Tascam Db25_pinout DB 25 Pinout

DB-25_Pinout Product: DS-M7.1 | TASCAM

DB-25_Pinout Product: MX-2424 | TASCAM

DB-25_Pinout Product: IF-SM/DM | TASCAM

DB-25_Pinout Product: DA-78HR | TASCAM

DB-25_Pinout Product: IF-AN/DM | TASCAM

User Manual: Tascam Product: DM-3200 | TASCAM

Open the PDF directly: View PDF .
Page Count: 1

02/13/07

Page 1 of 1

TASCAM’s DB-25

Pinout Standard

TASCAM developed the standard for multi-pin

DB-25 cables over 10 years ago, and most

of the pro audio industry has followed this

standard. This is the pinout found on TASCAM

mixers, recorders and their accessories, such

as the X-48, DM-3200 and DM-4800.

Analog DB-25 Connectors

AES/EBU DB-25 Connectors

Be sure to check that the cables you’re using

are rated for analog audio use. Many cables

look the same on the outside.

You may notice that the AES/EBU pinout

scheme follows the analog one closely. The

original AES/EBU pinout was indeed based

on the analog pinout, but using the fi rst four

balanced lines for AES/EBU in, and the last

four balanced lines for AES/EBU out.

While analog breakout cables will often work

for AES/EBU connection, note that AES/EBU

DB25 to DB25 connections require a different

pinout in the cable. Analog cables wire pin

1 to pin 1. AES/EBU must fl ip the connec-

tions so that pins 12, 24 and 25 will wind

up on the other end of the cable at pins 6,

18 and 19 respectively. (Digital out must

feed digital in.)