Telecell Mobile J8 Smart phone User Manual UW4003K V2
Telecell Mobile (H.K) Ltd. Smart phone UW4003K V2
manual
J8 QUICK START GUIDE Package content Device layout ● Device ● Data cable ● Screen protector To turn on the device, press and hold the Power key for few seconds. ● USB power adaptor ● Quick start guide Charging the battery Gently remove the battery door from the phone, slide and lift the SIM tray door and place the SIM card as shown in the picture below: Front Camera Their items supplied with the device and their images May vary by region Installing a nano-SIM and a microSD card Accessing more information The charger should remain close to the electric socket and easily accessible while charging. Using the Home button Rear Camara ● The user manual may not be available depending on the web browser or service provider. ● You may incur additional charges for accessing the internet. Flash ● When you turn on the device, the Home button will appear at the bottom of the screen as a soft button. ● When the screen is off, hard press the Home button until the device vibrates to turn on the screen. SIM 1 SIM 2 Read all safety information before using the device to ensure safe and proper use. Warning The actual available capacity of the internal memory is less than the specified capacity because the operating system and default apps occupy part of the memory. The available capacity may change when you upgrade the device. Micro SD card Micro-SIM card Micro-SIM card To view the full user manual on your device, launch the Settings app and tap User Manual. Safety Information Before using the device for the first time, you must charge the battery. Volumen Key Power Key ●To transfer data of the previous to a new device: Please login to your Gmail account and sync all your content. Follow the warning information provided below to prevent incidents such as fire or explosion. ● Do not expose the device to physic al impact or damage. ● Use manufacturer-approved batteries, chargers, accessories, and Supplies. ● Prevent the multipurpose jack and battery terminals from Contracting conductive elements, such as metal or liquids. ● Do not turn on or use the device when the battery compartment is exposed. Follow the warnings below to prevent injury to people or damage for the device. Some content may differ from your device depending on the region, service provider, or software version, and is subject to change without prior notice. ● If the card is not firmly to the tray, the card may leave or fall out of the tray. To view the full safety information including device and battery disposal instructions, launch the Settings app and tap About phone Legal information Safety information. You can download and install the firmware update to upgrade your device’s software with the firmware over the-air (FOTA) service. To check for the firmware update, launch the OTA Update Service app and tap Available Update.. ● Do not allow children or animals to chew or suck the device. ● If the device has a camera flash or light, do not use it close to the eyes of people or animals. ● The device can be used in locations with an ambient temperature of 0 °C to 35 °C. You can store the device or reduce the battery’s lifespan. ● Do not use your device in a hot environment or near fire. ● Comply with all safety warnings and regulations regarding mobile device usage while operating a vehicle. ● To protect your eyes, do not stare at the iris recognition LED light when your eyes are less than 20 cm away from the device. Google, Android, Gmail, and other marks are trademarks of Google LLC. Oreo is a trademark of Mondelez International, Inc. group. Speaker Nano-SIM card, Micro-SIM card and MicroSD card are sold separately. To prevent possible hearing damage when using a headset, do not listen to sound high volume for long periods. Home Button FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. SAR Information Statement Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 0.536W/Kg and when worn on the body, as described in this user guide, is0.436W/Kg(Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements). The maximum scaled SAR in hotspot mode is 0.637W/Kg. While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on FCC ID: 2ADX3J8 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a sub-stantial margin of safety to give additional protection for the public and to account for any variations in measurements. Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Create Date : 2018:08:23 08:48:20+08:00 Creator : Adobe Acrobat Pro 9.0.0 Modify Date : 2018:08:23 08:48:20+08:00 XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Metadata Date : 2018:08:23 08:48:20+08:00 Creator Tool : Adobe Acrobat Pro 9.0.0 Format : application/pdf Title : UW4003K-说明书-V2 Document ID : uuid:d1062250-8b67-41b7-b6f8-96d58a79978c Instance ID : uuid:712f515e-cefa-44f4-a7fe-54bd35fe53bc Producer : Adobe Acrobat Pro 9.0.0 Page Count : 3 For : Administrator, Bounding Box : 1 -15 2310 880 Container Version : 11 Creator Version : 16EXIF Metadata provided by EXIF.tools