User Manual
Z
CR-H101
CD Receiver
OWNER’S MANUAL
MODE D’EMPLOI
MANUAL DEL USUARIO
ENGLISH
FRANÇAIS
ESPAÑOL
2
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
<The lightning flash with arrowhead
symbol, within an equilateral trian-
gle, is intended to alert the user to
the presence of uninsulated “dan-
gerous voltage” within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of elec-
tric shock to persons.
BThe exclamation point within an equi-
lateral triangle is intended to alert
the user to the presence of import-
ant operating and maintenance
(servicing) instructions in the litera-
ture accompanying the appliance.
WARNING: TO PREVENT FIRE OR
SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
CLASS " apparatus with double insulation,
and no protective earth provided.
CAUTION
oDO NOT REMOVE THE EXTERNAL CASES OR
CABINETS TO EXPOSE THE ELECTRONICS. NO
USER SERVICEABLE PARTS ARE INSIDE.
oIF YOU ARE EXPERIENCING PROBLEMS WITH THIS
PRODUCT, CONTACT THE STORE WHERE YOU
PURCHASED THE UNIT FOR A SERVICE REFERRAL.
DO NOT USE THE PRODUCT UNTIL IT HAS BEEN
REPAIRED.
oUSE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
IN USA/CANADA, USE ONLY ON 120 V SUPPLY.
The nameplate is located on the bottom of the unit
as shown below.
Nameplate
Front side
IMPORTANT SAFETY INSTRUCTIONS
3
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
8) Do not install near any heat sources such as radi-
ators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polar-
ized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A
grounding type plug has two blades and a third
grounding prong. The wide blade or the third
prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an elec-
trician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
11) Only use attachments/accessories specified by
the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
14) Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has
been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
oThe apparatus draws nominal non-operating
power from the AC outlet with its POWER or
STANDBY/ON switch not in the ON position.
oThe mains plug is used as the disconnect device,
the disconnect device shall remain readily
operable.
oCaution should be taken when using earphones
or headphones with the product because exces-
sive sound pressure (volume) from earphones or
headphones can cause hearing loss.
CAUTION
oDo not expose this apparatus to drips or
splashes.
oDo not place any objects filled with liquids,
such as vases, on the apparatus.
oDo not install this apparatus in a confined
space such as a book case or similar unit.
oThe apparatus should be located close
enough to the AC outlet so that you can
easily reach the power cord plug at any time.
oIf the product uses batteries (including a bat-
tery pack or installed batteries), they should
not be exposed to sunshine, fire or excessive
heat.
oCAUTION for products that use replaceable
lithium batteries: there is danger of explosion
if a battery is replaced with an incorrect type
of battery. Replace only with the same or
equivalent type.
VPrecautions concerning batteries
Misuse of batteries could cause them to rupture or
leak leading to fire, injury or the staining of nearby
things. Please read and observe the following pre-
cautions carefully.
oBe sure to insert the batteries with correct posi-
tive (¥) and negative (^) orientations.
oUse batteries of the same type. Never use differ-
ent types of batteries together.
oIf the remote control is not used for a long time
(more than a month), remove the batteries to
prevent them from leaking.
oIf the batteries leak, wipe away the leakage inside
the battery compartment and replace the batter-
ies with new ones.
oDo not use batteries of types other than those
specified. Do not mix new batteries with old ones
or use different types of batteries together.
oDo not heat or disassemble batteries. Never
throw batteries into fire or water.
oDo not carry or store batteries with other metallic
objects. The batteries could short circuit, leak or
explode.
oNever recharge a battery unless it is confirmed to
be a rechargeable type.
4
Compliance of radio transmitter and
interference
Model for USA
Declaration of Conformity
Responsible party:
TEAC AMERICA, INC.
Address: 1834 Gage Road,
Montebello, California, U.S.A.
Telephone number : 1-323-726-0303
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two con-
ditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Labeling of authorization
FCC ID: XEGCR-H101
Model for Canada
Compliance of radio transmitter
This device complies with Industry Canada's
license-exempt RSSs. Operation is subject to the
following two conditions:
1) This device may not cause interference; and
2) This device must accept any interference, includ-
ing interference that may cause undesired
operation of the device.
Labeling of authorization
IC: 1559C-CRH101
Compliance of interference
This Class B digital apparatus complies with Canadian
ICES-003.
CAUTION
Authorization of wireless devices are different in
countries or regions. Please use only in the country
where you purchased the product.
oDepending on the country, restrictions on the
use of Bluetooth wireless technology might exist.
Wireless equipment precautions
Radiation Exposure requirements
This equipment meets the regulation, which is recog-
nized internationally, for the case of human exposure
to radio waves generated by the transmitter.
Statement of compliance
Model for USA
This equipment complies with FCC radiation expo-
sure limits set forth for an uncontrolled environment
and meets the FCC radio frequency Exposure
Guidelines.
Model for Canada
This equipment complies with IC RSS-102 radia-
tion exposure limits set forth for an uncontrolled
environment.
CAUTION
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
5
Laser information
This product contains a semiconductor laser system
inside the cabinet and is classified as a “CLASS 1 LASER
PRODUCT”.
To prevent being exposed to the laser beam, do not
try to open the enclosure.
Laser:
Type: EP-HD870PB
Manufacturer: GUANGDONG EVER BRIGHT GROUP
CO.,LTD
Laser output: Less than 1 mW on the objective
lens
Wavelength: 792±25 nm
Model for USA
This product has been designed and manufactured
according to FDA regulations “title 21, CFR, chapter
1, subchapter J, based on the Radiation Control for
Health and Safety Act of 1968”, and is classified as class
! laser product. There is not hazardous invisible laser
radiation during operation because invisible laser
radiation emitted inside of this product is completely
confined in the protective housings.
The label required in this regulation is as follows:
Front side
Bottom
Information for interference
(FCC requirements)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful inter-
ference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user
is encouraged to try to correct the interference by
one or more of the following measures.
oReorient or relocate the equipment and/or the
receiving antenna.
oIncrease the separation between the equipment
and receiver.
oConnect the equipment into an outlet on a cir-
cuit different from that to which the receiver is
connected.
oConsult the dealer or an experienced radio/TV
technician for help.
1115 MA-2225A
This device has a serial number located on its back panel. Please record the serial number
and retain it for your records.
Model name: CR-H101 Serial number
TEAC CORPORATION 1-47 Ochiai, Tama-shi, Tokyo 206-8530, Japan Phone: +81-42-356-9156
TEAC AMERICA, INC. 1834 Gage Road, Montebello, California 90640 U.S.A. Phone: +1-323-726-0303
TEAC AUDIO EUROPE Liegnitzer Straße 6, 82194 Gröbenzell, Germany Phone: +49-8142-4208-141
Z