Topcon RS1NJT499 Wireless LAN Module User Manual

Topcon Corporation Wireless LAN Module

a href="https://usermanual.wiki/Topcon" itemprop="url"> Topcon >

User s Manual081119 1 revised

RS1NJT499 USER’S MANUAL Over View This device is a 802.11g/b WirelessLAN Module, which operates in 2.4GHz ISM band . The system is compliant with IEEE Wireless LAN standards 802.11b/g It uses OFDM technique that the maximum data rate could up to 54Mbps. If the signal to noise ratio is too poor which could not support 54Mbps, the 11Mbps data rate with DSSS technique will be applied. Physical Specifications Table A-1 Physical Specification Dimensions W:45.4 D:20.8 H:7.0mm Weight 15g Input / output USB/Power/antenna Input voltage 3.3V±5% /460mA (typ) Operating temperature 0-+40℃ Strage temperatuere -10-70℃ Wireless specifications Table A-2 Wireless Specifications Standard IEEE802.11/b/g Frequency modulation technique T DSSS,OFDM Data speed T 1,2,5.5,11,6,9,12,18,24,36,48,54Mbps Frequency Range 2412-2462MHz Channel 1-11 Output power 30mW The channel AREA is controlled with software. We are preparing software which controls within the range of 1-11 channels. This software driver software which operates by Window CE5.0. The released device will only be capable of use on channels 1-11.( excludes for Japan.)
Installation Guide 1. Module connected to USB Port on the mother Board in your Equipment. (see below) NAME SPEC MODEL I/F Connecter USB Port AXK6F20545YJ RF Connector Antenna coaxial connector U.FL-R-SMT *We are preparing driver software which operates by Windows CE5.0. Confirm the homepage of Microsoft to the method of installing the driver software. You must make sure that 20cm minimum separation is maintained between users and the antenna. Warning Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Regulatory Information Compliance statement to FCC/IC This module complies with part 15 of the FCC rules and IC RSS-210. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF exposure compliance 1) To comply with FCC/IC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. 2) This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Requirements to end product This module must be integrated only by OEM integrators under the following conditions. Mother Board USB Port Bottom View Top View Connect to USB Port Antenna
Download:
Mirror Download [FCC.gov]
Document ID1035949
Application IDTwgIEXUjJ/ZESHSJwpzjMA==
Document DescriptionUser s Manual081119 1 revised
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize2.37kB (29566 bits)
Date Submitted2008-11-26 00:00:00
Date Available2008-11-27 00:00:00
Creation Date2008-11-19 13:22:45
Producing SoftwareAcrobat Distiller 6.0 (Windows)
Document Lastmod2008-11-19 13:22:45
Document Titleuntitled
FCC ID Filing: H5P-RS1NJT499

Navigation menu