UCLOUDLINK NETWORK TECHNOLOGY G1611 4G Wireless Data Terminal User Manual G1611 V1x
HONGKONG UCLOUDLINK NETWORK TECHNOLOGY LIMITED 4G Wireless Data Terminal G1611 V1x
User Manual
G1611 Manual ShenzhenuCloudlink Network Technology Ltd. 1. Product Overview 01:Proximity Sensor 02:Receiver 03:LCD Touch Display 04:Micro USB Port (Input): 05:SIM Slot 06:LED Indicator 07:USB Port (Output) Indicator Status: Red‐Low Battery ;Yellow‐Normal 08:Microphone 09:Volume Down Button 10:Volume Up Button 11:Power Button ; Green‐High Battery Chargers with an output of 5V‐1A are recommended 2.1 How to use 1.Connect to GlocalMe Wi‐Fi Note: Press and hold the power button “ ” for 3 seconds and wait for the G1611 to boot. Select “Login” to finish the following steps. (Login 1. Connect to 4G Wireless Data Terminal Wi‐Fi Wi‐Fi Hotspot:4G Wireless Data Terminal_XXXXX Password:XXXXX 2. Create your 4G Wireless Data Terminal Account on 4G Wireless Data Terminal App Get 4G Wireless Data Terminal App by scanning the above QR code. 3. Login your 4G Wireless Data Terminal Account on G1611 Device Use 4G Wireless Data Terminal App to scan the above QR code again or login manually >> After logining your G1611, the screen will show the amount, Wi‐Fi name and password. When the signal icon shows the local network operator. or , it indicates that the hotspot is successfully connected to How to charge the phone how long does it take? Charging the battery of the phone about 180 minutes using 5V USB power supply. You may use the common handset chargers. 2.2 How to use 2.Account Top up Use 4G Wireless Data Terminal App to top up . Our payment methods support PayPal, VISA/MasterCard (through PayPal), Alipay, etc. Scan to download App for Android &iOS Note: GlocalMe is powered by revolutionary cloud SIM technology, which does not require a SIM card. When 4G Wireless Data Terminal is working, it can automatically connect the local mobile broadband network provided by local mobile operator. Therefore, if you are in a location where mobile signal is poor or intermittent, 4G Wireless Data Terminal may not work well. 3 User Interface 01.Number of device connections 02.Remaining data 03.Account name 04.Charging mode (Package/ Non‐Package) 05.Account information 06.Hotspot information 07.Battery level 08.SIM card signal strength 09.Rate/Package name 10.Balance/Days to go of package 11.SIM Management 12.Others 4 Product Specifications Brand: GlocalMe Model: G1611 5 FAQ 1.How long does it take to be fully charged? About 7.5 hours. 2.How long it can work continuously? About 15 hours after a full charge. 3.How to change the Wi‐Fi name and password? Go to “My Hotspot”, make changes and save. 4. How to use it as a power bank? Charging starts as soon as the cable is inserted to the standard USB port. 5.What to do if you lost your device? Please change your 4G Wireless Data Terminal account password on App as soon as possible to protect your account balance. 6.How many devices can be connected to 4G Wireless Data Terminal G1611 at the same time? 5 devices. 7.How long does it take to connect to the internet after starting up? Normally 1‐2 minutes. It may take up to 10 minutes to start up for the first time in a country. 8.Why the signal icon shows 3G even if the device supports 4G? The 4G Wireless Data Terminal service depends on the local operators’ network, the 4G network is prioritized. When the 4G signal is weak, the signal will be transferred to 3G. Website:www.glocalme.com Phone Number:+852 8191 2660 or +86 400 822 1581 E‐mai:service@ucloudlink.com Facebook:GlocalMe HK GlocalMe International Twitter:@GlocalMeOnline Address:Unit D.16F,Chenknang plaza 250 Hennessy Road,wanchaiHongKong FCC Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ‐Reorient or relocate the receiving antenna. ‐Increase the separation between the equipment and receiver. ‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ‐Consult the dealer or an experienced radio/TV technician for help. The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types G1611 (FCC ID: 2AC88‐G1611) has also been tested against this SAR limit. The highest reported Hotspot Tissue SAR values is 0.99 W/kg for main board, and 0.81 W/kg for vice board respectively. The Max simultaneous SAR is 1.11 W/kg for main board, and 0.93 W/kg for vice board respectively. Website:www.glocalme.com Phone Number:+852 8191 2660 or +86 400 822 1581 E‐mai:service@ucloudlink.com Facebook:GlocalMe HK GlocalMe International Twitter:@GlocalMeOnline Address:Unit D.16F,Chenknang plaza 250 Hennessy Road,wanchaiHongKong
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : Administrator Create Date : 2017:04:07 15:49:39+08:00 Modify Date : 2017:04:07 15:49:39+08:00 XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Format : application/pdf Creator : Administrator Title : Microsoft Word - G1611_User Manual V1.docx Creator Tool : PScript5.dll Version 5.2.2 Producer : Acrobat Distiller 9.0.0 (Windows) Document ID : uuid:f2b88b29-8e55-42d4-9d7d-a1663e2a5b37 Instance ID : uuid:e36471f5-e7c2-4589-b3a6-f3861396c200 Page Count : 7EXIF Metadata provided by EXIF.tools