VTech Telecommunications 80-9496-00 1.9GHz Digital Modulation Cordless Speaker User Manual REVISION HISTORY

Download:
Mirror Download [FCC.gov]
Document ID	2130573
Application ID	efeUXxr7V99uFKdbBN/6cw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	38.5kB (481305 bits)
Date Submitted	2013-11-28 00:00:00
Date Available	2013-11-28 00:00:00
Creation Date	2013-11-20 11:54:27
Producing Software	Acrobat Distiller 8.1.0 (Windows)
Document Lastmod	2013-11-20 11:54:34
Document Title	REVISION HISTORY
Document Creator	Acrobat PDFMaker 8.1 for Word
Document Author:	VTech

USER MANUAL
Pendant
(Simple DECT phone for Elders)
Model : OOMA-HWSP01
IMPORTANT SAFETY INSTRUCTION :
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury, including the following:
1) Read and understand all the instructions.
2) Follow all warnings and instructions marked on the product.
3) Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a
damp cloth for cleaning.
4) Do not use this product near water (for example, near a bath tub, kitchen sink, swimming pool).
5) Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
6) Unplug this product from the wall outlet and refer servicing to Vtech under the following conditions:
• When the power supply cord or plug is damaged or frayed.
• If the product does not operate normally by following the operating instructions.
• If the product has been dropped and the cabinet has been damaged.
• If the product exhibits a distinct change in performance.
7) Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of
electric shock from lightning.
8) Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS
Caution for Rechargeable battery :
1) The Pendant is equipped with Li-ion battery. You cannot replace it by yourself. Do not disassemble the unit
and take out or replace the battery pack.
2) The use of other battery types or non-rechargeable batteries/primary cells can be dangerous. These may
cause interference and/or unit damages. The manufacturer will not be held liable for damage arising from such
non-compliance.
3)
4)
5)
6)
Do not use third party charging bays. The batteries may be damaged.
Do not immerse the unit in water and do not place in fire.
Risk of explosion if you replace the battery by an incorrect type.
Dispose of the unit with Li-ion battery enclosed according to the instruction. Must be disposed of at the point of
sale or at the appropriate collection points provided by the public waste authorities.
Package contents
The package contains the following items:
• 1 Pendant unit with necklace attached
• 1 charger with AC power adapter
• 1 User manual
The maximum range between the base station and the Pendant is approximately 250 meters. Depending on the
surrounding conditions as well as spatial and structural factors, the range may be reduced. The range indoors is
normally less than outdoors.
1
INSTALLING YOUR PENDANT WITH A DECT PHONE
First to power up your Dect phone used at home.
Then power up the Pendant.
Do the registration procedure with the Dect phone. See section 4, “Enter Registration Mode”.
Pls use only the provided adaptor connected to the charger base.
Important : Charging the Pendant unit for at least 5 hours before use.
Power adaptor information for Pendant :
Manufacturer : Tenpao
Model : S005IU0600040, Input 100-120V AC 60Hz 150mA, Output 6VDC 400mA
Manufacturer : CHOU SEN ELECTRONICS (SZ) CO., LTD.
Model : CS2A060040LUF, Input 100-120V AC 60Hz 200mA, Output 6VDC 400mA
Battery installed in the unit :
Manfacturer : BYD
Type : Lithium-ion polymer rechargeable battery
Model : VT-02
Capacity : 3.7V, 450 mAh, 1.665 Wh
Start to know your Pendant :
1. The buttons and structure :
microphone
LED indicator
Loudspeaker
2. Functions for the Buttons :
POWER/TALK ON/OFF
In idle mode: Press to place a call. Press and hold to power the wireless headset on or off.
During a call: Press to end the call.
During registration: Press to exit the registration mode.
VOLUME UP
During a call: Press to increase the earpiece volume.
During ringing: Press to increase the ringer volume.
VOLUME DOWN/FLASH
During a call: Press to decrease the earpiece volume.
Press and hold for 2 seconds to do a Flash (R) to answer a second incoming call.
During ringing: Press to decrease the ringer volume.
M1
Short press to dial the direct Memory M1. This is for Confort 250/450 and GT350.
M2
Short press to dial the direct Memory M2. This is for Confort 250/450 and GT350.
RESET
Use a pin to push the button, it will reset the unit when it is found mal-function.
3. Front LED Indicator functions :
Purple:
Steady On : Un-register
Slow Flash (0.5s On -> 4.5s Off) : The unit is registered but the base is not available. Searching or out of range.
Blue:
1. Steadily on: When the PENDANT is seated in the base and fully charged.
2. Steadily on 3s (On 3s -> Off) : Once the PENDANT is successfully registered, the blue light will on for about
three seconds, and emit a long beep.
3. Double flashing (0.25 On -> 0.25 Off -> 0.25 On -> 9.25s Off, On for 2s when just off hook): Off hook.
4 .Double flashing (0.25 On -> 0.25 Off -> 0.25 On -> 9.25s Off , On for 2s when just off hook): Off hook but
the signal is weak. Hear 3 rapid beeps in every 10s.
5. Long flashing (0.5s On -> 4.5s Off ): The unit is in idle mode and off the base.
6. Continuously flashing (0.5s On -> 0.5s Off ): The unit is ringing and can be heard through the speaker.
Red:
1. Steadily on: When the unit is charging on the base.
2. Long flashing : Indicates that the battery is low, the unit is not on the base, and the unit will emit short double
beeps.
3. Double flashing (0.25 On -> 0.25 Off -> 0.25 On -> 9.25s Off ): Indicates that the battery is low while the unit
is in use and short double beeps will be emitted.
Red/Blue:
Toggling (0.5s Red On -> 0.5s Blue On) : The unit is in registration mode after press and hold Vol+ and Vol –
keys for 10s.
4. Enter Registration Mode :
To work as the handset extension, the Pendant must be registered to the base.
1. Press and hold  on the base station, until you hear a beep and the IN USE LED on base station starts
to flash.
2. Press and hold  together with  until the LED on wireless headset toggling between red and blue.
3. Place the Pendant unit close to the Base.
4. A long beep tone is generated and the LED on in blue for a while if the registration is successful.
Note: To register the Pendant unit, the system PIN of the Dect phone base should be 0000. Or else, the
registration will be failed.
Remark : It will hear the voice message in below 3 events :
1. Battery low
2. Out of range
3. Not Registered
4. Use the Pendant :
To receive a call with the Pendant :
Press the Phone on key when receiving a call with ringer on.
Talk to the caller with the PENDANT about 1 foot from your mouth.
After the caller release the line, press the Phone on key to standby mode.
To dial the M1 or M2 numbers stored in the Dect phone :
You can press the M1 or M2 key to dial the phone number which is stored in the M1 or M2 of the Dect phone.
Remarks :
1. Fine tune the speaker sound level refer to the incoming level and your hearing sensitivity, especially for elder
person.
2. The microphone is on the top left side. Do not cover it by your finger when in talk mode
3. Place the unit on the charger bay after use it to make sure the battery power is full.
4. If the unit is not working even the battery is charged, use a pin to reset the unit (there is the reset hole on the
rear side under the VOL - key.
Technical Specifications :
RF frequency band
Channels
Operating temperature
Nominal effective range
DC adaptor output
Operating times*
1921.536MHz – 1928.448MHz
32 deg F – 113 deg F
0 deg C – 45 deg C
250m outdoor
DC 6V @ 400mA
Talk time : up to seven hours
Standby : up to seven days
*Operating time varies depending on your actual use and the age of battery.
Li-ion battery warning :
This Class B digital apparatus complies with Canadian requirement : CAN ICES-3 (B)/NMB-3(B).
For body worn operation, this Pendant has been tested and meets the FCC RF exposure guidelines when
used with accessories supplied or designated for this product. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines.
Privacy of communications may not be ensured when using this device.
Service Centre phone number and web site.
In USA : 1 (888) 711 6662
Web site : www.ooma.com/support
In Canada : 1 (866) 929 6662

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Producer                        : Acrobat Distiller 8.1.0 (Windows)
Source Modified                 : D:20131120035357
Create Date                     : 2013:11:20 11:54:27+08:00
Creator Tool                    : Acrobat PDFMaker 8.1 for Word
Modify Date                     : 2013:11:20 11:54:34+08:00
Metadata Date                   : 2013:11:20 11:54:34+08:00
Document ID                     : uuid:49802a58-3eea-4aee-8ea4-cabe738ac7d0
Instance ID                     : uuid:a530c7d9-8baf-4aed-95c5-722cf5577413
Subject                         : 3
Format                          : application/pdf
Creator                         :  VTech
Title                           : REVISION HISTORY
Page Count                      : 9
Page Layout                     : OneColumn
Author                          :  VTech

EXIF Metadata provided by EXIF.tools