TAKSTAR ELECTRONIC TS-8807HH Wireless Microphone User Manual

GUANGDONG TAKSTAR ELECTRONIC CO., LTD. Wireless Microphone

user manual

TS-8807TS-8807User's Manual UHF Wireless Microphones GUANGDONG TAKSTAR ELECTRONIC CO., LTD.Address: Xialiao Longxi Boluo Huizhou Guangdong China 516100 Tel: +86 752 6383897 / 6383644 Fax:+86 752 6383952Website: www.takstar.com
Security:4• Do not apply any strong shock to it.• Please place the batteries according to correct polarities. Take out the batteries when not using it for a long time. Annoucement:• is a protected and registered trademark • Product and contents described in the user manual are subject to change without prior notice1Handheld Microphone:1234(1) Wire-mesh cap and capsule: wire-mesh cap protects the capsule, eliminates “pop” noise and avoids rolling when laid flat.(2) LCD display: indicate frequency/channel and battery power level.(3) Power switch: press once, it is on; press again, it is off.(4) Microphone housing: assemble wire-mesh capsule and capsule on the top, with batteries, PCB board inside, and antenna at the rear.Specification:TransmitterPower Supply: 2pcs 1.5V AA batteriesPlaytime: 10hrs(depending on batteries)Operating Range: 50m(depending on environment)Operating Temperature: -20° -60°Output Type: Independent Balanced and Unbalanced Outputs
32Trouble Shooting:Troules Possible reasonsNo RF signal on receiver Frequency of transmitter and receiver is not the same or out of operating range With RF signal, but no audio signalMicrophone is not connected or squelch level of receiver is too highBackground noise of audio signal is too loud Frequency deviation is too low;output level of receiver is too low;check if there is an interfering signal Audio signal distortion Frequency deviation is too high;output level of receiver is too highOperating distance is too short, signal is not stableTransmitter is set at low power;squelch level of receiver is too high; receiver antenna is wrong placed; there is a strong electro-magnetic interferenceIf there are other troubles, please contact us or your local distributor or retailer. Please do not dismantle the products as it will void warranty.678(6) Infra-red data synchronization window: send frequency signal to transmitters by pressing “SET” on receiver.(7) Lock switch: if it is set at “ON” position, the power switch is locked and can only be used for mute function.(8) Power adjusting switch: choose high or low transmit power. 5(5) Battery compartment: put in 2pcs AA batteries.1.How to use handheld microphone:(1) Hold the middle part of microphone. If the hand is too close to the wire mesh, the sound will be influenced; if the hand is too close to the antenna at bottom, the operating distance will be shortened.(2) By changing the distance between microphone head and mouth, the sound volume will be increased or reduced.
FCC WARNING This device complies with Part 74 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: The manufacturer is not responsible for any changes or modifications not expressly approved by the manufacturer for compliance, such modifications could void the user’s authority to operate the equipment. NOTE 2: This device complied with FCC radiation exposure limits as set forth for an uscontrolled environment. This device should be installed and operated so that its antenna(s) are not co-located or operating in conjunction with any other antenna or transmitter

Navigation menu