Toy State 94140T49 NANO VAPORIZR 2 User Manual FAR 94140 Nikko IM ENG 032615
Toy State International Ltd. NANO VAPORIZR 2 FAR 94140 Nikko IM ENG 032615
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 2620584 |
| Application ID | 1aTvaiIugqleX6pqLvr9eA== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 292.33kB (3654173 bits) |
| Date Submitted | 2015-05-21 00:00:00 |
| Date Available | 2015-05-21 00:00:00 |
| Creation Date | 2015-03-26 12:12:31 |
| Producing Software | Adobe PDF library 10.01 |
| Document Lastmod | 2015-03-26 12:12:31 |
| Document Title | FAR_94140_Nikko_IM_ENG_032615 |
| Document Creator | Adobe Illustrator CS6 (Macintosh) |
8+ #94140 CONTROLLER x3 BATTERIES NOT INCLUDED VEHICLE x4 BATTERIES NOT INCLUDED Important! Carefully read the Owners Manual before play! GETTING STARTED Remove the R/C vehicle and controller from the package. Insert batteries into the controller to begin full function play (see “Battery Installation” section for further details). CAUTION WARNING! CHOKING HAZARD Small parts. Not for Children under 3 years. Only operate the product and its accessories when fully assembled and in accordance with this manual! This product and its accessorries are not suitable for children under the age of 36 months, because of small parts that can be swallowed. Intended for children age 8 and older. Adult supervision strongly recommended. Drive your vehicle in a safe area away from people, pets, cars, etc. Do not drive on streets or after dark. Do not touch or try to pick up the vehicle when it is in motion. Wait until it has stopped completely. Keep hair, fingers, face and loose clothing away from front and rear wheels while the vehicle is switched on or while the transmitter is operating. Do not drive the vehicle toward walls or other hard objects. Be a responsible operator! Do not drop or give impact to the product and its accessories. Check if a near transmitter produces interference or signals with the same frequency. In such a case, move to another location or try again after a while. Never attempt to disassemble or modify the product or its accessories. Regularly inspect the antennas for cracks or breaks. Do not bend the transmitter antenna. Do not use the transmitter if the antenna is broken. The vehicle wire antenna is fragile. Never pull or tug on the antenna, as it may loosen or detach from the vehicle. Use extra caution when playing near water or ice. Intended to be used on land and in water. Do not use the product in salt water or water with strong currents. Important Battery Information • Dispose of batteries properly. • Do not dispose of batteries in fire. • Use only batteries of the type recommended. • Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. • Do not mix old and new batteries. • Remove batteries from R/C vehicle and controller if vehicle will not be used for a long period of time. ANTENNA ASSEMBLY Insert antenna wire from product into tube EN Slide tube down Tie knot with any antenna wire and into remaining antenna wire hole in product (Do not pull wire tight) BATTERY INSTALLATION CONTROLLER 1. To remove battery cover, loosen screw to open. 2. Insert 3 “AAA” batteries into the controller. Be sure the + and – are properly matched. R/C VEHICLE Open 1,5V 1,5V 1,5V 1,5V Unscrew the vehicle's top cover and remove it as shown in the illustration. OFF ON OFF ON Open DEMO OFF PLAY DEMO OFF PLAY 1,5 Unscrew the battery cover and open it. Insert 4xAA batteries and pay attention to place them with the correct polarity (+/-). NOTE: For best performance, always use alkaline batteries only. EN OFF ON OFF ON STRONG BATTERY MEANS OPTIMUM PERFORMANCE Save the battery by turning off vehicle when not in use. OPERATING R/C VEHICLE After play, always turn vehicle off. Remove batteries from controller and R/C vehicle when not in use or when storing. Leakage may occur and cause damage if left for a long period of time. This vehicle can run on land and in water but it is not fully water-proof! Immersing it into water may lead to a malfunction. Dry vehicle well after operating in water. Adult supervision is strongly recommended when playing near water. Do not drive your vehicle in the sea and wavy water surface, or where a rapid current flows. Stay away from areas where waves rise due to a strong wind. Also avoid driving on dirty water surface or where waterweed grows dense, this can cause a malfunction. Operate your vehicle in water with due care to the distance and battery life, since you need to get the vehicle back before the power of the batteries is drained. FORWARD (Push both sticks forward) BACKWARDS (Pull both sticks backwards) LEFT TURN (FORWARD) (Push right stick forward) RIGHT TURN (BACKWARDS) (Pull right stick backwards) RIGHT TURN (FORWARD) (Push left stick forward) LEFT TURN (BACKWARDS) (Pull left stick backwards) LEFT SPIN (At the same time, pull left stick back and push right stick forward) RIGHT SPIN (At the same time, pull right stick back and push left stick forward) EN SAFETY CIRCUIT During use, the internal power in the electric circuit can get quite high (for example during a 360 spin). In such a case a safety circuit will shut down the vehicle for approximately 10-15 seconds. During this period the car will not respond to signals from the transmitter. This is not a defect but a safety measure to protect the electronic circuits. After this period, the car will resume normal operation. TROUBLESHOOTING AND CARE FOR R/C VEHICLE LIMITED RADIO CONTROL RANGE While R/C vehicle may be visible at a distance, full operational control may be lost. Hold controller high in the air and direct vehicle back. INTERFERENCE Other radio signals may cause loss of control. Remove vehicle from an area of interference. • Are the + and – contacts correctly matched in the controller? • Are the metal contact tabs touching, rusty or dirty in controller? • Are there batteries in the vehicle and controller? • Is the power switch turned to play? • Are the batteries weak or out of power? R/C VEHICLE DOES NOT MOVE • There is radio interference in the area. • Another R/C vehicle with the same frequency is close by. R/C VEHICLE MOVES BY ITSELF R/C VEHICLE RUNS SLOWLY PERFORMANCE DROP, INCONSISTENT MOVEMENT OR FAILS TO RUN • There is radio interference in the area. • Another R/C vehicle with the same frequency is close by. • Are the batteries weak or out of power? Check batteries. If necessary, replace the batteries in the R/C vehicle and controller with new alkaline batteries. TREAT YOUR R/C VEHICLE WELL Radio waves control the R/C vehicle. Care for your vehicle and it will provide hours of fun! Avoid heat, sand and high impact crashes! Store in safe place. No Collisions. EN No direct sunlight. R/C vehicle may get stuck on carpet or grass. No sand or dust. Avoid running 2 vehicles with the same radio control frequencies. CLEANING AND MAINTAINING Brush areas where dirt and dust get trapped. Wipe body off with a soft rag or tact cloth. Do not clean vehicle with chemicals. FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the userʼs authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. MANUFACTURER’S NOTE “Modifications not authorized by the manufacturer may void users authority to operate the device.” ATTENTION PARENTS This toy and all accessories need to be periodically examined for potential hazards and any potentially hazardous parts be repaired or replaced. www.toystate.com www.NikkoRC.com For questions, e-mail our Consumer Service Dept.at consumerservice@toystate.com Or Call 1-877-473-8015 WARNING: Not suitable for children under 36 months due to small parts. Choking hazard. MADE IN SHENZHEN, CHINA TOY STATE INTERNATIONAL LIMITED 66 MODY ROAD, KOWLOON, HONG KONG IN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY IMPROVING AND UPDATING OUR PRODUCTS. CONSEQUENTLY, PICTURES IN THIS INSTRUCTION SHEET MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED. EN www.toystate.com
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27 Format : application/pdf Title : FAR_94140_Nikko_IM_ENG_032615 Metadata Date : 2015:03:26 12:12:31+08:00 Modify Date : 2015:03:26 12:12:31+08:00 Create Date : 2015:03:26 12:12:31+08:00 Creator Tool : Adobe Illustrator CS6 (Macintosh) Thumbnail Width : 256 Thumbnail Height : 36 Thumbnail Format : JPEG Thumbnail Image : (Binary data 4861 bytes, use -b option to extract) Instance ID : uuid:d4ce02ba-0882-2d48-9cc7-e5ed84d2f946 Document ID : xmp.did:0280117407206811822ADB9CFD4E0F3F Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:a072e565-3696-b142-b8b4-bc56c849955d Derived From Document ID : xmp.did:0180117407206811822AF52E556E5010 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:075748CE30206811822ACD9B0D1E2798, xmp.iid:0280117407206811822ADB9CFD4E0F3F History When : 2015:02:26 17:25:11+08:00, 2015:03:26 12:12:06+08:00 History Software Agent : Adobe Illustrator CS6 (Macintosh), Adobe Illustrator CS6 (Macintosh) History Changed : /, / Manifest Link Form : EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference Manifest Reference File Path : /Volumes/WAREHOUSE/94140 NANO VAPORIZR 2 MANUAL/Nikko_Logo_3D_BW_2.psd, /Volumes/WAREHOUSE/94140 NANO VAPORIZR 2 MANUAL/Nikko_Logo_3D_BW_2.psd, /Volumes/WAREHOUSE/94140 NANO VAPORIZR 2 MANUAL/Nikko_Logo_3D_BW_2.psd, /Volumes/WAREHOUSE/94140 NANO VAPORIZR 2 MANUAL/Nikko_Logo_3D_BW_2.psd, /Volumes/WAREHOUSE/94140 NANO VAPORIZR 2 MANUAL/Nikko_Logo_3D_BW_2.psd, /Volumes/WAREHOUSE/94140 NANO VAPORIZR 2 MANUAL/Nikko_Logo_3D_BW.psd Startup Profile : Print Has Visible Overprint : True Has Visible Transparency : True N Pages : 1 Max Page Size W : 139.700000 Max Page Size H : 208.279966 Max Page Size Unit : Millimeters Font Name : MotionControl-BoldItalic, MyriadPro-SemiboldCond, DIN-Bold, DINOT-Bold, Tahoma-Bold, Helvetica-Condensed, Helvetica-Bold, HelveticaNeue-Condensed, LucidaGrande Font Family : Motion Control, Myriad Pro, DIN, DIN OT, Tahoma, Helvetica, Helvetica, Helvetica Neue, Lucida Grande Font Face : BoldItalic, Semibold Condensed, Bold, Bold, Bold, Medium Condensed, Bold, 57 Condensed, Regular Font Type : Open Type, Open Type, Open Type, Open Type, Open Type, Type 1, TrueType, Type 1, TrueType Font Version : Version 1.0, Version 2.006;PS 002.000;Core 1.0.38;makeotf.lib1.6.6565, 001.000, Version 7.504; 2005; Build 1020, Version 5.01.1x, 001.004, 9.0d3e2, 001.000, 9.0d11e1 Font Composite : False, False, False, False, False, False, False, False, False Font File Name : MotionControl-BoldItalic.otf, MyriadPro-SemiboldCond.otf, DIN-Bold.otf, DINOT-Bold.otf, Tahoma Bold.ttf, HelveCon; Helv_Condensed Screen Fonts, Helvetica.dfont, HelveNeuCon; Helvetica Neue Condensed, LucidaGrande.ttc Plate Names : Cyan, Magenta, Yellow, Black, PANTONE 186 C Swatch Groups Colorants L : 44.705898 Swatch Groups Colorants A : 68 Swatch Groups Colorants B : 40 Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : Grays Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=0 M=0 Y=0 K=50 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 0.000000 Swatch Groups Colorants Magenta : 0.000000 Swatch Groups Colorants Yellow : 0.000000 Swatch Groups Colorants Black : 50.000000 Producer : Adobe PDF library 10.01 Page Count : 8 Creator : Adobe Illustrator CS6 (Macintosh)EXIF Metadata provided by EXIF.tools