Teraoka Electronic WB-10 Wireless Ethernet Bridge User Manual 2ARYWWB 10 x
Shanghai Teraoka Electronic Co., Ltd Wireless Ethernet Bridge 2ARYWWB 10 x
2ARYWWB-10_User Manual
2018-11-09 WB-10 SpecificationsandOperationManual Model :WB-10 1stversion Edition Month Year 1st Feb. 2018 SHANGHAITERAOKAELECTRONICCO.,LTD TINGLININDUSTRYDEVELOPMENTALZONE JINSHANCOUNTRY,SHANGHAICHINA TEL:+86-021-57234888 FAX:+86-021-57234090 2018-11-09 WB-10 Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC RF Safety Caution statement: To satisfy FCC RF exposure requirements for mobile and base station transmission devices, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during operation. To ensure compliance, operation at closer than this transmitter must not recommended. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The device has been evaluated to meet general RF exposure requirement. 2018-11-09 WB-10 TableofContent 1. General Layout ..................................................................................................................... 1 2. Feature .................................................................................................................................... 2 3. Operation Condition ............................................................................................................ 2 4. External Connector.............................................................................................................. 3 4.1 PowerConnector ................................................................................................................ 3 4.2 EthernetConnetor .............................................................................................................. 3 5. Physical layoutofElectricalConnection .......................................................................... 3 2018-11-09 WB-10 1. GeneralLayout R&DDept. ©2018SHANGHAITERAOKAELECTRONICCO.,LTD. 1of 3 2018-11-09 WB-10 2. Feature NetworkParameters Networkstandard Wirelessstandard:IEEE802.11n,g,b LAN standard: IEEE802.3, IEEE802.3u Wirelesstransmission rate IEEE802.11n: IEEE802.11g: IEEE802.11b: 150MbpsMax; 54MbpsMax; 11MbpsMax Numberof channels 1~11 FrequencyRange 2.4000~2.4835G Transmitpower 15dBm Antenna Antennatype External antenna Function Parameters WIFImode Wirelessnetworkcard/ wirelessaccesspoint/ wireless router WDSFunction SupportWDSwirelessbridge Wirelesssecurity Wireless MAC addressfiltering Wirelesssafetyfunctionswitch 64/128/152bitWEPencryption WPA-PSK/WPA2-PSK,WPA/WPA2securitymechanism Networkmanagement Remotewebmanagement Profileimportand export WEBsoftwareupgrade 3. Operation Condition Operating temperature: -20º C to 70º C Operatinghumidity: Storagetemperature: Storagehumidity: Powersupply: Power Consumption: 10~90% RH (Non-condensing) -40ºC to80ºC 5~90%RH (Non-condensing) DC 5V 1A 2.5WMax R&DDept. ©2018SHANGHAITERAOKAELECTRONICCO.,LTD. 2of 3 2018-11-09 WB-10 4. ExternalConnector 4.1 PowerConnector 1 xDC JACK 4.2 Ethernet Connetor 1 xRJ45: Connectwith PCorDIGIscale. 5. Physical layoutofElectrical Connection R&DDept. ©2018SHANGHAITERAOKAELECTRONICCO.,LTD. 3of 3
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : 3.1-701 Producer : Acrobat Distiller 7.0 (Windows) Create Date : 2019:02:02 10:08:11+08:00 Creator Tool : PScript5.dll Version 5.2.2 Modify Date : 2019:02:02 10:08:11+08:00 Format : application/pdf Creator : Mindy Wang Title : Microsoft Word - 2ARYWWB-10_User Manual.docx Document ID : uuid:c29753b3-f1b8-41c6-8d6f-c07235d1b511 Instance ID : uuid:6a7ce94f-9266-4a2e-b1cf-5ce88b4b9168 Page Count : 6 Author : Mindy WangEXIF Metadata provided by EXIF.tools