Telefield WP-1 Emergency Alarm Pendant User Manual List

Telefield Ltd. Emergency Alarm Pendant List

User Manual

Operation:InstallationThe Pendant operates on three 1.5V batteries. The lift of those batteries for standby isapproximately 3 years. There are two screws on the back of the transmitter that hold the top andbottom case together.Recommendation: Test your transmitter periodically to ensure that all the batteries are working. Ifthe communication distance or the brightness of alarm LED reduced, please replace all batterieswith new one.To replace the Pendant batteries:1. Undo the two screws on the back of the transmitter. The bottom case will then come off.2. Take out all the old batteries using a small screwdriver or a pen3. Place the new batteries in position.4. Reprogram the device if necessary.5. Close the battery cover and reinsert two screws.ProgrammingPendant allows you to activate WR-1 or WR-2 receivers after programming shown below.1. Press and hold the “SETUP” button of the Receiver unit until the “SETUP” LED lights up.2. Press the “ALARM” button of Pendant once, the alarm LED will light up (or flash slowly for firstsetup).3. Plug the program cable to Base unit and Pendant, LED will quickly flash to indicate connectionsuccessfully.4. Select one of 16 locations in sequence by pressing “SETUP” button (for WR-1, WR-2).5. Press and hold “SETUP CONFIRM” button to assure. The “SETUP” LED on Base unit will turnoff and “ALARM” LED on transmitter will turn off once if installation successfully.6. Disconnect the program cable; alarm LED of Pendant turn off.7. Press the “ALARM” button of Pendant once, the corresponded unit LED on Base unit will lightup and alarm will hear.8. Repeat step 2~7 for other Transmitters.OperationIn an emergency, you can activate the WR-1 or WR-2 receivers using the Pendant. Press the“ALARM” button once will transmit alarm to receiver for around 2.5 minutes to activate the receivers.To release the alarm on receiver, press the “ALARM RESET” button on the receiver to turn off thealarm sound and corresponded unit LED.FCC WarningChanges or modifications to this unit not expressly approved by the party responsible forcompliance could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communication.However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception which can be determinedby turning the equipment off and on, the user in encouraged to try to correct the interference by oneor more of the following measures.¨ Reorient or relocate the receiving antenna.¨ Increase the separation between the equipment and receiver.¨ Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.¨ Consult the dealer or an experienced radio/TV technician for help.

Navigation menu