Tranwo Technology MWF-5201 WiFi Module User Manual MWF 5200
Tranwo Technology Corp WiFi Module MWF 5200
User Manual.pdf
WiFi Module MWF‐5201 Specifications Version: 1.0 No. Version 1.0 Description Date Writer Initial 2014‐06‐05 IVONA TRANWO TECHNOLOGY CORP. www.tranwo.com No.236, Sec.3, Huanbei Rd., Jubei City, Hsinchu County 30265, Taiwan Tel:886-3-553-5326 Fax:886-3-553-5283 WiFi Module MWF‐5201 1. Features Compliant with IEEE802.11b/g/n、IEEE802.3、IEEE802.3u Support CSMA/CA、CSMA/CD、TCP/IP、PPPoE、DHCP、ICMP、NAT protocol Embedded PA/LNA 150Mbps PHY data rate 20Mhz/40Mhz channel width Standard IEEE 802.11 b/g/n、IEEE802.3、IEEE802.3u、CSMA/CA、 CSMA/CD、TCP/IP、PPPoE、DHCP、ICMP、NAT、PPPoE WAN One 10/100M port LAN One 10/100M port Frequency 2.4 ~ 2.4835GHz 11n:135 / 121.5 / 108 / 81 / 54 / 40.5 / 27 / 13.5 Mbps Data Rate 65 / 58.5 / 52 / 39 / 26 / 19.5 / 13 / 6.5 Mbps 11g:54 / 48 / 36 / 24 / 18 / 12 / 9 / 6 Mbps 11b:11 / 5.5 / 2 / 1 Mbps Channel 14 Spread spectrum DSSS DBPSK、DQPSK、CCK and OFDM(BPSK/QPSK/16‐QAM/64‐QAM) Modulation type Sensitivity ‐64 dBm @135Mbps / 10% PER ‐70 dBm @54Mbps / 10% PER ‐85 dBm @11Mbps / 8% PER Transmit Power (Average) 11n : 23 dBm 11g : 23 dBm 11b : 20 dBm Power Dissipation 3.3V, 340mA (Typ.) / 430mA (Max.) TRANWO TECHNOLOGY CORP. www.tranwo.com No.236, Sec.3, Huanbei Rd., Jubei City, Hsinchu County 30265, Taiwan Tel:886-3-553-5326 Fax:886-3-553-5283 WiFi Module MWF‐5201 2. Interface Definition A. J1 Pin Definition Description Specification Notes 3.3V 3.3V DC input pin CPURST_N CPU reset GPIO2_/I2C_SCLK I2C Clock GPIO1_/I2C_SD I2C Data GND Ground GND Ground Pin Specification Notes UPHYO_PADP USB Data+ UPHYO_PADM USB Data‐ USB_GND Ground TXOM4 PHY4 TX‐ EPHY4 TXOP4 PHY4 TX+ ( Default WAN Port ) RXIM4 PHY4 RX‐ RXIP4 PHY4 RX+ RXIM3 PHY3 RX‐ EPHY3 RXIP3 PHY3 RX+ ( Default LAN Port ) 10 TXOM3 PHY3 TX‐ 11 TXOP3 PHY3 TX+ 12 GPIO11/RTSN See Table 1 13 GPIO12/TXD See Table 1 14 GPIO13/CTSN See Table 1 15 GPIO14/RXD See Table 1 16 GPIO10/I2SSD See Table 2: I2SSD 17 GPIO8/I2SWS See Table 2: I2SWS 18 GPIO9/I2SSDO See Table 2: I2S output 19 GPIO7/I2SCLK See Table 2: I2S clock 20 MCS1_N Clock output UART2 21 RXD2 UART2 RXD ( CONSOL ) 22 TXD2 UART2 TXD LED 23 W_LED WLAN Activity LED SPI 24 SPI_MISO SPI master in salve out GPIO / I2C Pin B. J2 Pin Definition Description USB GPIO / UART GPIO / I2S TRANWO TECHNOLOGY CORP. www.tranwo.com No.236, Sec.3, Huanbei Rd., Jubei City, Hsinchu County 30265, Taiwan Tel:886-3-553-5326 Fax:886-3-553-5283 WiFi Module MWF‐5201 LDO 25 SPI_CS0 SPI chip select0 26 SPI_CLK SPI clock 27 SPI_MOSI SPI master out slave in 28 3.3V 3.3V DC input pin 29 SOD_1.8V Power supply to 10/100 transformer 30 GND Ground Pin Specification Notes GND Ground ANT1 WiFi Antenna connector GND Ground C. J3 Pin Definition Description Antenna Port 3. I/O Design Definition Table 1: GPIO share scheme: RXD2 TXD2 RIN DSR_N DCD_N DTR_N RXD CTS_N TXD RTS_N SPI_MISO SPI_MOSI SPI_CLK SPI_CSO I2C_SCLK I2C_SD GPIO0 UART UARTF SPI I2C GPIO GPIO#16 GPIO#15 GPIO#14 GPIO#13 GPIO#12 GPIO#11 GPIO#10 GPIO#9 GPIO#8 GPIO#7 GPIO#6 GPIO#5 GPIO#4 GPIO#3 GPIO#2 GPIO#1 GPIO#0 Table 2: UART pin share scheme Pin Name RIN DSR_N DCD_N DTR_N RXD CTS_N TXD RTS_N 3’b000 UARTF RIN DSR_N DCD_N DTR_N RXD CTS_N TXD RTS_N 3’b001 PCM, UARTF PCMDTX PCMDRX PCMCLK PCMFS RXD CTS_N TXD RTS_N 3’b010 PCM, I2S PCMDTX PCMDRX PCMCLK PCMFS I2SSDI I2SSDO I2SWS I2SCLK 3’b011 I2S UARTF RXD CTS_N TXD RTS_N I2SSDI I2SSDO I2SWS I2SCLK 3’b100 PCM, GPIO PCMDTX PCMDRX PCMCLK PCMFS GPIO#10 GPIO#9 GPIO#8 GPIO#7 TRANWO TECHNOLOGY CORP. www.tranwo.com No.236, Sec.3, Huanbei Rd., Jubei City, Hsinchu County 30265, Taiwan Tel:886-3-553-5326 Fax:886-3-553-5283 3’b101 GPIO UARTF GPIO#14 GPIO#13 GPIO#12 GPIO#11 RXD CTS_N TXD RTS_N 3’b110 GPIO I2S GPIO#14 GPIO#13 GPIO#12 GPIO#11 I2SSDI I2SSDO I2SWS I2SCLK 3’b111 GPIO GPIO#14 GPIO#13 GPIO#12 GPIO#11 GPIO#10 GPIO#9 GPIO#8 GPIO#7 WiFi Module MWF‐5201 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. there is no guarantee that interference will not occur in a particular installation. However, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ‐ Reorient or relocate the receiving antenna. ‐ Increase the separation between the equipment and receiver. ‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ‐ Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co‐located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end‐product for any additional compliance requirements required with this module TRANWO TECHNOLOGY CORP. www.tranwo.com No.236, Sec.3, Huanbei Rd., Jubei City, Hsinchu County 30265, Taiwan Tel:886-3-553-5326 Fax:886-3-553-5283 WiFi Module MWF‐5201 installed IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co‐location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re‐evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: O6LMWF‐5201”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual. TRANWO TECHNOLOGY CORP. www.tranwo.com No.236, Sec.3, Huanbei Rd., Jubei City, Hsinchu County 30265, Taiwan Tel:886-3-553-5326 Fax:886-3-553-5283
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V2.3 (128-bit) User Access : Print, Extract Tagged PDF : Yes XMP Toolkit : 3.1-701 Create Date : 2014:06:18 16:51:46+08:00 Creator Tool : Acrobat PDFMaker 10.0 Word 版 Modify Date : 2014:07:01 14:04:24+08:00 Metadata Date : 2014:07:01 14:04:24+08:00 Producer : Acrobat Distiller 10.0.0 (Windows) Keywords : Format : application/pdf Creator : Version: 1.0 Title : MWF-5200規格書 Description : Version: 1.0 Document ID : uuid:13d3a228-9a32-43fe-9d53-ea07ff3c16be Instance ID : uuid:494fa94f-65f0-4869-aa24-2977e82e901b Subject : 2 Company : 傳世通訊股份有限公司 Comments : Source Modified : D:20140618085134 Headline : Version: 1.0 Has XFA : No Page Count : 6 Page Layout : OneColumn Author : Version: 1.0EXIF Metadata provided by EXIF.tools