TCL Communication B073 GPS Tracker User Manual Ref GPS Tracker QG EN v0 6 20160913

Download:
Mirror Download [FCC.gov]
Document ID	3138610
Application ID	tiqsjFBpDBx6zdWuZ9cSpg==
Document Description	Ref_GPS Tracker_QG_EN v0.6 20160913
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	84.03kB (1050360 bits)
Date Submitted	2016-09-19 00:00:00
Date Available	2016-09-21 00:00:00
Creation Date	2016-09-14 16:23:55
Producing Software	Adobe PDF Library 10.0.1
Document Lastmod	2016-09-14 16:23:56
Document Title	Ref_GPS Tracker_QG_EN v0.6 20160913
Document Creator	Adobe InDesign CS6 (Windows)

Quick Start Guide
CJB1GS0ALAAA
What’s In The Box
or
Please read this document carefully before using your device.
Inserting Your Nano-SIM
1.
2.
Remove the Nano-SIM cover using the supplied screwdriver.
Insert your Nano-SIM.
3.
Replace the Nano-SIM cover
and tighten the two screws.
Device Overview
⑤
① ② ③
④
①
Battery indicator
②
GPS indicator
③
Network indicator
④
Power button
⑤
Micro-USB port
⑥
Nano-SIM Card cover
⑥
Category
Description
Battery
indicator
• Blinks red during charging
• Lights blue when fully charged
• Lights red when battery level is low
GPS indicator
• Blinks red when searching for a GPS signal
• Lights blue when your MOVETRACK has
found its GPS location.
• Lights red when your MOVETRACK is unable
to find its GPS location
Network
Indicator
• Lights blue when connected to the cellular
data network.
• Lights red when there is no network
coverage (please ensure that your Nano-SIM
is inserted correctly).
Power On/Off
• Press once to show battery/GPS/network
status.
• Press and hold for 3 seconds to turn on your
MOVETRACK.
• Press and hold for 3 seconds to turn off your
MOVETRACK.
Category
Description
Micro-USB port For charging and data transfer.
Nano-SIM card
Remove to access Nano-SIM.
cover
Charging Your MOVETRACK
Plug the micro-USB cable into your MOVETRACK and connect it to a
USB charger or any 1A/5V USB port.
• When charging, the battery light will blink red.
• The battery is fully charged when the battery light changes to blue.
Warning: Charge your MOVETRACK for at least 2 hours before first
use.
Powering on Your MOVETRACK
Press and hold the power on/off button for 3 seconds, all LEDs will
light up indicating that your MOVETRACK is now on and ready for use.
Note: Press and hold the power on/off button for 3 seconds to turn
off your MOVETRACK.
Pairing with Your Smartphone
1.
Download the MOVETRACK App using the appropriate QR code
shown below, or alternatively search for ‘MOVETRACK’ on the
App Store or on Google Play.
App Store
QR CODE
2.
Google Play
QR CODE
Open the MOVETRACK App, register your account by following
the in-app instructions, and log in.
3.
4.
Select Select the option I want to add a new tracker.
Enter the unique identifier of your MOVETRACK (IMEI). The IMEI
can be found on the back of your MOVETRACK.
5.
6.
Enter your name and phone number.
Enter a profile picture as your icon. You can use the default image
or a photo from your phone.
Enter a name and profile picture for your MOVETRACK. You can
use the default image or a photo from your phone.
Your MOVETRACK and phone are now successfully paired.
7.
8.
Using your MOVETRACK
A luggage tag or a pet tag is included with your MOVETRACK.
Using the luggage tag
Unfasten the luggage tag and insert your MOVETRACK as shown
below. Please ensure that you align the Power button on your
MOVETRACK with the button on the side of the luggage tag.
Using the pet tag
Insert your MOVETRACK into the pet tag as shown below. Please align
the cut-out window so that the 3 notification icons are visible.
FAQ
1.
2.
3.
4.
Are any of the materials used in this product harmful to children?
The material in use has passed all related safety testing for
children, it is safe for daily use.
Why is my MOVETRACK not charging?
If your MOVETRACK is not charging, follow the steps below:
• Ensure that the metal charging contacts on the back of your
watch are aligned correctly with the pins on the charging
cradle.
• Check that there is no dirt or corrosion on the metal charging
contacts or the charging cradle pins.
• Check that the pins on the charging cradle are intact.
Can I make calls to my MOVETRACK?
Your MOVETRACK does not support voice calling.
How many users can monitor my MOVETRACK simultaneously?
10 users can monitor your MOVETRACK at any one time. You
can invite users by sharing the QR code on the Invite User page
in the App.
5.
6.
7.
How come I cannot obtain the position of my MOVETRACK?
• Please confirm your Nano-SIM card is enabled for data.
• Check if a Nano-SIM card is correctly inserted in your
MOVETRACK.
• Check that your MOVETRACK's battery level.
• Ensure that your MOVETRACK has access to a clear signal.
• Switch your MOVETRACK off and on to restore service.
Why does it take so long to find my location?
Check which power-saving mode is selected. In manual mode,
your MOVETRACK can only find your location when you press
the
button.
Note: If you enable the Auto change to Manual mode, your
MOVETRACK will auto-switch to manual mode once the power
level is less than 20%.
Is my MOVETRACK waterproof?
This device is rated to IP67 which can protect the MOVETRACK
from splashing water. Do not wear your MOVETRACK whilst
immersed under water for extended periods, for example whilst
swimming, diving or bathing.
10
8.
What do you use my personal data for?
Your personal data will not be used for advertising purposes,
unless you have given us your express consent. Moreover, we
will not transfer your personal data to any third parties without
your express consent. The transfer of personal data to public
institutions and public authorities that are entitled to receive
such information, will only be carried out to the extent required
by law or if we are obliged to do so by virtue of a court order
or court ruling. If we commission third parties to provide certain
services for us, such third parties will only have limited access to
personal data, insofar as this is necessary to provide such services.
Such third parties are bound to comply with the applicable data
protection laws and our Privacy Policy while processing personal
data.
11

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27
Create Date                     : 2016:09:14 16:23:55+08:00
Metadata Date                   : 2016:09:14 16:23:56+08:00
Modify Date                     : 2016:09:14 16:23:56+08:00
Creator Tool                    : Adobe InDesign CS6 (Windows)
Instance ID                     : uuid:abf970c5-9916-46cb-bd7e-03611bd1ee68
Original Document ID            : xmp.did:7B0F08C3677BE411ADEC857A3EF77E38
Document ID                     : xmp.id:7E548893547AE61199B5CA7AFEBF3320
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:1D8D878F547AE61199B5CA7AFEBF3320
Derived From Document ID        : xmp.did:40F63D898979E61180628337F90855AF
Derived From Original Document ID: xmp.did:7B0F08C3677BE411ADEC857A3EF77E38
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CS6 (Windows)
History Changed                 : /
History When                    : 2016:09:14 16:23:55+08:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 10.0.1
Trapped                         : False
Page Count                      : 12
Creator                         : Adobe InDesign CS6 (Windows)

EXIF Metadata provided by EXIF.tools