TAT Electronics T14 Remote Control User Manual 15 T14 UserMan

Download:
Mirror Download [FCC.gov]
Document ID	3556092
Application ID	tq3NFxAEhkn/gOoWOaRo5Q==
Document Description	15_T14 UserMan
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	18.95kB (236866 bits)
Date Submitted	2017-09-11 00:00:00
Date Available	2017-09-12 00:00:00
Creation Date	2017-08-19 16:19:36
Producing Software	Microsoft® Office Word 2007
Document Lastmod	2017-08-19 16:19:36
Document Title	15_T14 UserMan
Document Creator	Microsoft® Office Word 2007
Document Author:	Administrator

User Manual
Remote Control
Model: T14
FCC ID: 2AM69T14
1 Pairing Procedure
Long press shutter button B to enter setup, press power button A to navigate. Press
shutter button B to enter general setting, select RF CTRL. Turn on RF CTRL.
With camera RF CTRL on, press power Remote Control button and hold on for
3seconds to turn on the controller and pair . The LED Indicator will blink blue.
Using your remote
Photo Shot: Press the Photo button once to shoot a single picture, the LED indicator
of remote flickers twice.
Video Record: Press the Video button once to start recording, the LED indicator
flickers twice also, press the Video button again to stop.
Power Off button: Press the Power Off button and hold on for 3seconds to turn off
the camera, the LED indicator turns off accordingly.
3 Replace the Battery
When the battery capacity is low, LED indicator flickers once per second. You need
to replace with a new button battery.
How to replace a button battery?
1. Begin by purchasing a replacement battery for your remote. You need a button
battery with model No. CR2032.
2. Screw the round cap at the bottom of remote. Please see above pictures.
3. Remove the old battery.
4. Insert the new battery into the slot where the old battery was, with the flat
surface up.
Note:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This modular complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 3
Language                        : zh-CN
Tagged PDF                      : Yes
Author                          : Administrator
Creator                         : Microsoft® Office Word 2007
Create Date                     : 2017:08:19 16:19:36+08:00
Modify Date                     : 2017:08:19 16:19:36+08:00
Producer                        : Microsoft® Office Word 2007

EXIF Metadata provided by EXIF.tools