Trek Bicycle MFRFID1 RFID Module User Manual Installation Guide

Trek Bicycle Corporation RFID Module Installation Guide

Installation Guide (User Manual)

Installation Guide
MFRFID1
Compliance and Regulatory Statements
FCC Compliance Statement (USA)
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital Devices,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a residential environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the product manuals, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, the
user is encouraged to do one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced RF service technician for help.
The end product must be labeled, in a visible area, with the following:
Contains FCC ID: 2AHXD-MFRFID1
Modification Warning
The user is cautioned that any changes or modifications not expressly approved by BCycle LLC could
void the user s authority to operate the equipment.
RF Exposure Statement
This transmitter complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter, except in accordance with FCC multi- transmitter product procedures.
Canadian DOC Compliance Statement
Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada. This Class B digital
apparatus complies with Canadian ICES-003.
Industry Canada (IC) Warning
Le present appareil est conforme aux CNR d Industrie Canada applicables aux appareils radio exempts de
licence. L exploitation est autorisee aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l utilisateur de l appareil doit accepter tout brouillage radioelectrique subi, meme si le
brouillage est susceptible d’en compromettre le fonctionnement.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
1) This device may not cause interference.,
2) This device must accept any interference, including interference that may cause undesired
operation of the device.
The end product must be labeled, in a visible area, with the following:
Contains IC: 21334-MFRFID1
Approved Antenna information
Only the integrated antenna on module is allowed and cannot be user replaceable.
General
TheMFRFID1 modulehasbeencertifiedasaLimitedSingleModular.Additional
evaluationisrequiredforuseinallhostdevices.Thefollowingdescribestheinstallationprocedures
forthevarioushostsinwhichthemodulehasbeenevaluated.
Installation Instructions for Trek BCycle Dash
TheMFRFID1 isnotintendedforOEMintegratorsorendusers.Itcanonlybeinstalledinthe
TrekBCycleDash‐MainControlBoardPCBA(BCY‐000295‐01)atthegranteemanufacturingfacility.

Navigation menu