Tong Lung Metal Industry PL1 KKEYPAD ELECTRONIC DEDBOLT LOCK User Manual
Tong Lung Metal Industry Co.,Ltd. KKEYPAD ELECTRONIC DEDBOLT LOCK Users Manual
User manual
http//www.ezset.com.tw
12345
67890
12345
67890
12345
67890
KEYPAD ELECTRONIC LOCK
REMOTE CONTROL MANUAL
Remote is well programmed already. You may use
it without programming only if you want to add
more remotes or change the setting.
Please refer to the following instructions.
FEATURES
1. Power & Battery
1-1 Power : a CR2025 lithium button cell battery needed.
1-2 Changing Battery : Please use slotted head screwdriver to
separate the plastic cover and change the battery.
1-3 All setting will not be changed or eliminated because of
battery replacement.
2. Transmission Distance
30M without obstruction.
3. Lock the lockset
Press on remote once
→ Green light flashes twice with 1 short beep.
→ The door is locked.
Battery
4. Unlock the Lockset
Press on remote once.
→ Green light flashes twice with 1 short beep.
→ The door is unlocked.
PROGRAMMING
1. Add Remotes (under unlock status)
(1) Enter Programming Code
→ Press
→ Enter
→ Press
→ Press any button on remote
→ It's usable after 8 seconds
(2) 3 short warning sounds when re-add the same remote.
The remote is still valid, and won't occupy the number of
available remotes.
(3) Up to 5 remote controls available.
2. Delete All Remotes
(1) Enter Programming Code
→ Press
→ Press
→ Press
(2) It's not available to delete individual or specified remote.
When you delete remotes, you delete all of them.
REMARK
1. When pressing RESET button, all the remote setting will be
eliminated as well.
2. Do not put in the battery backward, it might cause a
breakdown of remote.
TONG LUNG METAL INDUSTRY CO., LTD.
62, Chung Hsiao 1st Street, Hou-Hu-Li, Chia-Yi 600.
Taiwan, R.O.C.
TEL : 886-5-2770017 FAX : 886-5-2767392
Notice : The changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
IMPORTANT NOTE : To comply with the FCC RF exposure
compliance requirements, no change to the antenna or
the device is permitted.
Any change to the antenna or the device could result
in the device exceeding the RF exposure requirements
and void user's authority to operate the device.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.