Toy State 94145R49 NANO SLAMMR User Manual
Toy State International Ltd. NANO SLAMMR
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 2661989 |
| Application ID | 4yDfyHlwx/G17494sCuozw== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 54.31kB (678852 bits) |
| Date Submitted | 2015-06-30 00:00:00 |
| Date Available | 2015-06-30 00:00:00 |
| Creation Date | 2015-06-30 14:12:29 |
| Producing Software | Adobe PSL 1.2e for Canon |
| Document Lastmod | 0000-00-00 00:00:00 |
| Document Title | User Manual |
| Document Creator | Canon iR-ADV 6255 PDF |
.+-
{+}
-r
-ô
.+-/
FA[t-94r45-Nanoslammr-Ene IM_041615.pdf
0]flt{ER',g
16/4/15 11:38
-o
am
}ilniluflt
8+
ê-r
#94145
trffiMYffitrffL
TTATTE
CONTROLLER
VEHICLE
AAA/1R03 x 3
AA/LR6 x4
BATTERIES NOT INCLUDED
BATTERIES NOT INCLUDED
lmportant! Carefully
Ít
read the 0wners Manual before play!
.@
-@
ô.+-,
-@
FAR_94145-NanoSlammr_Eng
IM_041615
pdf
16/4/15 11:38 am
ô\r
ô.+.,
FPrrlra
rn/17
Èrlt
PRECAUTION
WARNING! CHOKING HAZARD
Small
parts. Not for Children under 3 years,
Only operate the product and its accessories when fully
assembled and in accordance with this manual!
Do not use this vehicle in water, mud, or sand,
This product and its accessorries are not suitable for children under the age of 36 months, because of small
parts that can be swallowed.
lntended for children age 8 and older.
Adult supervision strongly recommended.
Drive your vehicle in a safe area away from people, pets, cars, etc.
Do not drive on streets or after dark.
Do not touch or try to pick up the vehicle when it is in motion. Wait until it has stopped completely.
Keep hair, fingers, face and loose clothing away from front and rear wheels while the vehicle is switched on
or while the transmitter is operating.
Do not drive the vehicle toward walls or other hard objects,
Be a responsible operator!
Do not drop or give impact to the product and its accessories.
Check if a near transmitter produces interference or signals with the same frequency. ln such a case, move
to another location or try again after a while.
Never attempt to disassemble or modify the product or its accessories,
Regularly inspect the antennas for cracks or breaks. Do not bend the transmitter antenna. Do not use the
transmitter if the antenna is broken.
BATTERIES
IMPORTANT BATTERY SAFETY INFORMATION
CAUTION: TO AVOID BATTERY LEAKACE:
NOTE: BATTERIES MUST BE RECYCLED OR DISPOSED PROPERLY.
Contact your local area office of solid waste management or other appropriate
local agency for information.
Make sure the batteries are inserted with correct polarity and follow the toy and battery manufacturer's
instructions,
Use only battery type(s) recommended,
Do not attempt to short-circuit, charge, disassemble or heat batteries.
Do not dispose of batteries in fire or make them wet.
Do not mix or use new and old batteries together,
Do not mix or use different types of batteries together,
Non-rechargeable batteries are not to be recharged because of the danger of eruption.
Remove rechargeable batteries from the product before charging.
Rechargeable batteries are only to be charged under adult supenuision and follow the battery and charger
manufacturer's instructions.
Battery replacement should be done in presence of an adult,
Remove batteries from the product for storage. Batteries may be hot.
After use, be sure to turn the switch off,
Remove weak or exhausted batteries from the product.
Dispose batteries safely and properly, according to your local requirements,
OFF
ON
STRONC BATTERY MËANS OPTIMUM PERFORMANCE
Save the battery by turning off vehicle when not in use
.o
ôr.+-,
+l
,K
-fft+
.J-./
trAR-94145-NanoSlammr-Ene-lM-041615.pdf
.+-
16/4/15 11:38 am
ô
'JRpnln
rilnrRfl,
ANTENNA ASSEMBLY
lnsert antenna wire
g,
Slide tube down antenna
and into hole in
wire
product
from product into tube
rü
Tie knot wilh any remaining
antenna wire (Do not pull wire tight)
BATTERY INSTALLATION
TRANSMITTER
1. To remove battery lid, loosen screw to
1.5V
2,
t 1.5V +
1.5V
open.
Slide open the battery lid in the direction as shown
in the figure, while lightly pressing lts center.
3, lnsert
1,5V (AAA/1R03) batteres x3 with the
polarity (+/-) as shown on the bottom of battery
compartment.Replace the battery lid, following
the removal procedure in reverse.
NOTE: There is no on/off switch on the Transmitter, Moving the sticks turns it on automatìcally
VEHICLE
OFFMON
'â
1, Turn off vehicle,
2.
3,
ii+
Unscrew the vehicle's top cover.
iii rì
Remove vehicle'stop cover as shown in
the illustration.
4. lnsert
1,5V (AA/LR6) batteries x4
into banery compartment with correct
polarity (+/-), Slide back the vehlcle's
top cover and fasten the screw,
NOTE: For best performance, always use alkaline batteries only, To remove the batteries, reverse the
installation proced
re.
+{Þ}
-+./
,1'.
1{Þ+
-+-/
.@
.@
FAR_94145_NanoSlammr-Ene_IM_041615.pdf
4 I6/Ul5
11:38 am
ô-t
Fqrllat
ffrnTPot
OFFEEON
TURN VEHICLE POWER ON
FORWARD
BACKWARDS
(Push both button at the same time)
(Push both button at the same ti
LEFTTURN ÍFORWARDI
RIGHTTURN IFORWARDI
(Push left button forward)
-,ä"iJi',fi,.îTåii,llJüi
1'
LEFT TURN ÍBACKWARDI
(Push right button backwards)
(Push left button backwards)
RIGHTSPIN -smooth surface only
(Push both button at the same time)
LEFTSPIN -smooth surface only
(Push both button at the same time)
0-300
cLtMBtNG: Keep moving the vehicle in
dìrection. That way it cañ climb up hills
have an angle of less than 30 degrees.
ôr+/
one
that
lfll:Jllf^tl:.vehicle
oÞJect llKe a wall'
bv driving against
an
-ô
.+-,
-+
-]-
+{Þ}
.l
FAIì-94 145-NanoSlammr-Eng-IM-041615,pdf
16 / 4/
l5
.@
I 1 :38 am
.@
ô-+.
Rpt)rtt
rttl rPf 7l
SPECIAL MOVEMENTS
Practice special movements by switching the direction of movement at various moments.
This vehicle is not equipped with a trim adjust. While driving the vehicle, it may steer slightly to left or right,
adjust the vehicle with the control buttons.
N0TE:
off. Remove batteries from controller and R/C vehicle when not in
may occur and cause damage if left for a long period of time.
After play, always turn vehicle
use or when
storing. Leakage
SAFETY CIRCUIT
During use, the internal power in the electric circuit can get quite high (for example during a 360 spin),
ln such a case a safety circuit will shut down the vehicle for approximately 10-15 seconds. During this period the car
will not respond to signals from the transmitter. This is not a defect but a safety measure to protect the electronic
circuits, After this period, the car will resume normal operation,
.+-
,l+++
.l
.o
,{
+ût
.l
FAII-94145-NanoSlammr-Ene-IM-041615pdf
.+-
16/4/15 11:38am
{{Þ
r+-/
,-K
{+}
.+./
Hrrftat rnatt'ænt
TROUBLESHOOTING AND CARE FOR R/C VEHICLE
-Ð
t_
LII\4ITED RADIO CONTROL RANGE
INTERFERENCE
Other radio signals may cause loss of control,
Remove vehicle from an area 0f interference.
While R/C vehicle may be visible at a distance, full
operational control may be lost. Hold controller
high in the air and direct vehìcle back,
Are the + and - contacts correctly matched in the controller?
r Are the metalcontacttabs touching, rusty or dirty in controller?
R/CVEHICLE
Are there batteries in the vehicle and controller?
ls the power switch turned to play?
r Are the batterles weak or out of power?
DOESNOTMOVE
RI/C
. There is radio interference in the area.
. Another R/C vehicle with the same frequency
VEHICLE
MOVES BY ITSELF
. There is radio interference in the area.
. Another R/C vehicle with the same frequency
. Are the batteries weak or out of power?
Hi/C VEHICLE
RUNS SLOWLY
PERFORMANCE DROP,
INCONSISTENT MOVEMENT
OR FAILSTO RUN
is close by
is close by,
Check batteries. lf necessary, recharge battery pack and/or replace the
batteries in the R/C vehicle and controller with new alkaline batteries,
TREAT YOUR R/C VEHICLË WELL
RadiowavescontroltheR/Cvehicle, Careforyourvehicleanditwill providehoursoffun!
Avoid heat, sand and high impact crashes!
¿,
ú
Store in safe
No Collisions
-Þ
place.
¿
No sand or dust,
No direct sunlight.
No rain or water
R/C vehicle may get stuck
0n carpet or grass,
Avoid running 2 vehicles with the same radio control
freq ue n cies,
,+-.
-+
-@
FAIL94145-NanoSlammr Ene
IM 0416l5.pdf 7
16/4/15 11:38
am
ìiì
.@
ái+
.+,
RFFIF
TRFI
'ON
CLEANING AND MAINTAINING
Brush areas where dirt and
Wipe body off with a soft
dust get trapped,
or tact
cloth,
rag
Do not clean vehicle with
chemicals or water.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE
NOTE:
This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
theuser'sauthoritytooperatetheequipment.NOTE:
Thisequipmenthasbeentestedandfoundtocomplywiththe
limitsforaClassBdigitaldevice,pursuanttoPartl5oftheFCCRules. Theselimitsaredesignedtoprovidereasonable
protection against harmful ínterference in a residential installation, Thìs equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications, However, there is n0 guarantee that interference willnot occur in a part¡cular installation,lf this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- lncrease the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help,
MANUFACTURER'S NOTE
"Modifications not authorized by the manufacturer may void users authority to operate the device."
ATTENTION PARENTS
This toy and all accessories need to be periodically examined for potential hazards and any
potentially hazardous parts be repaired or replaced,
C€ GO
www,toystate.com
www.NikkoRC.com
For questions, e-mail our Consumer Service Dept. at
cons u merse rvice@toystate,com
0r Call 1-877-473-8015
WARNING:
Not suitable for children under 36 months due to
small parts. Choking hazard,
MADE IN SHENZHEN, CHINA
TOY STATE INTERNATIONAL LIMITED
66MODY ROAD, KOWLOON, HONG KONG
lN THE INTEREST 0F BEITER QUAUTY AND VALUE,
ARE CONSTANTLY |Ì\4PROV|NC
AND UPDATINC OUR PROÐUCÍS,
'IHE
CONSEOUENTLY, PICTURES IN THIS INS]'RUCTJON SHEET MAY SOMENMES DIFFER FROM
ô.+-/
MODEL ENCLOSED,
-+-
+s+
r+,
-o
-o
+
tr4tl94145-NanoSlammr-EnejM-0416i5.pdf
I ßlAß
11:38 am
.o
Í
SIHTE
www.toystate.com
.o
,-K
{P-
||
.o
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Creator : Canon iR-ADV 6255 PDF Create Date : 2015:06:30 14:12:29+08:00 Page Count : 8 XMP Toolkit : Adobe XMP Core Creator Tool : Canon iR-ADV 6255 PDF Producer : Adobe PSL 1.2e for Canon Format : application/pdf Document ID : uuid:58339255-0000-2c9e-fc1c-5e1400000000EXIF Metadata provided by EXIF.tools