TianJin HuaLai Technology WHSB1 WYZE Sensor Bridge User Manual
TianJin HuaLai Technology Co.,Ltd. WYZE Sensor Bridge
User manual
Wyze Sense Starter Kit
QUICK START GUIDE
SETUP
1Insert the Sensor Bridge into the
USB port of a Wyze Cam or Wyze
Cam Pan.
This device complies with part 15 of
the FCC Rules. Operation is subject to
the following two conditions: (1) This
device may not cause harmful
IN THE BOX
Wyze Contact Sensor
(battery pre-installed)
Wyze Motion Sensor
(battery pre-installed)
Wyze Sensor Bridge
Quick Start Guide
Pin
x2
x1
x1
x1
x1
STATUS LIGHTCONTACT SENSOR
PLACEMENT
MOTION SENSOR
PLACEMENT
FCC Compliance
Statement
Bridge
Sensors
Solid yellow light
The device is powered on, but
not connected
Flashing yellow/blue light
The bridge is connecting
Solid blue light
The device is working properly
Flashing blue light
The device is ready to pair with
a sensor
Ensure the two sections of the Contact Sensor
are at most 2 cm apart when closed.
Place Sensor approximately 6 feet high and
ensure the Wyze Logo is in the top left corner.
Red light
Sensor triggered
POWER
Wyze Sensor Bridge
2Log into your Wyze account and
add a new device from the Home
page. Follow the instructions in
the Wyze app to finish setup.
3Repeat Step 2 for each Contact and
Motion Sensor.
Wyze
@WyzeCam
40mm
40mm
2cm(max.)
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Note: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
—Reorient or relocate the receiving
antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an
outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced
radio/TV technician for help.
Wyze Sensor BridgeWyze Motion SensorWyze Contact Sensor
( WHCS1) ( WHMS1) ( WHSB1)
NEED HELP?
Resources & Support
www.wyze.com/support
Community
www.wyze.com/forums
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority
to operate the equipment.