Tiger Electronics 06-001-00-01 Walkie Talkie User Manual 8

Tiger Electronics Inc Walkie Talkie 8

8

Download: Tiger Electronics 06-001-00-01 Walkie Talkie User Manual 8
Mirror Download [FCC.gov]Tiger Electronics 06-001-00-01 Walkie Talkie User Manual 8
Document ID59645
Application ID2uvdc+/swy26FIUY8YC2ug==
Document Description8
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize4.73kB (59091 bits)
Date Submitted1999-09-20 00:00:00
Date Available1998-10-06 00:00:00
Creation Date2001-06-06 03:23:50
Producing SoftwareAcrobat Distiller 4.0 for Windows
Document Lastmod2001-06-06 03:23:52
Document Title8

EXHIBIT C
User Manual
TO OPERATE:
Lthua
Switch the ON/OFF VOLUME control ON by pushing the dial down To turn OFF, move the dial
up until you hear it click
To transmit, press the PUSH TO TALK button and speak into the microphone, Speak in a normal
voice
To receive, release the PUSH TO TALK button, and listen to the sender's message.
Your voice will transmit up to [00 feet in areas with clear reception.
The walkie talkie can attach to your belt with the BELT CLIPS for ease and portability.
“THE FOOLING FACTORS CAN AFFECT THE PERFORMANCE AND OPERATING
RANGE OF THE WALKIE TALKIE: COMPUTERS, ACTIVE ELECTRONIC EQUIPMENT,
FLUORESCENT LIGHTS AND TALL BUILDINGS”
CAUTION:
5"
F"
If your walkie talkie does not operate properly try a new set of batteries since your batteries may
be defective or have low voltage even though they appear to be new.
Afier use always return the ON/OFF control to the OFF position.
Do not touch antenna with your fmgers or hand. It will cause week transmission.
Your walkie talkie set has been fully adjusted prior to shipment from the factory. Do not touch the
internal parts other than replacing the battery.
Manufacturer recommends alkaline batteries for maximum performance,
To prevent damage. do not expose the set to rain or moisture.
To ensure proper fimction:
Do not mix new & old batteries.
Do not mix alkaline, standard or rechargeable batteries.
Battery installation should be done by an adult.
Non—rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed form the toy before being charged (if removable).
Rechargeable batteries are only to be charged under adult supervision (If removable)
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy.
The supply terminals are not to be short circuited.
BATTERY INSTALLATION:
1.
2.
3.
Slide the ON/OFF SWITCH to the OFF position.
To open the BATTERY COVER, slide the BATTERY COVER in downward motion to release the
door.
To install 9 volt or “6LR61” battery observe the battery polarity by matching the snap on the
connector with the proper snap terminals on the battery, Use care not to bend the connector
terminals. Push the battery connector firmly on the battery. Reinstall the BATTERY COVER.
iNFORNATION TO THE USER
kk*1kkekk=kkuk$fitflxtfikk
This deVice complies with part 15 of the FCC Rules.
Operation is subjeCt to the following two conditions:
(1) This device may not cause harmful interference.and
(21 This deVice must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to cemply with the
limits for a Class 8 digital device Pursant to Part 15 of the
FCC Rules. These limits are deSiened to provide reasonable
protection against harmful interference in a reSLdential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions‘ may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception. Which can be determined by turning the equipment off
and on the user is encouraged to try to correct the interference
by one or more of the following measures:
—-Reorient or relocate the receiving antenna.
—~Increase the separation between the equipment and
receiver.
-—Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected,
__Consult the dealer or an experienced radio/TV technician
for help.
This booklet is available from the US government Printing Office
*washington, DC 20402, Stock NO. 004—000—00345-4.
CAUTION: Any changes of modifications not expressly
approved by the grantee of this device could void the
users authority to operate the equipment.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : Yes
Create Date                     : 2001:06:06 03:23:50
Producer                        : Acrobat Distiller 4.0 for Windows
Modify Date                     : 2001:06:06 03:23:52-04:00
Page Count                      : 3
EXIF Metadata provided by EXIF.tools
FCC ID Filing: I5406-001-00-01

Navigation menu