Turning Technologies RCRF03 ResponseCard RF LCD User Manual RCRF 03 User s Manual

Turning Technologies, LLC ResponseCard RF LCD RCRF 03 User s Manual

Exhibit D Users Manual per 2 1033 b3

Replace batteries With Maxell, CR2032, 3-Volt Coin Cell ONLY. Use of another battery may present risk of fire or explosion. The disposal of used batteries is governed by law in many countries world-wide. Therefore, please check your local regulations prior to battery disposal. Responsive Innovations ResponseCard RF LCD User’s Manual RCRF-03 User’s Manual Ver. Preliminary
REGULATORY INFORMATION FCC Statement This product has been tested and found to comply with Part 15 of the FCC Rules. Operation it subject to the following conditions: it may not cause harmful interference and must be accept interference received, including interference that may cause undesired operations. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Canada Statement This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Safety Statement WARNING, batteries may explode if mistreated. Do not recharge, disassemble or dispose in a fire.
pressed. Valid keys are ‘0’ through ‘9’. Valid RF Channels are ‘1’ through ‘82’. While in Set RF Channel mode pressing a valid key will cause the status LED to briefly flash YELLOW. When Set RF Channel Mode exits, the status LED indicates the result as follows: SOLID GREEN - Set RF Channel successful SOLID RED - Set RF Channel failed Overview: The RI RF LCD Keypad is designed to be used with the RI RF Receiver connected to a PC. The keypad transmits key presses via radio frequency to the RF receiver for accumulation by the PC. The keypad consists of 12 data keys (0-9, Go/Login, ?) and a single status LED. In Idle state, the LED is OFF. The keypad returns to idle state after completion of a key press. Standard Operation Mode: Initially the status LED is OFF. Pressing a single key will cause the key to be transmitted to the receiver. After pressing a key the status LED shows status as follows: Quick YELLOW Blink then OFF - Receiver is not accepting data at this time BLINKING YELLOW - key is being transmitted (up to 8 seconds) SOLID GREEN - key transmit successful - ready for input SOLID RED - key transmit failed – ready for input BLINKING GREEN - Receiver indicated correct answer BLINKING RED - Receiver indicated incorrect answer
Blinking Green and Blinking Red will only occur if the Receiver is configured to indicate a correct or incorrect answer (CORRECT POLLING mode). Setup Modes: Active at any time the keyboard is ready for input. Match Mode (Check RF connection) Press ‘?’ In order for Match Mode to operate properly an RF Receiver MUST also be placed into Match Mode. Quick YELLOW Blink then OFF - Receiver is not accepting data at this time BLINKING YELLOW - key is being transmitted SOLID GREEN - RF receiver found, but not in Match Mode SOLID RED - Key transmit failed BLINKING GREEN - RF receiver in Match Mode found BLINKING RED - RF receiver found, but not in Match Mode Auto Match Mode(find RF Receiver) Press Go/Login, while holding Go/Login, quickly press and hold ‘?’. Release both keys. In order for Auto Match Mode to operate properly an RF Receiver MUST also be placed into Match Mode, otherwise the keypad will always indicate that Auto Match Mode has failed. BLINKING YELLOW - search is in progress SOLID GREEN - search successful – Match Mode exits SOLID RED - search failed – Match Mode exits Set RF Channel Press GO/LOGIN Set RF Channel mode is indicated by the status LED flashing a RED then GREEN pattern. Set RF Channel mode exits automatically after three valid keys are pressed, if no valid key is pressed for 5 seconds, or at any time an invalid key is

Navigation menu