Targus 000014 Bluetooth Comfort Laser Mouse User Manual CAB9D3C3CAD6B2E12E706466

Download:
Mirror Download [FCC.gov]
Document ID	1150412
Application ID	VEdAntCVpuCpwTNdUd7Gjg==
Document Description	Users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	16.86kB (210772 bits)
Date Submitted	2009-08-07 00:00:00
Date Available	2009-08-07 00:00:00
Creation Date	2009-07-31 00:02:53
Producing Software	Acrobat Distiller 7.0.5 (Windows)
Document Lastmod	2009-07-31 00:04:14
Document Title
Document Creator	PScript5.dll Version 5.2
Document Author:	cathy

User Guide
Targus Wireless Comfort Laser Mouse
Introduction
Thank you for your purchase of the Targus Wireless Comfort Laser Mouse.
The accompanying micro USB receiver is small enough to leave plugged
into your computer or simply store it inside the mouse when travelling.
This is a plug-n-play device so no additional software is required. The
advance scroll wheel feature program can be downloaded from the Targus
web-site.
Contents
s 4ARGUS 7IRELESS #OMFORT ,ASER -OUSE
s  X !! BATTERIES
s -ICRO 53" RECEIVER
s 5SER GUIDE
System Requirements
Hardware
s 53" PORT
Operating System
s -ICROSOFT 7INDOWSÂŽ 2000
s -ICROSOFT 7INDOWSÂŽ XP
s -ICROSOFT 7INDOWS 6ISTAÂŽ
s -ICROSOFT 7INDOWSÂŽ 7
s -AC /3ÂŽ X 10.4 or later
Targus Wireless Comfort Laser Mouse
Installing the Batteries
1. Remove the battery cover from the top of the mouse by using the notch
on the back. Carefully lift the cover up as shown in the diagram.
2. Remove the battery safety clip by squeezing the center of the clip and
sliding it back, towards the rear of the mouse. Lift up and rotate the
clip out of the way.
NOTE: THE BATTERY SAFETY CLIP WILL NEED TO BE IN THE SECURE, LOCKED POSITION BEFORE THE BATTERY COVER CAN BE PUT BACK IN PLACE.
Targus Wireless Comfort Laser Mouse
3. Remove the micro USB receiver stored inside the center compartment .
Micro USB
receiver
4. Insert the two AA batteries, making sure that the positive (+) and
negative (-) ends of each battery match the polarity indicators inside
the battery compartment.
Targus Wireless Comfort Laser Mouse
5. Replace the battery safety clip by sliding it forward until it clicks into
place and then replace the battery cover.
Targus Wireless Comfort Laser Mouse
Establishing the Connection
(A) Plug the USB receiver into an available USB port on your computer.
(B) Turn on the mouse pressing the power button, located on the bottom
of the mouse, for 3 seconds and then release.
Power Button
This mouse is a plug-n-play device. It will automatically operate when the
USB receiver is connected to the computer.
Targus Wireless Comfort Laser Mouse
Power On:
Press and hold the power button for 3 seconds and then release.
The battery life indicator will briefly light up showing the current power
level of the batteries.
Power Off:
Press and hold the power button for 3 seconds and then release.
The battery life indicator will briefly light up and then fade out.
Battery Check:
After the mouse is turned on, quickly press and release the power button.
The battery life indicator will light up showing the current power level of
the batteries.
Power Saving mode:
!FTER AN EXTENDED PERIOD OF TIME IF THE MOUSE IS NOT USED IT WILL AUTOMATIcally enter power saving mode to conserve power and increase battery
life. Click on any mouse button to resume the normal operation. The
mouse may take a few seconds to re-connect with your computer.
Targus Wireless Comfort Laser Mouse
Battery Life Indicator
3 LEDs lit
Full power
2 LEDs lit
Half power
1 LED lit
Low power
NOTE: WHEN THE FIRST LIGHT IS BLINKING, PLEASE REPLACE THE BATTERIES
Power Management
s 4O EXTEND THE LIFE OF YOUR BATTERY TURN OFF THE MOUSE WHILE TRAVELLING OR
when you’re not using it.
Targus Wireless Comfort Laser Mouse
Programming Your Mouse
7INDOWS /NLY
To access the advanced scroll wheel features you will need to download
and install the software driver. This can be downloaded from the following
location:
6ISIT www.targus.com to download and install the driver.
/NCE INSTALLATION IS COMPLETE OPEN THE DRIVER SOFTWARE AND SELECT THE
desired setting for the scroll-wheel button. Close the driver software
application and you’re ready to go. Activate your selected feature by
pressing down on the scroll wheel.
Targus Wireless Comfort Laser Mouse
Technical Support
For technical questions, please visit:
US
Australia
New Zealand
Internet: www.targus.com/support.asp
Internet: www.targus.com/au
Email: infoaust@targus.com
Telephone: 1800-641-645
Telephone: 0800-633-222
Product Registration
Targus recommends that you register your Targus accessory shortly after purchasing
it. Go to:
http://www.targus.com/registration.asp
You will need to provide your full name, email address, country of residence and
product information.
Warranty
Targus warrants this product to be free from defects in materials and workmanship
for one year. If your Targus accessory is found to be defective within that time, we will
promptly repair or replace it. This warranty does not cover accidental damage, wear
and tear, or consequential or incidental loss. Under no conditions is Targus liable for
loss of, or damage to devices; nor loss of, or damage to, programs, records, or data;
nor any consequential or incidental damages, even if Targus has been informed of
their possibility. This warranty does not affect your statutory rights.
Regulatory Compliance
4HIS DEVICE COMPLIES WITH 0ART  OF THE &## 2ULES /PERATION IS SUBJECT TO THE
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
10
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. (Example- use
only shielded interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and it also complies with Part 15 of FCC RF Rules. Operation is subject to the
following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.
Canada Statement
This Device complies with RSS-210 of the IC Rules, Operation is subject to the following two
conditions:
(1). This device may not cause interference and
(2). This device must accept any interference received,, including interference that may cause
undesired operation.
Declaration of Conformity
Hereby, Targus, declares that this device is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
Targus Wireless Comfort Laser Mouse
CAUTION
,!3%2 2!$)!4)/. $/ ./4 34!2% ).4/ 4(% "%!- /2 6)%7 $)2%#4,9 7)4(
/04)#!, ).3425-%.43 #,!33 ) ,!3%2 02/$5#4
.%6%2 0/).4 ! ,!3%2 "%!- ).4/ ! 0%23/.3 %9%3 /2 6)%7 ! ,!3%2 "%!$)2%#4,9 !3 02/,/.'%$ %80/352% #!. "% (!:!2$/53 4/ 4(% %9%3
-/-%.4!29 %80/352% &2/- ! ,!3%2 0/).4%2 35#( !3 !. ).!$6%24%.4
37%%0 /& 4(% ,)'(4 !#2/33 ! 0%23/.3 %9%3 -!9 #!53% 4%-0/2!29
&,!3( ",).$.%33 3)-),!2 4/ 4(% %&&%#4 /& ! #!-%2! &,!3( "5,"
!,4(/5'( 4()3 #/.$)4)/. )3 4%-0/2!29 )4 #!. "%#/-% -/2%
$!.'%2/53 )& 4(% %80/3%$ 0%23/. )3 %.'!'%$ ). ! 6)3)/. #2)4)#!,
!#4)6)49 35#( !3 $2)6).'
12
410-1689-001A / AMW51US
1 YEAR LIMITED WARRANTY: We pride ourselves
on the quality of our products. For complete warranty
details and a list of our worldwide ofces, please visit
www.targus.com. Features and specications are subject to change without notice. All trademarks and registered trademarks are the property of their respective
owners. All rights reserved. Š2009 Manufactured or
imported by Targus Group International, Inc. (for U.S.
sales: 1211 North Miller Street, Anaheim, CA 92806
USA) whose Australian sales representative is Targus
Australia Pty. Ltd., 117-119 Bowden Street, Meadowbank, NSW 2114 Australia
N2953

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1-702
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Create Date                     : 2009:07:31 00:02:53+08:00
Modify Date                     : 2009:07:31 00:04:14+08:00
Metadata Date                   : 2009:07:31 00:04:14+08:00
Creator Tool                    : PScript5.dll Version 5.2
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 4845 bytes, use -b option to extract)
Document ID                     : uuid:7924E869227DDE11A42DEFD9F36F37B2
Instance ID                     : uuid:6e0b3fd8-a853-49ff-b96c-9c16d0574bf0
Derived From Instance ID        : uuid:b720a232-7a45-46de-afdf-fd5c67f08614
Derived From Document ID        : xmp.did:DEEE966CC754DE11B02DE01CFA698BC2
Derived From Rendition Class    : proof:pdf
Doc Change Count                : 884
Format                          : application/pdf
Title                           : 
Creator                         : cathy
Has XFA                         : No
Page Count                      : 13
Author                          : cathy

EXIF Metadata provided by EXIF.tools