TimeKeeping Systems DD-001 DD-001 User Manual

TimeKeeping Systems Inc DD-001 Users Manual

a href="https://usermanual.wiki/TimeKeeping-Systems" itemprop="url"> TimeKeeping Systems >

Users Manual

GUARD1/tracking Duress Device User's Manual
Introduction The Duress Device is a portable device that is worn on a duty belt or lanyard by officers, staff, or visitors. It monitors their status and transmits information to a control room monitor. It can be used to signal an emergency. The Duress Device sends a signal to the Guard1 Tracking system once each second. If this signal is interrupted, the panic button is pressed, or if a secondary condition is detected, an alert is raised in the Guard1 Tracking system. Using the Duress Device The Duress Device has a button on its front, for sending a panic alert. It has one LED, which is used to confirm it is operating and display battery status. The Duress Device has a vibration motor and a beeper. Either one of these may be enabled, or both. This is set at the factory, depending on your organization’s requirements. Charging To charge the Duress Device, place it in the charger. Charging takes approximately three hours. ● ♩ STATUS Single beep entering Charging mode The LED indicates the charge status. There are two stages to the charging process: Flashing red slowly Waiting to charge. Make sure the charger is plugged in. Solid Red Stage 1 Solid Orange Stage 2 Solid Green Charge complete You can remove the Duress Device and use it at any time during the charge sequence. Self Test If you press the button while the Duress Device is in the charger, it will beep and vibrate, and the LED will be solid orange. The Duress Device then returns to normal operation. It's a good idea to test the device each day, before you go on duty. ● ♩ STATUS One beep per second If you press the button for more than ten seconds while the Duress Device is in the charger, it will enter Shipping mode. This must be done before shipping the Duress Device to another facility or back to the manufacturer. To return the device to normal operation, remove it and re-insert it in the charger. Active Mode In active mode, the LED flashes once each second. ✹ ♩ STATUS Single beep entering Active mode The LED will indicate the battery status: green for good, orange for low, and red for discharged. If the battery is low or discharged, place it in its charger as soon as you are able to.
Download:
Mirror Download [FCC.gov]
Document ID3391621
Application IDampZazc8vfodgWuiE/n2Nw==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize16.8kB (209952 bits)
Date Submitted2017-05-15 00:00:00
Date Available2017-05-15 00:00:00
Creation Date2016-08-12 10:59:29
Producing SoftwareMicrosoft® Word 2013
Document Lastmod2016-08-12 10:59:29
Document TitleUsers Manual
Document CreatorMicrosoft® Word 2013
Document Author: Barry Markwitz
FCC ID Filing: MTD-DD-001

Navigation menu