VALEO Telematik und Akustik CKIII-HFP CKIII-HFP User Manual UserMan

Download:
Mirror Download [FCC.gov]
Document ID	620969
Application ID	LMb/7JIZedFSu6BeuVGX3w==
Document Description	UserMan
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	12.9kB (161247 bits)
Date Submitted	2006-01-19 00:00:00
Date Available	2006-01-18 00:00:00
Creation Date	2005-11-28 15:28:36
Producing Software	Acrobat Distiller 5.0.5 (Windows)
Document Lastmod	2006-01-19 11:42:35
Document Title	UserMan

• Accessories
Installation Instructions
Mercedes-Benz
Bluetooth® Cradle adaptor
Mercedes-Benz
Bluetooth® Cradle adaptor
1
M+P-03F-6311
The Mercedes-Benz approved/
recommended Bluetooth® Phones can be
utilized inside Mercedes-Benz vehicles
without affecting vehicle electronics.
Application
These installation instructions are valid for
vehicles with an MHI hands-free
communications systems and a
Mercedes-Benz-approved Bluetooth®
mobile telephone. An overview of approved
mobile telephones can be found on the
Internet at www.wireless4mb.com and is
available at any Mercedes-Benz Center.
Parts included
•
(1) Mercedes-Benz Bluetooth®
Cradle adaptor
Notes
Please contact your local Mercedes-Benz
Dealer if you encounter difficulties when
installing or operating the MB Bluetooth®
Cradle adaptor.
More information can be found on the
Internet at www.wireless4mb.com.
The manufacturer reserves the right to
change technical details from those shown
in the illustrations contained in these
installation instructions.
These installation instructions also refer to
the vehicle Operator’s Manual, COMAND
Operator’s Manual, and mobile telephone
manual. Please refer to them for reference.
-1-
RF Exposure statement:
The antenna shown in this filing must not
be co-located or operated in
conjunction with any other antenna or
transmitter. End users may not be
provided with the installation instructions.
OEM integrators and end
users must be provided with transmitter
operating conditions for satisfying
RF exposure compliance.
For portable applications OEM
integrators need no SAR evaluation. The
max source-based time-averaged output
of 0.0005 W is below the low threshold of
24mW for d < 1.5 cm.
Statement according to FCC part 15.21:
Modifications not expressly approved by
this company could void the user's
authority to operate the equipment.
Statement according to FCC part 15.105:
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
-1-
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver isconnected.
- Consult the dealer or an experienced
radio/TV technician for help.
-2-
Note
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
•
This device may not cause harmful
interference.
•
This device must accept any
interference received, including
interference that may cause
undesired operation.
Installing the MB Bluetooth® Cradle
adaptor
M+P-03F-6312
Insert the MB Bluetooth® Cradle adaptor (1)
into the catches on the pre-installed contact
plate (2), located in the center console.
While inserting the MB Bluetooth® Cradle
adaptor (1), slide it upwards until it clicks
into place.
-2-
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver isconnected.
- Consult the dealer or an experienced
radio/TV technician for help.
-2-
Pairing the mobile telephone with the
MB Bluetooth® Cradle adaptor
Make sure that the starter switch is in
position 1 (see the vehicle Operator’s
Manual).
M+P-03F-6313
1. With MB Bluetooth® Cradle adaptor
connected to vehicle press the
button (3) for approx. 2-3 seconds.
LED's will begin to flash rapidly. The
MB Bluetooth® Cradle adaptor is in
Discovery Mode and can be detected by a
Bluetooth® mobile telephone. The
MB Bluetooth® Cradle adaptor will appear
as "MB Phone system" on the mobile
telephone. The mobile telephone will prompt
the user for a Pass-Key.
2. For instructions on how to get the
mobile telephone ready for pairing, see the
mobile telephone manual or go to
www.wireless4mb.com. on the Internet.
Once the mobile telephone and
MB Bluetooth® Cradle adaptor find each
other the mobile telephone will prompt the
user to enter a Pass-Key.
-3-
4
M+P-03F-6379
3. To locate the Pass-Key remove cover (4)
by sliding it away from the MB Bluetooth®
Cradle adaptor. Located behind this
cover (4) there will be a sticker containing
the Pass-Key (5).
4. Enter the Pass-Key into the mobile
telephone. Depending on the type of mobile
telephone being used, it may be necessary
to confirm a connection request (see the
mobile telephone manual).
Once the Pass-Key has been entered and
accepted the LED's will be lit continuously.
This confirms that the mobile telephone is
paired and the mobile telephone information
has been stored in the MB Bluetooth®
Cradle adaptor.
-4-
The connection is re-established
automatically every time the mobile
telephone enters into the MB Bluetooth®
Cradle adaptor’s range, as long as the
mobile telephone is switched on and the
starter switch is in position 1 (see the vehicle
Operator’s Manual).
Depending on the type of mobile telephone
being used, a message may appear in the
display (see the mobile telephone manual).
The mobile telephone is now in hands-free
mode and it is possible to make calls using
the vehicle hands-free system (see the
vehicle Operator’s Manual or the COMAND
Operator’s Manual).
Note
A maximum of 4 mobile telephones can be
paired with the MB Bluetooth® Cradle
adaptor at a time. However, only one mobile
telephone is connected to the
MB Bluetooth® Cradle adaptor at a time. If a
fifth mobile telephone is paired with the
MB Bluetooth® Cradle adaptor, then the
information stored from the first mobile
telephone which was paired with the
MB Bluetooth® Cradle adaptor will be
deleted.
-5-
When the starter switch is in position 1
(see the vehicle Operator’s Manual), the
MB Bluetooth® Cradle adaptor will search
for the last connected mobile telephone and
reconnect. The mobile telephone will then be
reconnected as soon as it enters the range
of the MB Bluetooth® Cradle adaptor.
If the last-connected mobile telephone is not
detected, the second-to-last connected
mobile telephone (and so on) will be
searched for sequentially and, if detected by
the MB Bluetooth® Cradle adaptor,
reconnected.
If the connection between the
MB Bluetooth® Cradle adaptor and mobile
telephone is not established automatically, it
is possible to establish a connection
manually (see page 7).
When using Bluetooth® the mobile
telephone uses more power. Since the
mobile telephone is not being charged the
battery should have a sufficient charge.
SMS messages can not be accessed via the
COMAND or radio while the Bluetooth®
connection is established.
Different ring-tones of the mobile telephone
are not supported by the COMAND or radio.
3-way-calling is not supported from the
MB Bluetooth® V60 adaptor. A waiting call
will be signalized through an audible
notification.
The Tele Aid System (emergency call
system) will continue to function as
designed as long as there is a valid service
contract.
For a list of possible features visit
www.wireless4mb.com.
-6-
Connecting the mobile telephone and
MB Bluetooth® Cradle adaptor manually
Valid for all Mercedes-Benz vehicles with the
exception of the model year 2007 S-Class:
on the COMAND or
•
Press button
radio.
Model year 2007 S-Class vehicles:
•
See vehicle Operator's Manual.
Note
Before connecting the mobile telephone and
MB Bluetooth® Cradle adaptor manually, the
mobile telephone must already be paired
with the MB Bluetooth® Cradle adaptor (see
page 3).
When the mobile telephone is within the
range of the MB Bluetooth® Cradle adaptor,
the connection between the mobile
telephone and the MB Bluetooth® Cradle
adaptor remains active, and phone calls
made with the mobile telephone use the
vehicle’s hands-free system. For this reason,
the connection between the mobile
telephone and the MB Bluetooth® Cradle
adaptor should be disconnected manually if
the mobile telephone is taken out of the
vehicle (see page 9).
When the starter switch is in position 1
a connection between the mobile telephone
and the MB Bluetooth® Cradle adaptor will
be established.
In the case where the Bluetooth®
connection was disconnected manually
through the mobile telephone menu the
connection will not automatically be
reconnected. If the disconnection was
caused by the mobile telephone going out of
range of the MB Bluetooth® Cradle adaptor
the connection will automatically be
reconnected. If this is not the case, the
connection must be established manually.
-7-
Disconnecting the Bluetooth®connection automatically
The connection between the MB Bluetooth®
Cradle adaptor and the mobile telephone is
automatically disconnected if the maximum
range (30 ft) is exceeded. Depending on the
type of mobile telephone being used, it may
be necessary to confirm a connection
request (see the mobile telephone operating
instructions).
Note
When within the range of the MB Bluetooth®
Cradle adaptor, the connection between the
mobile telephone and the MB Bluetooth®
Cradle adaptor remains active, and phone
calls made with the mobile telephone use
the vehicle’s hands-free system. For this
reason, the connection between the mobile
telephone and the MB Bluetooth® Cradle
adaptor should be disconnected manually if
the mobile telephone is taken out of the
vehicle.
-8-
Disconnecting the Bluetooth®connection manually
The connection between the mobile
telephone and the MB Bluetooth® Cradle
adaptor can be disconnected at any time
(see the mobile telephone manual).
Disconnect the paired mobile telephone
from MB Bluetooth® Cradle adaptor using
COMAND or radio.
Valid for all Mercedes-Benz vehicles with the
exception of the model year 2007 S-Class:
on the
•
Press and hold button
COMAND or radio for approx.
3 seconds.
Model year 2007 S-Class vehicles:
•
See vehicle Operator's Manual.
Note
If a phone call is in progress, the connection
can only be disconnected directly on the
mobile telephone (see the mobile telephone
operating instructions).
-9-
Detaching the MB Bluetooth® Cradle
adaptor
M+P-03F-6314
Press and hold the release button (6). Slide
the MB Bluetooth® Cradle adaptor (1) in
direction of arrow (7) and remove it from the
pre-installed contact plate (2).
Operating instructions
Please refer to your Mercedes-Benz vehicle
Owner’s Manual for operating instructions
regarding the MHI hands-free
communication system cradle.
- 10 -
© 2005, Mercedes-Benz Accessories Inc.
Not to be reprinted, translated or otherwise
reproduced, either wholly or in part.
Mercedes-Benz Accessories Inc., Stuttgart ·
A DaimlerChrysler AG Company
11/05
03F029-05
Printed on 100 % Recycled Paper

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 17
Has XFA                         : No
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:3862041d-ebdb-4297-a87f-f6204d209e47
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Create Date                     : 2005:11:28 15:28:36Z
Modify Date                     : 2006:01:19 11:42:35+01:00
Metadata Date                   : 2006:01:19 11:42:35+01:00
Document ID                     : uuid:5ae09d3e-9791-4191-8e6c-eb6199bd60a9
Format                          : application/pdf

EXIF Metadata provided by EXIF.tools