Thermaltake Technology MOVXPWDLOBK01 Ventus X Plus User Manual VENTUS X Plus QIG print
Thermaltake Technology Co., Ltd. Ventus X Plus VENTUS X Plus QIG print
User Manual
Additionally, the reports did not contain an example of the manufacturer’s certification statement. The required
certification statement (21 CFR1010.2(b))must be delivered with the
laser product. It must be in the form of a label or tag permanently affixed to or inscribed on the
laser product and it must be in the Englishlanguage. References to other organizations and
standards (unless in conformance with FDA laser Notice No. 502) are not sufficient to fulfill this requirement.
Address: 5F.,No.185,Sec.2, Tiding Blvd Neihu Dist., Taipei City 114,Taiwan
NCC警語 - 低功率射頻電機：
┍依據低功率電波射性電機管理辦法┛ 第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或
使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。第十四條 低功率射頻電機之使用不得影
響飛航安全用干擾合法通信；經發現有干擾現象時應立即停用，并改善至無干擾時方得繼續使用。前項合法通
信，指依電信法規定作業之無線電通信。低功率射頻須忍受合法通信或工業、科學及醫療用電波輻射性電機設
備之干擾。┛
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communication. However, there is no guarantee
that interference with not occur in a particular installation. If this
equipment does cause harmul interference to radio or television
reception, which can be determined by turning the equipment off and
on,the user is encouraged try to correct the interference by one or more
of the following
measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlent into an outlet on a circuit different
fromthat to which
-Consult the dealer or an experienced radio/TV technician for help.
the receiver is connected.
FCC Caution; Any changes or modifications not exprdssly approved by
the party responsible for compliance could void the user’s suthorith to
opreate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:(1) This device may not cause harmful
interference, and (2)this device must accept any interference received,
including interference teat may cause undesired opreation
料號：
材質：80G書紙
尺寸：138X138MM
FCC WARNING STATEMENT