VOLANTEXRC VOLANTEX757 Radio Control Product User Manual
VOLANTEXRC CO., LTD. Radio Control Product
User Manual
2
3
4
5
GAS INSTALLATION
Receiver Connection & Binding
6
DRONE Mode Switch
7
8
9
10
The system is not
connected
Your transmitter and receiver are too
close
Take transmitter 1 to 3 meters away from
receiver
You are around metal objects Try in an area with less metal around
The model selected is not the model
bound to
Check the selected model and ensure you
The model is not the bound one Rebind your transmitter and receiver
The receiver not
responding during
operation
Low battery voltage Charge your battery
Loose or damaged wires or connectors
between battery and receiver
Check the wires and connection between
the battery and receiver.
Repair or replace wires and/or connectors
FCC ID: 2ABYMVOLANTEX757
This device complies with Part 15 of the FCC Rules.
Operation is subject to
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
the following two conditions:
that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, If not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
© 2014