Taiyo A14227 27MHz Remote Control Transmitter User Manual CR inst 1 4
Taiyo Co., Ltd. 27MHz Remote Control Transmitter CR inst 1 4
Taiyo >
users manual
R/C Facts for Improved Operation 1. When batteries start to discharge, vehicle may slow, stop, or refuse to respond to your control. It's time to replace both vehicle batteries and/or remote battery. This is absolutely the #1 cause of all problems and questions! Observe polarity when replacing batteries. 2. Radio frequency interference can interfere with the control of your vehicle. Buildings, power wires, other R/C remotes, or CB radio can all cause problems. Pick a place to drive that's away from these things. 3. Hold remote so antenna points up, not toward the vehicle. Keep vehicle within range (about 30 to 40 feet) to keep control. If vehicle goes out of range, try lifting remote high into air to increase range. 4. Wipe vehicle clean and dry after each use, including inside battery compartments. 5. Turn vehicle power switch off immediately after running. Remove batteries for storing or shipping. Keep vehicle and Remote away from heat and direct sunlight and moisture. 6. Do not run vehicle in or near water. Troubleshooting Guide Don't take your vehicle back to the store--try solving problems using this valuable guide. Problem Probable Cause Correction Vehicle runs slowly, or won't move, or won't steer • Batteries dead or low charge • Batteries installed incorrectly in remote or vehicle • Loose battery connection • Dirty battery or battery compartment contacts • Power switch is off • Install 2 fresh new "AA" alkaline cells • Remove and replace batteries, making sure battery direction (polarity, +/-) is correct and battery compartment contacts, plug and socket are clean. • Replace remote battery. • Turn on Power switch. Erratic operation, loss of control, short range • Radio interference • Loose or curled remote antenna • Antenna touching hands or body • Weak remote battery • Weak vehicle batteries • Move to another location. • Extend antenna fully. Point up in the air, not at vehicle. • Don't touch antenna during operation. • Replace both vehicle batteries and / or remote battery Vehicle stops working after going through water, mud or snow • Water in battery, electronics or motor areas • Any time vehicle is run through water, turn power knob off IMMEDIATELY, remove batteries, dry inside and out with clean soft cloth and allow to dry overnight with battery door open. Always avoid wet surfaces, puddles or rain. COMPLIANCE WITH FCC REGULATIONS THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION OF THIS DEVICE IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE. (2) THIS DEVICE MUST ACCEPT ANY HARMFUL INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. This device generates and uses radio frequency energy and if not used properly may cause interference to radio and television reception. It has been tested and found to comply with the limits set by the FCC, which are designed to provide reasonable protection against such interference. CAUTION: FCC Regulations state that changes or modifications to this product not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. PRINTED IN CHINA © 2001 Taiyo Edge Ltd. Co., P.O. Box 1470, New Smyrna Beach, FL 32170, U.S.A. All Rights Reserved. U.S. and Foreign Patents Pending.Taiyo Edge; Get the Edge!; On Road, Off-Road, No Road!; and Cell Racer are licensed trademarks of Tilbor Marketing and Development Inc. Product specifications subject to change. Product may differ from illustrations. ™ TM Taiyo Edge™ R/C Consumer Service We want to assist you! DO NOT RETURN THE PRODUCT TO THE STORE! Log on: Click “Help/Service” at www.taiyoedge.com E-mail: help@taiyoedge.com 90-DAY LIMITED WARRANTY (a copy of this warranty is inside) TOLL-FREE CONSUMER HELPLINE NUMBER 1-866-4-EDGE-RC (1-866-433-4372) SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. THEY CONTAIN IMPORTANT INFORMATION. Important! Please read your Owner's Manual all the way through before operating your vehicle. Safety First • Drive your vehicle in a safe area away from people, pets, cars, etc. Not in streets, in or near water, or in darkness! • Don't touch or try to pick up vehicle when it is in motion. Wait until it stops completely. • Keep hair, fingers, face and loose clothing away from wheels while the vehicle is switched on or while the remote is operating. • Be a responsible Cell Racer™ R/C operator! Batteries Required (not included) 2 "AA" Alkaline batteries required for vehicle. One 9-Volt Alkaline battery required for the remote. READ AND FOLLOW ALL INSTRUCTIONS IMPORTANT BATTERY SAFETY INFORMATION CAUTION: TO AVOID BATTERY LEAKAGE • Make sure the batteries are inserted with the correct polarity and follow the toy and battery manufacturers' instructions. • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium or nickel-metal hydride) batteries. • Remove weak or exhausted batteries from the product. ADDITIONAL IMPORTANT BATTERY SAFETY INFORMATION • An adult should help with battery replacement • Only batteries of the same or equivalent type as recommended in the "Battery Installation" (or replacement) instructions are to be used. • Non-rechargeable batteries are not to be recharged. • If removable rechargeable batteries are used, they are only to be charged under adult supervision. • Rechargeable batteries are to be removed from the product before they are charged. • If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and other parts. Do not use a damaged battery charger until it has been properly repaired. • Dispose of batteries safely and properly. Vehicle Battery Installation 1. Slide vehicle BATTERY DOOR open and remove as shown. (Fig. 1) 2. Insert 2 fresh, new Alkaline batteries into battery compartment as shown. IMPORTANT: OBSERVE BATTERY POLARITY (DIRECTION, + AND -). (Fig. 2) 3. Replace BATTERY DOOR and slide closed until it latches. (Fig. 3) Remote Battery Installation 1. Slide open BATTERY DOOR on REMOTE and remove. (Fig. 4) 2. Insert a fresh, new 9-VOLT ALKALINE BATTERY with the polarity (+/-) as shown on the bottom of battery compartment. (Fig. 5) 3. Replace BATTERY DOOR and slide it closed to secure. (Fig. 6) Fig 4 Fig 1 Fig 5 Fig 2 Fig 3 Fig 6 ANTENNA Extend antenna fully for operation. Hold Remote so antenna points straight up in the air. Don't touch during operation. Forward Right Forward Left Forward Left Right Fig 7 Remote Operation Press and hold a "dialing" button to move the vehicle in the direction shown by the arrow on the button. Release button for "neutral." POWER SWITCH Note: There is no on/off switch on Remote. Pressing the buttons turns it on. Releasing the buttons turns it off. Right Reverse Left Reverse Reverse R/C Tip In order to race or operate two vehicles together, they must be different frequencies. Check the package and the bottom of your vehicle for the frequency label. Vehicle Operation 1. Turn on POWER SWITCH on bottom of vehicle. (Fig. 7) 2. Vehicle operates best on flat, smooth, surfaces. KEEP AWAY FROM WATER, SNOW AND WET SURFACES. 3. If vehicle steers slightly to one side or the other when you press a button to go straight, move the TRIM TAB on the bottom in the opposite direction, a little at a time. (Drive vehicle away from you to test.) Repeat if necessary. (Fig. 8). TRIM TAB Fig 8
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Create Date : 2001:11:06 17:40:08-08:00 Creator : Adobe Illustrator 9.0.2 Producer : Adobe PDF library 4.800 Title : CR inst 1-4.pdf Modify Date : 2001:11:30 13:41:31-05:00 Creator Version : 9 Container Version : 9 For : virginia Tsai, Bounding Box : 15 -718 784 -9 Page Count : 2EXIF Metadata provided by EXIF.tools