable
repeaters, temporary remote rf Control station and other relation mobile applications.
Product of New Zealand /Motorola XTS3000 radios Made in USA
ASTRO & XTS3000 are trademarks of Motorola Inc.
RDX Series
RF Module User Guide
SECURE / ENCRYPTION OPERATION ( Optional)
RDX RF modules may optionally fitted with Motorola ASTRO XTS3000 encryption modules.
Encrypted mode should be slaved to the 16 programmable modes. Only one encryption key
is available. Keys can be entered using a standard Motorola Key Loader and an appriate interface cable
.
General Safety.
NEVER hold the antenna when theRF Module is “IN USE”.
Keep all parts of the body at least 8inches ( 20cm) from Antenna whip.
ELECTROMAGNETIC INTERFERENCE
Most electronic devices are susceptible to electromagnetic interference (EMI). To avoid electromagnetic
interference and/or compatibility conflicts, turn off the X-Ponder anywhere posted notices instruct you to
do so. The Health Industry Manufacturers Association recommends that a minimum separation of 6 inches
(15 centimeters) be maintained between a wireless radio and a pacemaker. Turn the unit OFF immediately
if you feel that interference is taking place. Digital radios may interfere with some types of hearing aids.
If such interference occurs, you may want to consult ithe aids manufacturer.
EXPLOSIVE ATMOSPHERES
Do not operate the X-Ponder in any area with a potentially explosive atmosphere. Areas such as fueling areas,
chemical handling facilities, or areas where the air contains chemicals or particles, such as grain dust or metal
powders. NEVER charge,remove or install batteries as sparks in such a potentially explosive atmosphere can
cause an explosion or fire resulting in injury or death. To avoid possible interference with blasting operations,
do not operate the module near electrical blasting caps, in a blasting area, or in areas posted:
“Turn off two-way radio.” Always obey all signs and instructions.
ELECTROMAGNETIC ENERGY (EME)
The Motorola XTS3000 radios inside are designed to comply with the following international standards and
guidelines regarding exposure of humans to electromagnetic energy (EME):
• USA Federal Communications Commission, Regulations; 47 CFR part 2 sub-part J
• American National Standards Institute (ANSI) / Institute of
Electrical and Electronic Engineers (IEEE) C95. 1-1992
• Institute of Electrical and Electronic Engineers (IEEE) C95.1-199 Edition
• USA National Council on Radiation Protection and Measurements, Report 86, 1986
• Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to
Electromagnetic Fields in the Frequency Range from 3 kHz to 300 GHz, 1999
• International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998
Wireless Pacific
Wireless Pacific