Umigo Technology L10 LED Remote Control User Manual
Umigo Technology Ltd. LED Remote Control
User Manual
L10 Remote control use instruction
1. Introduction : Remote control build in 250mAh polymer rechargeable batteries, When it is in
fully charged, more than 3 months for standby, more than 70 hours for continuous working. The
control distance is more than 10 meters.
2. Functional specifications:
1) Press the ①key to turn it off , Press any ②③④⑤⑥⑦ key to turn it on.
2) ①is the key for closing, the remote control will enter standby mode once pressed this key.
3) ②③④⑤⑥⑦ are the patterns function keys , The corresponding pattern on the backpack
will be displayed once pressed these keys.
4) ⑧is the input port for charging, Connect the Micro‐USB cable to charge it when the remoted
control become low battery.
5) When in charging, ⑦key will show the red light, and the red light will be closed after finish
the charge.
3. Technical parameters:
Model Name Wireless Remote control
Model No. L10
Input 5.0V/100mA
Volume 65*39*16mm
Battery Capacity 3.7V/250mAh/0.925WH
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.