Tyco Safety Canada 10WS4920 Wireless Alarm Repeater User Manual

Digital Security Controls Ltd. Wireless Alarm Repeater 29007856R001 WS4920 1 0 INS ENG

a href="https://usermanual.wiki/Tyco-Safety-Canada" itemprop="url"> Tyco Safety Canada >

User Manual

NOTE: Use these instructions in conjunction with the installation manual of the alarm panel with which this equipment is intended to be used.WARNING: READ and SAVE These Instructions! Follow All WARNINGS AND INSTRUCTIONS specified within these instruction and/or on the equipment.WS4920 v1.0Installation Instructions29007856R001
SAFETY INSTRUCTIONS for WS4920 WIRELESS REPEATERIMPORTANT:This equipment, WS4920 WIRELESS REPEATER 1.0 shall be used installed and used within an environment that provides the pollution degree max 2 and overvoltages category II NONHAZARDOUS LOCATIONS, indoor only. The equipment is FIXED and DIRECT PLUG IN powered from the mains; it is designed to be installed by Service Persons only; [Service Person isdefined as a person having the appropriate technical training and experience necessary to be aware of hazards to which that person may be exposed in performing a task and of mea-sures to minimize the risks to that person or other persons. 1. The equipment is installed in a FIRE ENCLOSURE.2. If during the installation a knockout is removed, it is the installer's responsibility to ensure that the same degree of protection for the enclosure is provided by the use of bushings,fittings, etc.3. The enclosure must be secured to the building structure before operation.4. Internal wiring must be routed in a manner that prevents:•Excessive strain on wire and on terminal connections;•Loosening of terminal; connections;•Damage of conductor insulation5. It is the end-user and/or installer's responsibility to ensure that the disposal of the used batteries (battery pack) is made according to the waste recovery and recycling regulationsapplicable to the intended market.WARNING: When using equipment connected to the MAINS, always follow basic safety instructions. Refer to the SAFETY INSTRUCTIONS provided with this product; save them for(future) reference. Instruct the end-user regarding the safety precautions that shall be observed when operating this equipment.SAFETY precautions required during installation:• NEVER install this EQUIPMENT during A Lightning Storm!• NEVER touch uninsulated wires or terminals unless the Direct Plug In transformer has been disconnected • Ensure that Cables are positioned so that accidents cannot occur. Connected Cables must NOT be subject to excessive mechanical strain• Use Only the Power Supply supplied with this equipment. Use of unauthorized power supplies may cause damage the repeater!!!• The AC Socket/Outlet powering the equipment shall be located near the equipment and shall be easily accessible. • Do NOT locate this product where persons will walk on the secondary circuit cable(s). • Do NOT use extension cords to PLUG-IN the Power Supply of this equipment.• AVOID setting up the equipment near heaters, air conditioners, ventilators, and/or refrigerators • Do NOT connect to electrical outlets on the same circuit as large appliances.• Do NOT select a place exposed to direct sunlight, excessive heat, moisture, vapors, chemicals or dust.• Do NOT install this Equipment near water. (e.g., bath tub, wash bowl, kitchen/laundry sink, in a wet basement, or near swimming pool, etc.).• Do NOT install this equipment and its accessories in areas where there is a risk of explosion.• Do NOT connect this equipment to electrical outlets controlled by wall switches or automatic timers; avoid interference sources.WARNING: THIS EQUIPMENT HAS NO MAINS ON/OFF SWITCH. THE PLUG OF THE DIRECT PLUG-IN POWER SUPPLY IS INTENDED TO SERVE AS THE DISCONNECTING DEVICE IF THE EQUIPMENTMUST BE QUICKLY DISCONNECTED. IT IS IMPERATIVE THAT ACCESS TO THE MAINS PLUG AND ASSOCIATED MAINS SOCKET/OUTLET, IS NEVER OBSTRUCTED.
The WS4920 is a wireless repeater designed toextend the range of DSC one-way wirelesstransmitters and to improve signal qualitybetween the transmitter and the receiver. Usethe WS4920 to remedy transmission problemscaused by excessive noise or other interference,or by long distances between devices andreceivers. Up to 4 repeaters can be installed peralarm system.The WS4920 is compatible with all DSC 433MHz one-way wireless transmitters, receivers andalarm panels. It can also be used with 2-wayalarm panels, but only for 1-way devices.Specifications• Temperature range: 0°C to +50°C (32°F-122°F)• Humidity (Max): 5% - 93% R.H. non condensing• Transformer: 16VAC, 20VA• Battery backup time: 24 hours• Battery charging rate: 80% within 24 hours• Operating frequency: 433.92 MHz• Dimensions: H6.96, W4.47, D1.33 in.• Weight: 2 lb.UnpackingEnsure your package includes the following:Controls and IndicatorsThe WS4920 has three LEDs on the front usedto communicate information. The LEDs indicate the following:In addition, the WS4920 has an internal Pro-gramming button to place the repeater intoEnroll/Placement modes. It also includes ajumper to prevent RF jam troubles from beingsent to the panel. When the jumper is open, RFjam troubles are not transmitted.Install the WS4920 in the following order:A.Temporarily mount in preferred locationB.Connect power (battery first then AC)C. Receiver placement test (detects interferencebetween repeater and wireless devices)Introduction• One WS4920• One direct plug-in transformer (kit dependant)• Mounting hardware pack, including plastic wall plugs and screws• Installation instructionsLED Normal Mode(cover on)Installer Mode(cover off)Green On: AC presentFlashing: No AC, battery goodOff: No AC, low or dead battery1 flash: EnrolledFlashing: Placement test activeRed On: Battery not connectedFlashing: Low batteryOff: Battery good (if AC on)Flashing: Zone not enrolledYellow On: RF jam presentOff: No RF jamOn: Receiver place-ment test “bad”Off: Receiver place-ment test “good”Green YellowRedInstallationProgrammingButton
Download:
Mirror Download [FCC.gov]
Document ID1380436
Application IDK8/8FkRWnqdrtml6cTmYUg==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize51.64kB (645459 bits)
Date Submitted2010-11-23 00:00:00
Date Available2010-11-24 00:00:00
Creation Date2005-04-18 16:30:37
Producing SoftwareAcrobat Distiller 9.4.0 (Windows)
Document Lastmod2010-11-02 10:05:31
Document Title29007856R001_WS4920_1-0_INS_ENG.fm
Document CreatorFrameMaker 9.0
Document Author: dorth
FCC ID Filing: F5310WS4920

Navigation menu