TOYS R US 912849 49MHz WIRELESS REMOTE CONTROL CAR-RX User Manual Incredible Manual ai

TOYS "R" US 49MHz WIRELESS REMOTE CONTROL CAR-RX Incredible Manual ai

USERS MANUAL

(Diagram 7)(Diagram 1)(Diagram 2)(Diagram 3)(Diagram 6)(Diagram 5)BackwardForwardStraightTurboLeftOnOffStopRightBFRRLL1:16 Incredible Instruction  Prints 1 Color Process BlackFolded size: 65mm x 121mmExtended size: 392mm x 121mmUSING 6V BATTERY PACK:1. Slide ON/OFF switch on the bottom of the       vehicle to OFF.2. Insert battery pack into the battery     compartment as shown.  (See diagram 2)3. Push battery pack forward in direction of arrow   engraved on battery pack.4. Use a coin to turn the battery compartment   latch counterclockwise until it stops to lock the   battery pack in position.When the vehicle slows down, recharge the battery pack. When the battery pack will no longer hold a charge, replace it.Note: To remove, use a coin to turn the battery compartment latch clockwise until it stops, slide the battery pack up and remove it from the battery compartment. © Disney / PixarFAST LANE is a mark of Geoffrey, Inc.© Geoffrey, Inc.Distributed by Toys“R”Us, Inc., Wayne, NJ 07470Made in Chinawww.toysrus.comDRIVING THE CAR:Warning: Never play with your vehicle in the street.1. Slide ON/OFF switch on the side of the vehicle    to ON. (See diagram 5)2. Use the transmitter’s control levers as follows:   (See diagram 6)  Left Control Lever:•  Push forward to move forward (F).•  Pull back to move backward (B).•  Release to stop.Right Control Lever:•  Push left to move left (L).•  Push right to move right (R).•  Release to go straight.TURBO:•  Press "Turbo" button for maximum power.Caution: If the vehicle gets stuck under an    object, immediately release the control levers on the transmitter, then retrieve the vehice.3. When you finish driving, slide the ON/OFF   switch on the vehicle to OFF.HOW TO OPERATE:1. If the vehicle does not go in a straight line when   you release the right control lever, adjust the   wheel alignment control on the bottom of the   vehicle. Turn the wheel alignment control    toward L if the vehicle is pulling to the right,   or toward R if the vehicle is pulling to the left.   (See diagram 7) HELPFUL HINTS:The following hints can help you get the most enjoyment from your vehicle:•  Running your vehicle continuously for long   periods generates high heat levels. Heat     causes wear and tear on the motor. When   your vehicle’s battery dies, let the vehicle cool   at least 10 minutes before installing a newly   charged battery pack. This helps keep heat   levels down.•  If the vehicle’s motor runs but does not     respond to the transmitter, move closer to the   vehicle and try again.•  If someone uses a CB nearby, it might     interfere with control of the vehicle. If this       happens, move the vehicle and transmitter   away from the CB.•  You cannot operate your vehicle near devices   with transmitters that use the same frequency,  (27 MHz or 49 MHz). Check the packaging   to see which frequency your vehicle uses.•  If the vehicle moves slowly, and you have    installed a recharged battery pack, check the   wheel mechanisms for lint, thread, hair or dust.CARE:The following suggestions will help you care for your vehicle so you can enjoy it for years:•  Never drive the vehicle on a wet floor, on     sand, or in mud, rain, or snow. These can    damage it.•  Do not expose the vehicle to extreme     temperatures.•  To protect the vehicle’s wheel mechanisms  from lint and hair, do not drive it on carpet.•  Occasionally wipe the vehicle with a damp   cloth to keep it looking new. Do not use harsh   chemicals to clean the vehicle.Modifying or tampering with the vehicle or the transmitter’s internal components can cause a malfunction and void your FCC authorization to operate them.THE FCC WANTS YOU TO KNOW:Your vehicle or transmitter might cause TV or radio interference even when it is operating properly. To determine whether your vehicle or transmitter is causing the interference, turn off your vehicle and release the transmitter’s control levers. If the interference goes away, your vehicle or transmitter is the cause.Try to eliminate the interference by:•  Moving your vehicle and transmitter away from  the TV or radio.If you cannot eliminate the interference, the FCC requires that you stop using your vehicle.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.BATTERY INSTALLATION:TRANSMITTER:The transmitter requires one 9-volt battery (not included). For the best performance and longest life, we recommend an alkaline battery.Follow these steps to install the battery in  the transmitter:1. Remove battery compartment cover by sliding  it in the direction of the arrow shown on the  compartment cover. 2. Place battery in the compartment according to  the polarity symbols (+ and -) marked inside. (See diagram 1)3. Replace the cover and snap it shut.When the transmitter’s range decreases, replace battery.CAR:Your vehicle requires a 6-volt rechargeable battery pack (not included) or 4 x AA batteries (not included). 6USING 4 X AA BATTERIES:1. You can use 4 x AA batteries (Alkaline,     Rechargeable NiMH, or Rechargeable NiCd)   to power your vehicle by using the AA Battery   Adaptor provided.2. Insert 4 x AA batteries in the AA Battery          Adaptor according to the polarity symbols  (+ and -) marked inside. (See diagram 3)3. Insert AA Battery Adaptor, as battery pack   with AA batteries facing down into the battery   compartment as shown. Follow steps 2, 3 and 4 of USING 6V     BATTERY PACK.ATTENTION PARENTS:IT IS RECOMMENDED THAT THIS TOY AND ALL ACCESSORIES BE PERIODICALLY EXAMINED FOR POTENTIAL HAZARDS AND THAT ANY POTENTIALLY HAZARDOUS PARTS BE REPAIRED OR REPLACED.OPERATING INSTRUCTIONSBATTERY PACK CARE / CAUTIONS:•  Use only a fresh battery and/or battery pack of  the required size and type.•  If you do not plan to use the vehicle for several  days, remove the battery from the transmitter   and the battery pack from the vehicle.•  Do not mix old and new batteries. Do not mix  alkaline, standard (carbon zinc), or  rechargeable (nickel-cadmium) or   Ni-MH batteries.•  Never leave dead or weak batteries in the     vehicle.•  Dispose of old batteries promptly and properly;  do not bury or burn them.•  Do not charge non-rechargeable batteries.•  Insert batteries with the correct polarity.•  Do not short the supply terminals.•  Remove rechargeable batteries from the         vehicle before being charged.•  Keep the package and owner’s manual since  it contains important information.AA Battery AdaptorBattery compartment latchRADIO CONTROLINCREDOBILELH

Navigation menu