Topcon America 080521 Radio Holder User Manual RH 1 USER MANUAL 100308
Topcon America Corporation Radio Holder RH 1 USER MANUAL 100308
Contents
- 1. Users Manual
- 2. Manual
Manual
RH-1 USERS MANUAL Please read these Terms and Conditions carefully. This product is designed to be used by a professional. The user should have a good knowledge of the safe of the product and implement the types of safety procedures recommended by the local government protection agency for both private use and commercial job sites. Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void your authority to operate such equipment. Turn off the power supply near a highly accurate electronic equipment. RH-1 ・Outline of product RH-1 is GPS receiver in GRS-1 to measure the GPS data in real time. RH-1 supplies the electric power to GRS-1 by two battery and outside AC power, and enables the operation of GRS-1 of long time. ・Physical Dimensions : 8.50” x 5.83” x 6.71” ( 216 x 148 x 170.5 mm ) no Antenna :15.47” x 5.83” x 6.71” ( 393 x 148 x 170.5 mm ) with Antenna Weight :1.4Kg Input / output :Bluetooth,Serial, Power, Antenna,Communication pins(for GRS-1) Battery Type :Li-ion battery, Rechargeable / Replaceable Input voltage :12 to 20V Operating temperature :-20 C° to +50 C° Strage temperatuere :-30 C° to +60 C° Waterproof :IPX4 ・Use 1. GRS-1 is installed in the holder. 2. Pushing the switch long , that RH-1 LEDs is lit. 3. Pushing the switch short , that RH-1 LED4 is matched to the machine used. 4. The power of GRS-1 is turned on. The user doesn't operate GPS from RH-1,because The user does all the operations concerning GPS from GRS-1. The electric power is supplied to GRS-1 without operating it under such a condition. (1/4) ・LED LED 1: Battery 1 (Red and Green) Green: Using / Battery Full Red Blink: Using / Battery Empty LED 2: Battery 2 (Red and Green) Green: Using / Battery Full Red Blink: Using / Battery Empty LED 3: Radio Modem Status (Green and Orange), Same as GR-3 Radio status LED. Non: Turn Off Red: Data Transmitting Green: Data Receiving LED 4: Serial port Connection mode and Radio power(Red, Green and Orange) Green: Radio board is connected to Bluetooth External port is connected to GRS-1 Red: Radio board is connected to GRS-1 Orange: Radio board is connected to External connector Non: Radio board is OFF Connected between GRS-1 and External connector ・Radio Each model built-in the following radio. The specification is same as GR-3’s radio portion. UHF 410-470MHz Antenna SA915 Satel Contact pins UHF for Japan (for GRS-1) ・RH-1 standard package includes ・Radio Holder unit Bluetooth ・Two Li-ion Battely ・Radio antenna ・Power adptor AD-11 (AC-DC Adptor) ・AC Cable ( for AD-11) Switch Panel ・Serial Cable ( DB9 ) ・Manual CD External port & Power port (2/4) Modem FCC Regulatory Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications not expressly approved by the party responsible for product compliance could void the user's authority to operate the equipment. Caution Exposure to radio frequency radiation To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. This device must not be co-located or operating in conjunction with any other antenna or transmitter. (3/4) Industry Canada Canada Regulatory Compliance Statement This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numériqué de la classe B est conformé à la norme NMB-003 du Canada. For Customers in Canada This device complies with RSS 210 of Industry Canada (IC). Operation is subject to the following two conditions: ・this device may not cause interference, and ・this device must accept any interference, including interference that may cause undesired operation of this device. L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes: ・il ne doit pas produire de brouillage et ・I'utilisateur du dispositif doit étre prêt a accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif. Exposure to radio frequency radiation The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s website at www.hc-sc.gc.ca/rpb. (4/4)
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39 Format : application/pdf Creator : Mika Title : Microsoft Word - RH-1_USER_MANUAL_100308.doc Create Date : 2008:10:04 08:17:14+09:00 Creator Tool : PScript5.dll Version 5.2.2 Modify Date : 2008:10:04 08:17:14+09:00 Producer : Acrobat Distiller 8.1.0 (Windows) Document ID : uuid:de30313f-dd81-42ec-b7e7-f14d73a19be3 Instance ID : uuid:b872d02b-fb11-4d72-b4d6-7f9aee1603c6 Page Count : 4 Author : MikaEXIF Metadata provided by EXIF.tools