TranSystem 890200801 BRS/EBS Transceiver User Manual TRX 221 manual

Download:
Mirror Download [FCC.gov]
Document ID	1631924
Application ID	S3av+sG+lhEVBMd6+W8xJw==
Document Description	User Manual rev
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	38.75kB (484347 bits)
Date Submitted	2012-02-07 00:00:00
Date Available	2011-12-22 00:00:00
Creation Date	2012-02-07 11:30:18
Producing Software	Acrobat Distiller 7.0 (Windows)
Document Lastmod	2012-02-07 11:30:18
Document Title	Microsoft Word - TRX-221 manual.doc
Document Creator	PScript5.dll Version 5.2
Document Author:	TEST

BRS/EBS
Transceiver
Operation Manual
Copyright 2008, TRANSYSTEM, INC.
All rights reserved
TRANSYSTEM INC.
No.1-2 Li-Hsin Rd.I Science-Based
Industrial Park, Hsinchu, Taiwan
Tel:+886-3-5780393 Fax:+886-3-5784111
e-mail: sales@transystem.com.tw
website: www.transystem.com.tw
TABLE
Chapter 1.
Chapter 2.
Chapter 3.
OF CONTENTS
General Information
1.1 Module Features and Specifications
Installation
2.1 Step by Step Installation
2.2 Connection to the Power Inserter and Cable Modem
2.3 Waterproofing Connections
10
Accessories
12
3.1 BRS/EBS Antenna
12
Chapter 1. General Information
1.1 Module Features and Specifications
Category
Parameter
Description
RF frequency
IF frequency
2500 ~ 2624 MHz
152 ~ 276 MHz
30 ± 2dB
0.3 dB/6 MHz
5.5 dB typ / 9.0 dB max
24 dBm
> 90 dB
> 90 dB
Gain
Downstream
Upstream
Noise Figure
Output 3rd Intercept
PCS Rejection
2.3G WCS Rejection
Image Rejection
(add gain)
IF Rejection
In-band Spurious
IF Input
RF Output
Gain
Output 1-dB Compression Point
> 80 dB
Output Transmit Noise
Output Spurious
@+22 dBm Tx output
Output Power Blanking Threshold
TX Switch Latency
Phase Noise
General
LO Leakage at RF / IF ports
LO Frequency
LO Stability
> 80 dB
< -80 dBm
12 ~ 42 MHz
2657 ~ 2690 MHz
24 ± 2 dB
+25 dBm typical
-120 dBm/Hz typical
-118 dBm/Hzm ax
-60 dBc
( in-band and out-band )
-45 dBm @ IF input
< 1.2 micro second
-84dBc/Hz @ 1KHz
-88 dBc/Hz @ 10 KHz
-96 dBc/Hz @ 100 KHz
-50 dBm Max.
Downstream : 2348 MHz
Upstream : 297MHz,2348MHz
± 10 KHz over temp.
Other feature:
1. lightning protection Ok
2. surge protection Ok
3. Transceiver sleep mode Ok
Note: Typical value @25℃, unless otherwise specified. Technical specifications are
subject to change without prior notice.
Chapter 2. Installation
2.1 Step by Step Installation
2.1.1 Mounting Bracket Assembly Suite
The following hardwares are suggested for mounting the Transceiver to
the pole. A set of mounting bracket, one L type screw. Please contact TSI
sales department for this accessory.
2.1.2 Step by Step Installation
Step 1 – Attach sequence
Left to right: Bracket , Mounting screw.
Step 2 – How to Attach
The concave of Bracket 2 is for holding onto the pole.
Step 3 – Tighten the bracket
2.2 Connection to the Power Inserter and Cable Modem
Connections to the Tranceiver are shown in diagram 2.2. Please note:
① The power inserter normally has 3 ports:
DC
Connect to wall adapter with RG-59 cable
ANT Connect to the Transeiver
TV
Connect to Cable modem
VERY IMPORTANT NOTICE!
a. The power inserter should be correctly connected, or the Transeiver
will not operate.
b. Ensure that all wires and cables are hooked up before plugging into
the AC adapter/power supply (i.e. you must hook up the power supply
last).
② After connection, the F connector of Transceiver must be sealed with an
asphalt sealing tape. (For details, please refer to Section 2.3 Waterproofing
Connections)
Diagram 2.2: Connection to Cable modem & Power Inserter
2.3 Waterproofing Connections
Water-proofing is very important during installation of Transceiver. Please
use the included water-proof asphalt tape to seal off the F-connector as
shown below:
① After you plug in the coaxial cable into the F-connector, use the included
water-proofing asphalt tape to seal off the F-connector from the bottom (i.e.
the part close to Transceiver). Note that the tape must wrap up all the thread
of the F-connector.
② The wrap up of the tape must be tight and sturdy. Each wrap-around must
cover at least 50% width of the previous wrap-around.
③ The total width of the wrap-around is about 6cm, which corresponds to 7
to 8 rounds of tapes.
* Warning: If you do not follow the above procedure, the Transceiver could
become malfunctioning due to water leakage.`
Chapter 3 Accessories
3.1 BRS/EBS Antenna
TSI is proud to offer a complete line of 2.5GHz antennas specifically
designed to satisfy your subscribers. Below are the series:
12dBi Corner Reflector
15dBi Spotbeam
17 dBi Viper

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0 (Windows)
Create Date                     : 2012:02:07 11:30:18+08:00
Creator Tool                    : PScript5.dll Version 5.2
Modify Date                     : 2012:02:07 11:30:18+08:00
Format                          : application/pdf
Title                           : Microsoft Word - TRX-221 manual.doc
Creator                         : TEST
Document ID                     : uuid:78008305-cecc-4425-a0e8-a91384c62659
Instance ID                     : uuid:d2407fcd-b9a9-48e8-8df3-7f616603b222
Page Count                      : 9
Author                          : TEST

EXIF Metadata provided by EXIF.tools