TCL Technoly Electronics OH000009 Beacon User Manual

TCL Technoly Electronics (Huizhou) Co., Ltd. Beacon Users Manual

Users Manual

User manual Trade name: WHERE Model: EXTx Product : Beacon/信標 The EXTx product is a low energy 4.1 version, the launch frequency of 2.4G Bluetooth signal transmitter, you can send the Bluetooth signal to the outside world. The product's main chip (Bluetooth chip) is Qualcomm's CSR1012, peripheral with 512Kbit EEPROM memory chip, used to store product software; use CR2032 3V button Lithiumbattery-powered, the product has a LED status indicator and a reset button. Shell with full plastic shell. When the product was loaded into the button battery, it starts work, the red light will flash, and then will continue to broadcast the Bluetooth signal, other equipment and products can be collected to the product, refer to PIC-1; Open bluetooth switch of device, refer to PIC-2 Open apps, refer to PIC-3,and search to EXTx ,refer to PIC4 PIC-2 PIC-1
and through the BLE (Low-power version 4.1 of Bluetooth) to establish a connection from the EXTx products to obtain relevant information, such as location information and work status and so on, refer to PIC-5 PIC-5 PIC-4 PIC-3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC Statement This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Canada Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf. NCC 警告語 本產品符合低功率電波輻射性電機管理辦法： 第十二條 經形式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方的繼續使用。 前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

Navigation menu