UTC Fire and Security Americas 715A-1PANIC 60-458-10-319.5 User Manual

UTC Fire & Security Americas Corporation, Inc. 60-458-10-319.5

User Manual

P/N 46-437 • REV D • 06JUN14 1 Learn Mode Handheld Panic Button Installation Instructions Overview Portable, hand held “P anic” transmitters are typically used as panic buttons to activate 24-hour “Police Emergency” alarms or 24-hour “Auxiliary” alarms. The single button transmitter can be activated by pressing anywhere within the “ALERT” box, and holding for one second. Figure 1: 60-458 and 60-457 Handheld Panic Button Activate the dual button transmitter by pressing both alert boxes at the same time for one second. The light control button is for systems with optional X-10 modules installed (Not investigated by UL) Battery Power The Single and Dual Button Alert Panic Transmitters are powered by a 3.6 volt Lithium battery (Saft LS3), which should last at least 1 year under normal circumstances. Programming General guidelines for programming this sensor are: 1. Set the CPU into Program Mode 2. Trip the panic by pressing the alert box(es) on panic. 3. Set the CPU to its normal operating mode. Note: Refer to the appropriate CPU installation manual for specific instructions for programming this sensor. Testing General guidelines for performing a Dealer Sensor Test are: 1. Using the appropriate touchpad for the CPU, enter the applicable Dealer Sensor Test code. 2. Trip the panic by pressing the alert box(es) on panic. 3. Note the number of beeps from the CPU. These beeps indicate how much of the panic button’s RF signal (rounds) is being heard by the CPU. Regulatory information Manufacturer UTC Fire & Security Americas Corporation, Inc. 1275 Red Fox Rd., Arden Hills, MN 55112-6943, USA FCC compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Interlogix can void the user’s authority to operate the equipment. FCC ID: B4Z-715A-1PANIC FCC ID: B4Z-715A-2PANIC IC compliance IC: 1175C-7151PANIC IC: 1175C-7152PANIC This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Le fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil peut ne pas provoquer d’interférences et (2) cet appareil doit accepter toutes interférences, y compris les interférences pouvant provoquer un fonctionnement non désiré de l’appareil. Contact information For general information, see www.interlogix.com. For customer/technical support, see www.interlogix.com/customer-support or call +1 855 286 8889. © 2014 United Technologies Corporation. Interlogix is part of UTC Building and Industrial Systems, a unit of United Technologies Corporation. All rights reserved. Light control

Navigation menu