U S Telemetry USTC-TED-0002E RTU Meter Telemetry Device User Manual two

Download:
Mirror Download [FCC.gov]
Document ID	140285
Application ID	OAJ+fP6KJJhSFoLMmluldw==
Document Description	Install Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	0.88kB (11016 bits)
Date Submitted	2001-03-14 00:00:00
Date Available	2001-03-14 00:00:00
Creation Date	0000-00-00 00:00:00
Producing Software	Acrobat PDFWriter 3.02 for Windows
Document Lastmod	2001-03-10 06:34:24
Document Title	two.PDF
Document Creator	Microsoft Word
Document Author:	Unknown

Axonn Corporation
U.S. Telemetry
Transmit Endpoint Device
Users Manual
RF Transmitter Installation Instructions
The USTC TED transmitter should only be installed by qualified service personnel.
The transmitter detects status or other data signals from the external binary inputs and low battery
and broadcasts that data to the system's CTS sites.
MOUNTING LOCATION
The USTC TED Transmitter is an RTU as defined by the FCC.
INSTALLATION INSTRUCTIONS
1. Supply the transmitter with DC power by inserting three 3-Volt batteries into the battery holder
inside the transmitter.
2. The unit will come pre-programmed with Transmitter ID. There will be field programming of the
unit for other parameters.
3. As the TED will be used to transmit utility-meter information to the CTS, the TED will be located
next to electric, water, or gas meters.
4. When installing the TED you should avoid areas near screens, metal window frames, circuit
breaker boxes, air conditioners and heaters if a suitable location for the unit may be found
elsewhere.
CAUTION:
This device is required to comply with FCC RF exposure requirements for mobile transmitting
devices. A separation of 20 cm (8 inches) or more must be maintained between the antenna and
all persons during device operations to satisfy RF exposure compliance.
TESTING THE TRANSMITTER
Following system installation, system testing is mandatory. This should be performed by locating
the TED in its final location and powering up the unit. On initial power-up, the TED will send out RF
messages every 4 seconds or more depending on programming. This will establish
communications with the CTS receiver and the information collected will then be used to judge
system performance
FCC NOTICE
The USTC TED transmitter generates and uses radio frequency energy. If not installed and used in
accordance with the manufacturer's instructions, it may cause interference to radio and television
reception. The transmitter has been tested and found to comply with the specifications in Part 95
of the FCC Rules.
If this equipment causes interference to radio or television reception - which can be determined
by turning the equipment on and off - the installer is encouraged to correct the interference by
one or more of the following measures: 1) Reorient the antenna of the radio/television. 2)
Connect the AC transformer to a different outlet so the TED and radio/television are on different
branch circuits. 3) Relocate the TED with respect to the radio/television.
If necessary, the installer should consult an experienced radio/television technician
for additional suggestions, or send for the "Interference Handbook" prepared by the
Federal Communications Commission. This booklet is available from the U.S.
Government Printing Office, Washington, D.C., 20402, stock number 004-000-00450-7.
CAUTION: Axonn Corporation does not support field changes or modifications to
any of the Axonn Corporation RF equipment unless they are specifically covered in
this manual. All adjustments must be made at the factory under the specific
guidelines set forth in our manufacturing processes. Any modification to the
equipment could void the user's authority to operate the equipment and render the
equipment in violation of FCC Part 95.
This device complies with Part 95 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
LIMITED WARRANTY
THERE ARE NOT WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON
THE FACE HEREOF. In no case shall Seller be liable to anyone for any consequential or
incidental damages for breach of this or any other warranty, express or implied, or upon
any other basis of liability whatsoever, even if the loss or damage is caused by Seller's
own negligence or fault.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : Microsoft Word
Create Date                     : Friday, March 09, 2001 1:45:39 PM
Title                           : two.PDF
Author                          : Unknown
Producer                        : Acrobat PDFWriter 3.02 for Windows
Subject                         : 
Modify Date                     : 2001:03:10 06:34:24-07:00
Page Count                      : 2

EXIF Metadata provided by EXIF.tools