VALEO Telematik und Akustik WMI2W205 Wireless Mobile Interface User Manual V1222 UserManual v1 8x
Peiker acustic GmbH Wireless Mobile Interface V1222 UserManual v1 8x
Contents
- 1. Users Manual
- 2. User Manual Revised
- 3. User manual revised
Users Manual
![________________________________________________________________________________________________________________________________ Page 18 VALEO – Product Line Valeo peiker Telematics - www.valeo.de 2.8 OPERATING MODES The system controller of the SBC manages register configuration and controls the internal functions. The system controller is a state machine. The SBC operating modes and the state transitions are shown in Figure 2.8-1. A detailed hardware characterization of the SBC operating modes by functional block is listed in the following Table 2.8-1 [1.] Determined by the setting of bits V2C in the regulator control register [2.] HVIO availability depends on the device variant [3.] Determined by the settings in the relevant HVIO control register [4.] See data sheet of the UJA1131HW/3V3, Determined by the settings in the SMPS control register [5.] Determined by the setting of bits CMC in the CAN control register [6.] Availability of LIN2 depends on the device variant [7.] Determined by the setting of bits LMCn in the LIN control register [8.] Determined by the settings of bits ENC and ENDC in the fail-safe control register [9.] Since V1 is off, EN can only operate as open-drain output in Sleep mode [10.] Determined by the setting of bit LHC in the Fail-safe control register [11.] Determined by the setting of bits WMC in the Watchdog control register Table 2.8-1: Hardware characterization by functional block](https://usermanual.wiki/VALEO-Telematik-und-Akustik/WMI2W205.Users-Manual/User-Guide-3891757-Page-18.png)
