Technicolor Connected Home USA TC8706-C Cable Modem User Manual

Technicolor Connected Home USA LLC Cable Modem

Contents

User Manual (Statements).pdf

SAFETY INSTRUCTIONS AND REGULATORY NOTICESBEFORE YOU START INSTALLATION OR USE OF THIS PRODUCT, CAREFULLY READ THESE INSTRUCTIONSDirectiveUnless express and prior approval by Technicolor in writing, you may not:Disassemble, de-compile, reverse engineer, trace or otherwise analyse the equipment, its content, operation, or functionality,or otherwise attempt to derive source code (or the underlying ideas, algorithms, structure or organization) from the equipment,or from any other information provided by Technicolor, except to the extent that this restriction is expressly prohibited by local law;Copy, rent, loan, re-sell, sub-license, or otherwise transfer or distribute the equipment to others;Modify, adapt or create a derivative work of the equipment;Remove from any copies of the equipment any product identification, copyright or other notices;Disseminate performance information or analysis (including, without limitation, benchmarks) from any source relating to the equipment.Such acts not expressly approved by Technicolor will result in the loss of product warranty and may invalidate the user's authority to operate this equipment in accordance with FCC Rules.Technicolor disclaims all responsibility in the event of use that does not comply with the present instructions.Environmental informationThe batteries use some hazardous substances which pollute the environment. Do not dispose of them with other articles. Take care to dispose them at special collecting points.Safety instructionsClimatic conditionsThis product:Is intended for in-house stationary desktop use; the maximum ambient temperature may not exceed 40°C (104°F).Must not be mounted in a location exposed to direct or excessive solar and/or heat radiation.!When using this product, always follow the basic safety precautions to reduce the risk of fire, electric shock and injury to persons, including the following:Always install the product as described in the documentation that is included with your product.Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.Do not use this product to report a gas leak in the vicinity of the leak.
Must not be exposed to heat trap conditions and must not be subjected to water or condensation. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.Must be installed in a Pollution Degree 2 environment (Environment where there is no pollution or only dry, nonconductive pollution).CleaningUnplug this product from the wall socket and computer before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.Water and moistureDo not use this product near water, for example near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool. Transition of the product from a cold environment to a hot one may cause condensation on some of its internal parts. Allow it to dry by itself before re-starting the product.Interface classificationsThe external interfaces of the product are classified as follows:Phone: TNV circuit, not subjected to over voltages (TNV-2)Cable, MoCA, RF: TNV circuit subject to overvoltages (TNV-1)All other interface ports (e.g. Ethernet, USB, etc.), including the low voltage power input from the AC mains power supply: SELV circuits.Electrical poweringThe powering of the product must adhere to the power specifications indicated on the marking labels.USBThe device is to be connected to an identified USB port complying with the requirements of a Limited Power Source.AccessibilityThe plug on the power supply cord serves as disconnect device. Be sure that the power socket outlet you plug the power cord into is easily accessible and located as close to the equipment as possible.OverloadingDo not overload mains supply socket outlets and extension cords as this increases the risk of fire or electric shock.ServicingTo reduce the risk of electric shock, do not disassemble this product. None of its internal parts are user-replaceable; therefore, there is no reason to access the interior. Opening or removing covers may expose you to dangerous voltages. Incorrect reassembly could cause electric shock if the appliance is subsequently used.If service or repair work is required, take it to a qualified service dealer.Damage requiring serviceUnplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:When the power supply or its plug are damaged.
When the attached cords are damaged or frayed.If liquid has been spilled into the product.If the product has been exposed to rain or water.If the product does not operate normally.If the product has been dropped or damaged in any way.There are noticeable signs of overheating.If the product exhibits a distinct change in performance.Immediately disconnect the product if you notice it giving off a smell of burning or smoke. Under no circumstances must you open the equipment yourself; you run the risk of electrocution.Regulatory informationYou must install and use this device in strict accordance with the manufacturer's instructions as described in the user documentation that is included with your product.Before you start installation or use of this product, carefully read the contents of this document for device specific constraints or rules that may apply in the country where you want to use this product.In some situations or environments, the use of wireless devices may be restricted by the proprietor of the building or responsible representatives of the organization.If you are uncertain of the policy that applies on the use of wireless equipment in a specific organization or environment (e.g. airports), you are encouraged to ask for authorization to use this device prior to turning on the equipment.Technicolor is not responsible for any radio or television interference caused by unauthorized modification of the device, or the substitution or attachment of connecting cables and equipment other than specified by Technicolor. The correction of interference caused by such unauthorized modification, substitution or attachment will be the responsibility of the user.Technicolor and its authorized resellers or distributors are not liable for any damage or violation of government regulations that may arise from failing to comply with these guidelines.North-America - United States of AmericaImportant safety instructionsThe cable distribution system should be grounded (earthed) in accordance with ANSI/NFPA 70, the National Electrical Code (NEC), in particular Section 820,93, Grounding of outer Conductive Shield of a Coaxial Cable.Leave 5 to 8 cm (2 to 3 inches) around the product to ensure proper ventilation to it.Never push objects through the openings in this product.Federal Communications Commission (FCC) radio frequency interference statementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
TECHNICOLOR WORLDWIDE HEADQUARTERS1, rue Jeanne d’Arc92443 Issy-les-MoulineauxFrancewww.technicolor.com*DSL37228970*DSL37228970Copyright 2013 Technicolor. All rights reserved. All tradenames referenced are service marks, trademarks, or registered trademarks of their respective companies. Specifications subject to change without notice.DMS-SAF-20130624-0000 v1.0. Printed in China.radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.RF-exposure statementWhen the product is equipped with a wireless interface, then it becomes a mobile or fixed mounted modular transmitter and must have a separation distance of at least 20 cm (8 inches) between the antenna and the body of the user or nearby persons. In practice, this means that the user or nearby persons must have a distance of at least 20 cm (8 inches) from the modem and must not lean on the modem in case it is wall-mounted.With a separation distance of 20 cm (8 inches) or more, the M(aximum) P(ermissible) E(xposure) limits are well above the potential this module is capable to produce.For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment. This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Restricted frequency bandThis product is equipped with an IEEE802.11b/IEEE802.11g/IEEE802.11n wireless transceiver and may only use channels 1 to 11 (2412 to 2462 MHz) on U.S.A. territory.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:1This device may not cause harmful interference, and2This device must accept any interference received, including interference that may cause undesired operation.

Navigation menu