Toy State 38721 Remote Control Toy Transmitter User Manual 38721 CAT Instr 101703

Download:
Mirror Download [FCC.gov]
Document ID	376887
Application ID	h/Hsw5VA2NhCFZbS1bLlcg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	19.37kB (242187 bits)
Date Submitted	2003-12-01 00:00:00
Date Available	2003-11-28 00:00:00
Creation Date	2003-10-17 15:36:36
Producing Software	Acrobat Distiller 5.0.5 for Macintosh
Document Lastmod	2003-10-17 15:36:36
Document Title	38721_CAT_Instr_101703.qxd
Document Creator	QuarkXPress(tm) 5.01
Document Author:	npalie

CAUTION-ELECTRICALLY RADIO CONTROL
OPERATED
PRODUCT:
DUMP
TRUCK
NOT RECOMMENDED FOR CHILDREN UNDER 5 YEARS
OF AGE. AS WITH ALL ELECTRIC PRODUCTS,
PRECAUTIONS SHOULD BE OBSERVED DURING
HANDLING AND USE TO PREVENT ELECTRIC SHOCK.
INPUT: 120V AC 60Hz 3.8W. OUTPUT: 12V DC 200mA.
OWNER’S MANUAL
BATTERY REQUIREMENTS:
4 “AA” Batteries (for Controller)
One 9.6V Rechargeable Power
Pack/Charger
(for Truck).
© 2004 Caterpillar
CAT, CATERPILLAR, and their design marks
are registered trademarks of Caterpillar Inc.
Call for Help!
If you have questions about this toy
MADE IN CHINA
TOY STATE INDUSTRIAL LTD.
14 Science Museum Road, Kowloon, Hong Kong
1-877-473-8015
Call Toll-Free:
Between 9:00 a.m. – 5:00 p.m. E.S.T. Monday thru Friday
Contact via e-mail: consumerservice@toystate.com
FRONT END ALIGNMENT
Trim adjustment is located under vehicle between front
wheels. Adjust trim to align wheels for straight line driving.
MANUFACTURERS NOTE
“Modifications not authorized by the manufacturer may void users authority to operate the device.”
CAUTION
Important Battery Information
TROUBLESHOOTING AND CARE FOR R/C TRUCKS
PROBLEM! TRUCK DOES NOT MOVE
• Are the + and –‘s contacts correctly matched in the controller?
• Are the metal contact tabs touching, rusty or dirty in controller?
• Are there batteries in the vehicle and controller?
• Is the power switch turned on?
• Is the battery/power pack weak or out of power?
• Is the Lock button on the controller activated? Press again to start the engine.
• Are there batteries in controller?
PROBLEM! TRUCK MOVES BY ITSELF
• There is radio interference in the area.
• Another R/C vehicle with the same frequency is close by.
• The antenna of controller is not screwed in tight.
• The antenna is not fully extended.
• A supernatural phenomenon.
PROBLEM! TRUCK RUNS SLOWLY
• There is radio interference in the area.
• Another R/C vehicle with the same frequency is close by.
• The antenna of controller is not screwed in tight.
• The antenna is not fully extended.
PROBLEM? PERFORMANCE DROP, INCONSISTENT MOVEMENT OR FAILS TO RUN
RECHARGEABLE BATTERY PACK IS NICKEL CADMIUM, BATTERY MUST BE RECYCLED OR DISPOSED
OF PROPERLY.
NOTE: 10 hour charging is recommended. The minimal time for charging is no less than 5 to 6 hours
to assure proper performance of the dump truck.
•
•
•
•
•
•
•
•
•
•
•
Allow the battery pack to cool before recharging.
Do not recharge batteries that are leaking or broken.
Always disconnect battery pack from truck when not in use.
Do not dispose of battery pack in fire.
Dispose of NiCd battery packs properly.
Always remove battery pack from vehicle before charging.
Do not use charger for any other use other than instructed in directions.
Use only batteries of the type recommended.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Do not mix old and new batteries.
Remove batteries from truck if vehicle will not be used for a long period.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Recharge battery power pack for 5 to 6 hours minimum and replace batteries in controller with
new alkaline batteries.
Call 1-877-473-8015 for help!
REMOVE THE “TRY ME” WIRE
TREAT YOUR TRUCK WELL
Radio waves control and drive the truck. Care for your truck and it will provide hours of fun!
Avoid water, heat, sand and high impact crashes! Off road vehicles may run on grassy dry areas.
Your CAT Radio Control Truck was sold in a
shelf demo package. Remove the vehicle and
controller from box. Remove and discard the “TRY
ME” wire from vehicle and controller. The wire is
not required for normal operation.
Charge the 9.6V Power Pack for at least 10
hours (first 2 charges) and your CAT truck is ready
to run.
Remove and discard “Try Me” wire from
controller and vehicle.
1. A special wire (connecting the controller & the
chassis) is required for demonstration. Please
disconnect and discard this wire after purchase.
Store in safe place.
No direct sunlight.
No rain.
No sand or dust.
No Collisions.
Truck may get stuck on carpet or grass.
BATTERIES AND ANTENNA TUBE INSTALLATION
Avoid running 2
vehicles with the
same radio control
frequencies.
1. Your controller comes equipped with 4 “AA” batteries.
Alkaline batteries are recommended.
2. Insert a fully charged 9.6V power pack into the truck,
mating the plug to the battery pack.
CLEANING AND MAINTAINING HINTS
3. Push antenna through the hallow tube.
4. Insert tube into hole on vehicle. Tie a knot with wire at
the top of the tube. (Do not pull wire tight)
Brush areas where dirt and dust
get trapped.
Wipe body off with a soft rag or
tact cloth.
Do not clean vehicle with
chemicals or water.
BATTERY AND ANTENNA INSTALLATION IN CONTROLLER
Loosen screw to open battery
compartment.
Insert 4 “AA” Batteries. Be sure the +
and – are properly matched.
TRUCK FEATURES
Screw antenna in tightly for best
transmission.
NOTE:
For best performance, always use alkaline batteries only.
Forward Action!
Reverse Action!
Turns Left or Right.
Raise or Lower Dump Bed.
BATTERY PACK INSTALLATION IN TRUCK
To remove battery cover, loosen screw
to open.
Connect battery by mating two
plastic clips.
Place 9.6V battery in compartment
and secure battery cover.
IMPORTANT:
YOUR CAT 9.6V POWER CHARGE NiCd BATTERY PACK MUST BE FULLY CHARGED PRIOR TO USE.
FOR BEST RESULTS BE SURE TO CHARGE BATTERY PACK FOR 10 HOURS. WHEN CHARGING
BATTERY PACK FOR THE 2ND TIME, ALSO CHARGE BATTERY PACK FOR 10 HOURS. AFTER THE
INITIAL 2 CHARGES, BATTERY PACKS WILL THEN ACHIEVE FULL CHARGE IN 5 TO 6 HOURS.
NOTE: 10 hour charging is recommended. The minimal time for charging is no less than 5 hours to
assure proper performance of the dump truck.
Activate Sound Effects.
TIPS & TRICKS
NO PATIENCE. . . QUICK START GUIDE
• Remove demo wire.
• Fully charge battery pack for 10 hours.
• Install battery pack in truck.
FULLY CHARGE THE BATTERY PACK
Always use truck with a fully charged battery pack.
Partially charged packs will not provide optimal
performance.
NOTE: 10 hour charging is recommended. The minimal time
for charging is no less than 5 to 6 hours to assure proper
performance of the dump truck.
• Install antenna.
• Learn function of controller.
• Enjoy!
DRIVING THE TRUCK
Turn ON/OFF switch
(on bottom of left
fuel tank) to the ON
position (as shown.)
INSTALLATION OF POWER PACK
Align battery pack with arrows in battery
compartment. Connect wires from pack to mating
connector of truck.
Flashing LED on
truck indicates
power on.
Antenna
Easy Carry Handle
STRONG BATTERY MEANS OPTIMUM
PERFORMANCE
Save the battery by turning off vehicle when not in use.
Forward, Neutral and
Reverse
Extend controller
antenna to full
length. Indicator
light works when
in use.
Left and Right
Steering
LIMITED RADIO CONTROL RANGE
While truck may be visible at a distance, full
operational control may be lost. Hold controller
high in the air and direct truck back.
Dump Bed Control
(Up and Down)
Start, Horn, Music
0 FT
80-1
Start, Horn, Music
INTERFERENCE
Other radio signals may cause loss of control.
Remove vehicle from an area of interference.
After play, always turn vehicle off. Remove “AA” batteries from controller and 9.6V rechargeable Power
Pack from vehicle when not in use or when storing. Leakage may occur and cause damage if left for a
long period of time.
HOW TO RECHARGE THE Ni-Cd BATTERY PACK
Ni-Cd Rechargeable Battery Pack and Charger
(Not Included in the kit)
• The newly purchased Ni-Cd pack (4.8V, 9.6V, 600mAH-720mAH) is not charged.
Recharge before starting.
• How to use the special charger for Ni-Cd packs:
1. The charger with the battery pack.
2. Plug in the female connector.
3. Plug the charger into the socket.
4. The battery pack will be automatically
charged.
• Average recharging time is approximately 5 to 6 hours.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Create Date                     : 2003:10:17 15:36:36-04:00
Modify Date                     : 2003:10:17 15:36:36-04:00
Page Count                      : 6
Creation Date                   : 2003:10:17 19:36:36Z
Mod Date                        : 2003:10:17 19:36:36Z
Producer                        : Acrobat Distiller 5.0.5 for Macintosh
Author                          : npalie
Metadata Date                   : 2003:10:17 19:36:36Z
Creator                         : npalie
Title                           : 38721_CAT_Instr_101703.qxd

EXIF Metadata provided by EXIF.tools