Thermo Products Pride Furnace Ohfa199Dv5B Users Manual

2015-02-03

• MODEL:
• OH6FA072D48B OH6FA072DV4B OH8FA119D60B OH8FA119DV5B
• OH6FA072D48R OH6FA072DV4R OH8FA119D60R OH8FA119DV5R
• OH6FA072D48N OH6FA072DV4N
• CONTENTS
• Model Number Digit
• A
  • Highboy
  • Highboy
  • Model Number
  • OH6
  • OH8
    • Dehum
• F
• O
• Table 1: MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS
• Fig. 2: Proper chimney termination height for pitched roofs
• Fig. 3: Proper chimney termination height for flat roofs
• Fig. 4: Proper insertion of the vent connector in the chimney.
• REDUCTION OF CLEARANCES WITH SPECIFIED FORMS OF PROTECTION:
  • ROTATION OF FRONT FLUE ELBOW:
    • The OH6 & OH8 may be vented through a standard correctly sized chimney.
    • The OH6 & OH8 may also be horizontally vented through a sidewall. Thermo Products has available the Field model FDVS-45/FOVP-415 and FDVS-67/FOVP-615 side wall vent kits for such applications. When installing the sidewall vent kits, outside combustion...
    • C. DRAFT REGULATORS:
    • Table 3: Suggested Duct Sizes for Homes, Quiet Offices, Or Similar Installations
    • Fig. 9: Supply air duct sizing Example
• E. Air Filter Mounted External to Furnace:
  • Fig. 10a: A typical filter rack and dimensions for the OH6 furnace.
  • Fig. 10b: A typical filter rack and dimensions for the OH8 furnace.
  • F. LIMIT POSITION AND LOCATION
  • Fig. 12: Typical location of the over fire air tap and components in burner mounting plate area
    • H. BURNER SPECIFICATIONS AND APPLICATIONS:
• Riello 2-stage burner specifications and applications (OH6 ONLY):
• I. OIL TANK AND PIPING:
  • K. ELECTRICAL WIRIING:
  • Figure 15: The Fan Control Module
  • Figure 17: Analog Ammeter w/ Wire Loops to Boost Reading
  • “COOL” Blower cool speed tap
• A. Inputs
  • B. Outputs
  • Four green LEDs are placed beneath their respective thermostat connections (W, Y, G and DEHUM) and operate whenever a call is present. See Diagnostic Features for a function description of operation.
  • C. Operating Modes
  • N. STARTUP PROCEDURES:
  • A. Heating System
• III. USERS INFORMATION SECTION
  • C. INSPECTION AREAS
  • D. STARTING THE BURNER:
  • E. FILTER CLEANING AND LOCATION:
  • IV. INSTALLER'S INSTRUCTIONS TO USER:
    • V. DEALER MAINTENANCE:
      • A. GENERAL INSPECTION:
        • B. HEAT EXCHANGER:
      • D. ELECTRICAL SYSTEM:
        • VII. TROUBLESHOOTING:
        • IX. Trouble Shooting Flow Chart:
• MO-437 printing specifications.pdf
  • Individual page specifications: