Timecode Systems TCB01 Timecode Master User Manual FCC Manual Addendum v2

manual addendum

12 Holt Castle Barns, Holt Heath, WORCESTER, WR6 6NJ

Addendum

Contains FCC ID: W7OZG2100-ZG2101

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy, and if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

•Consult the dealer or an experienced radio/TV technician for help.

To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a

separation distance of 20 cm or more should be maintained between the antenna of this

device and persons during operation. To ensure compliance, operation at closer than this

distance is not recommended.

The antenna(s) used for this transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter.