Toy State 90420F27 Engine Power R/C - 2 Asstd - Baja Bone Shaker User Manual

Toy State International Ltd. Engine Power R/C - 2 Asstd - Baja Bone Shaker

User Manual

CONTROLLER VEHICLEBatteries Not Included Batteries Not IncludedRADIO CONTROLENGINE POWER6+#90420OWNER’S MANUAL4For questions, e-mail our Consumer Service Dept. at consumerservice@toystate.comOr Call 1-877-473-8015www.toystate.comCLEANING AND MAINTAININGBrush areas where dirt and dust get trapped.Wipe body off with a soft rag or tact cloth. Do not clean vehicle with chemicals or water.ENG www.toystate.com3 x AAA/LR03 4 x AA/LR6MADE IN SHENZHEN, CHINATOY STATE INTERNATIONAL LIMITED66 MODY ROAD, KOWLOON, HONG KONGIN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY IMPROVING AND UPDATING OUR PRODUCTS. CONSEQUENTLY, PICTURES IN THIS INSTRUCTION SHEET MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED.WARNING: Not suitable for children under 36 months due to small parts. Choking hazard.HOT WHEELS and associated trademarks andtrade dress are owned by, and used under licensefrom Mattel. ©2013 Mattel. All Rights Reserved.NOTE:This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE“Modifications not authorized by the manufacturer may void users authority to operate the device.”This toy and all accessories need to be periodically examined for potential hazards and any potentially hazardous parts be repaired or replaced.MANUFACTURER’S NOTEATTENTION PARENTS
ENGTROUBLESHOOTING AND CARE FOR R/C VEHICLE3R/C VEHICLEDOES NOT MOVE• Are the + and – contacts correctly matched in the controller?• Are the metal contact tabs touching, rusty or dirty in controller?• Are there batteries in the vehicle and controller?• Is the power switch turned on?• Are the batteries weak or out of power?R/C VEHICLEMOVES BY ITSELF• There is radio interference in the area.• Another R/C vehicle with the same frequency is close by.R/C VEHICLERUNS SLOWLY• There is radio interference in the area.• Another R/C vehicle with the same frequency is close by.• Are the batteries weak or out of power?PERFORMANCE DROP, INCONSISTENT MOVEMENT OR FAILS TO RUNCheck batteries. If necessary, replace the batteries in the R/C vehicle and controller with new alkaline batteries.Radio waves control the R/C vehicle. Care for your vehicle and it will provide hours of fun! Avoid water, heat, sand and high impact crashes!TREAT YOUR R/C VEHICLE WELLStore in safe place. No direct sunlight. No rain or water. No sand or dust.No Collisions. R/C vehicle may get stuck on carpet or grass.Avoid running 2 vehicles with the same radio control frequencies.LIMITED RADIO CONTROL RANGE While R/C vehicle may be visible at a distance, full operational control may be lost. Hold controller high in the air and direct vehicle back.INTERFERENCEOther radio signals may cause loss of control. Remove vehicle from an area of interference.ENG21OPERATING R/C VEHICLENOTE: For best performance, always use alkaline batteries only.CAUTIONImportant Battery Information• Dispose of batteries properly.• Do not dispose of batteries in fire.• Use only batteries of the type recommended.• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.• Do not mix old and new batteries.• Remove batteries from R/C vehicle and controller if vehicle will not be used for a long period of time. GETTING STARTEDRemove the R/C vehicle and controller from the package. Insert batteries into the R/C vehicle and controller to begin full function play(see “Battery Installation” section for further details).ENG ENGAdjust Trim Switch on bottom of R/C vehicle to ensure precision drivingCONTROLLERTO REPLACE THE BATTERIESLOOSEN SCREW TO OPEN1.5V1.5V1.5V1. To remove battery cover, loosen screw to open.2. Insert 3 “AAA” batteries into the controller. Be sure the + and – are properly matched.R/C VEHICLETO REPLACE THE BATTERIESLOOSENSCREWTO OPEN1.5V1.5V1.5V1.5V1. To remove battery cover, loosen screw to open.2. Insert 4 “AA” batteries into the vehicle. Be sure the + and – are properly matched.BATTERY INSTALLATIONAfter play, always turn vehicle off. Remove batteries from controller and R/C vehicle when not in use or when storing. Leakage may occur and cause damage if left for a long period of time.TurnLeft & RightDriveForward &Reverse Turns In All Directions! Rumbling Engine!ONOFFONOFFPLAYDEMO OFFPLAYDEMO OFFTurn ON/OFF switch located on bottom of R/C vehicle to the ON position (as shown)STRONG BATTERY MEANS OPTIMUM PERFORMANCESave the battery by turning off vehicle when not in use.ONOFFONOFFPLAYDEMO OFFPLAYDEMO OFF

Navigation menu