Tera Tron LFHANDLE MLx Handle 125kHz User Manual Testreport ETS 300 335
Tera Tron GmbH MLx Handle 125kHz Testreport ETS 300 335
Users Manual
Test report no. 16010602 EUT: MLx Handle 125 kHz Page 1 of 2 FCC ID: QLXLFHANDLE FCC Title 47 CFR Part 15 Date of issue: 2016-11-10 Annex acc. to FCC Title 47 CFR Part 15 relating to TeraTron GmbH MLx Handle 125 kHz Annex no. 5 User Manual Functional Description Title 47 - Telecommunication Part 15 - Radio Frequency Devices Subpart C – Intentional Radiators ANSI C63.4-2014 ANSI C63.10-2013 Date: 2016-08-19 m. dudde hochfrequenz-technik Created: P9 Rottland 5a Controlled: P4 D-51429 Bergisch Gladbach/ Germany Released: P1 Tel: +49 2207-96890 Vers. no. 2.16 Fax +49 2207-968920 Test report no. 16010602 EUT: MLx Handle 125 kHz Page 2 of 2 FCC ID: QLXLFHANDLE FCC Title 47 CFR Part 15 Date of issue: 2016-11-10 User Manual / Functional Description of the test equipment (EUT) Date: 2016-08-19 m. dudde hochfrequenz-technik Created: P9 Rottland 5a Controlled: P4 D-51429 Bergisch Gladbach/ Germany Released: P1 Tel: +49 2207-96890 Vers. no. 2.16 Fax +49 2207-968920 MLx Handle 125kHz User Manual MLx Handle 13,56MHz User Manual Document no. Project Document for MLx LF Handle 125kHz / MLx HF Handle 13,56MHz User Manual MLx Handle 125kHz / MLx Handle 13,56MHz FCC and IC Creation date: 11.11.2016 Functional Description of the MLx 125kHz Handle and MLx 13,56MHz Handle The MLx 125kHz (LF) and MLx (HF) 13,56MHz Handles offer a general RFID reader functionality, powered by an external 5V DC voltage source. The MLX Handles are used in combination with the MLx Readers (e.g. MLx2000, MLx3000 and MLx5000), that control the Handles RFID transponder reading functionality via a 2-wire data bus. The Handles RFID functionality includes reading of several types of 125kHz (e.g. HITAG) or 13,56MHz ISO transponder (e.g. ISO15693, ISO14443) types. The µP of the MLx Handles is clocked by a 16MHz-Resonator. The active components are powered by 5V from an external linear LDO regulator (located on the MLx Readers). The 125kHz-Reader IC (P4097) drives the 125kHz coil antenna. The 13,56MHz Reader IC (CLRC663) drives a 13,56MHz coil antenna respectively. When reading a valid transponder, the data is sent via the data bus. The external MLx Reader identifies and returns a signal on the data bus to unlock the actuator of the handle. If a handle has an actuator, the MLx handle then controls the actuator and unlocks. This actuator is usually a 12V permanent magnet motor, which unlocks the handle, so the user can get access to a door, or compartment, e.g. In case the Handle has a Keypad, the user can enter a digit code to get access on a 12digit keyboard located in the handle front side. However the keypad functionality is optional, it does not affect the RFID functionality. The status of the Handle is shown to the user by RGB LEDs. All LF and HF handles share the same RFID reader functionality. Revision Generate 1.0 MSC Approved RHE Confidentiality Strictly confidential Page Document 1 of 3 MLx LF/HF Handle User Manual MLx Handle 125kHz User Manual MLx Handle 13,56MHz User Manual Document no. Project Document for MLx LF Handle 125kHz / MLx HF Handle 13,56MHz User Manual MLx Handle 125kHz / MLx Handle 13,56MHz FCC and IC Creation date: 11.11.2016 Functional Block Diagram Key with implemented RFID technology MLx Handle MLx Reader MLx Handles: 125kHz (LF) or 13,56MHz (HF) Handles MLx Readers: MLx2000 or MLx3000 or MLx5000 Revision Generate 1.0 MSC Approved RHE Confidentiality Strictly confidential Page Document 2 of 3 MLx LF/HF Handle User Manual MLx Handle 125kHz User Manual MLx Handle 13,56MHz User Manual Document no. Project Document for MLx LF Handle 125kHz / MLx HF Handle 13,56MHz User Manual MLx Handle 125kHz / MLx Handle 13,56MHz FCC and IC Creation date: 11.11.2016 Compliance Statements Compliance Statements FCC The title “CAUTION TO USERS” or “FCC/IC WARNING NOTE” or relevant title and “Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.” This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Compliance Statements IC This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Revision Generate 1.0 MSC Approved RHE Confidentiality Strictly confidential Page Document 3 of 3 MLx LF/HF Handle User Manual
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Page Count : 1 XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:48256a5e-a6e6-11f2-0000-02c7314339d4 Producer : GPL Ghostscript 9.18 Modify Date : 2017:07:22 10:37:17Z Create Date : 2017:07:22 10:37:17Z Creator Tool : UnknownApplication Document ID : uuid:48256a5e-a6e6-11f2-0000-02c7314339d4 Format : application/pdf Title : UntitledEXIF Metadata provided by EXIF.tools