VXI 202555 Bluetooth Wireless Headset User Manual 202557X2 B350XT indd
VXI Corporation Bluetooth Wireless Headset 202557X2 B350XT indd
VXI >
User Manual
* A Multipoint Connection allows connection of two devices to the headset at the same time. For example, this could be two cell phones, or a phone and a VoIP dongle.
FCC NOTICE TO USERS; This part complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation. Users are not permitted to make changes or modify the device in any way. Changes or modifi cations not approved
by VXI Corporation will void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by
one or more of the following measures: - Reorient or relocate the receiving antennae - Increase the separation between the equipment and the receive - Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
CANADA / IC NOTICE TO USER: Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation of the device. This device complies with RSS-210 of Industry Canada. This Class B digital apparatus complies with Canadian ICES-003 (Cet appareil
numérique de la classe B est conforme à la norme NMB-003 du Canada).
VXI WARRANTY:
1. VXI warrants that your Xpressway headset system will be free from defects in material and workmanship for one year from the date of purchase. If, during the fi rst year from the date of
purchase, your Xpressway headset system fails to work due to a defect in material or workmanship, VXI will repair or replace the product, at its election, free of charge. Without proof of purchase,
the warranty period begins on the date of manufacture. Consumable components (for example, cushions, battery and fuse) are not included in this one-year warranty.
2. The foregoing limited warranty does not cover equipment failure attributable to accident, improper operation, misuse, abuse, or any cause other than defects in the materials or workmanship
of VXI’s products.
3. VXI’s obligations under this warranty are limited to repair or replacement (at our option) of any defective part returned to VXI at the customer’s expense. Returned products require a Return
Authorization that may be obtained by calling 1-800-742-8588. Products returned to VXI for repair under this warranty will be return shipped to the customer at VXI’s expense.
4. THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some
jurisdictions do not permit the exclusion of implied warranties and the foregoing exclusions may not apply to you.
5. In no event shall VXI be responsible for any other damages whatsoever, including direct, indirect, special, incidental, consequential, or other damages for breach of this or any other warranty,
express or implied.
VXI Corporation, One Front Street, Rollinsford, NH 03869 USA 1-800-742-8588 / 603-742-2888 / www.vxicorp.com / www.blueparrott.com
PN202556B ©2009 VXI Corporation Printed in China
HOW TO REPLACE THE AUTO CHARGER FUSE
If the green indicator light on the auto adapter (located next to the USB port) does not light up when plugged into the
power source, check the charger’s inline fuse. Replace with 2A 250V Fast-Blow glass fuse (3AG) if necessary. Fuses are
available at most automotive stores. To replace, unscrew the tip of the auto adapter (see photo, right) and remove the
fuse. Put new fuse in and screw the tip back on.
MODES OF OPERATION BUTTON PRESS LIGHT INDICATORS AUDIO INDICATORS
TURN ON MFB - 3 second press Blue fl ashes 2 notes rising, followed by short
tone when Bluetooth
connected
TURN OFF MFB - 4 second press Red fl ashes 2 notes falling, followed by short
tone when Bluetooth disconnected
PAIRING MFB - 6 second press Blue quickly fl ashing 2 notes rising, followed by 4 notes
rising
ON - NO BLUETOOTH CONNECTION NA Blue double blink NA
ON - BLUETOOTH CONNECTED NA Blue fl ashing slowly NA
MAKE A CALL Dial from keypad or use Voice Dial NA NA
END A CALL MFB: 1 tap NA 2 notes falling
ANSWER A CALL MFB: 1 tap during ring tone NA 2 notes rising
VOICE DIAL - ACTIVATE / DEACTIVATE MFB: 1 tap NA 1 beep
REJECT A CALL MFB: 1 second press during ring
tone NA 2 notes falling
LAST NUMBER REDIAL 1 second press of Volume Down
button NA 1 beep
CALL WAITING - ANSWER / SWITCH BETWEEN CALLS MFB: 2 quick taps NA Beep heard when call is incoming
CALL WAITING - END CALLS MFB: 1 tap to end active call. Tap
once again to answer call on hold.
Tap once more to disconnect
second caller
NA Call on hold will ring the headset
after the active call
is disconnected
TRANSFER AUDIO WHILE ON A CALL 1 second press of Volume Down
button NA 1 Long tone
SEND CALL ON HOLD TO VOICE MAIL MFB: 1 second press NA Long tone
VOLUME UP / VOLUME DOWN Tap Volume Up or Volume Down
button NA 1 beep each time tapped
MUTE / UNMUTE 1 second press of Volume Up
button NA 1 beep. Short beep every 10
seconds while muted
TURN LEDS (LIGHTS) OFF / ON Tap Volume Up and Volume Down
buttons at the same time Lights go out NA
MULTIPOINT CONNECTION * - ENABLE Tap MFB, Volume Up and Volume
Down buttons all at the same time NA 4 notes rising
REESTABLISH LOST BLUETOOTH CONNECTION WITH
PHONE (PHONE IS ALREADY PAIRED AND TURNED ON) MFB: 1 tap Blue fl ashing slowly NA
LOW BATTERY WARNING NA Red fl ashes Long tone / 30 sec.
CHARGING IN PROCESS NA Red (not fl ashing) NA
CHARGING COMPLETE NA Green (not fl ashing) NA
OPERATIONS GUIDE
TIPS
Keep microphone positioned near the corner of your mouth. Correct positioning ensures that the noise-canceling
technology works properly.
If you have not used the headset for an extended period, charge the headset for 3½ hours before using.
Unscrew
Tip
Indicator
Light
CHARGE THE HEADSET
Refer to photos above
Connect small end of the USB cord into the
headset’s USB charging port.
Choose Charging Method: Plug other
end of cord into the Auto or AC charger
and then plug the charger into the power
source. Or, to charge the headset on your
computer, plug the USB cord directly into
your computer’s USB port.
An initial overnight charge is recommended.
Afterwards, charge 3½ hours for a full charge.
Charging Indicator Lights:
Red Light - Charging in process
Green Light - Fully charged
Insert disk into cushion so the ridge is seen
on fl at side of the cushion.
Attach headband, then cushion.
OVER-
THE-HEAD
WEARING
STYLE
Optional: Attach
receiver cover for
added stability
OVER-
THE-EAR
WEARING
STYLE
Attach ear hook
Attach behind-the-neck headband as shown.
Then attach cushion as described in the over-
the-head style.
BEHIND-
THE-NECK
WEARING
STYLE
PAIR HEADSET WITH PHONE
Turn off headset.
Place headset and phone within 3 ft. of
each other. Keep other Bluetooth devices
at least 50 feet away or turn them off.
Press the MFB on the headset for about
6 seconds until the blue light fl ashes
continuously.
Put phone into Bluetooth Discovery Mode
(“Add New Devices”).
Enter pass code of 0000 when prompted.
When the blue light changes from a quick
fl ash to a slower fl ash, pairing is complete.
COMPONENTS
1. Behind-the-Neck Headband
2. Over-the-Head Headband
3. Ear Cushion Mounting Disks (2 sizes)
4. Foam Ear Cushions (2 sizes)
5. Leatherette Ear Cushions (2 sizes)
6. Xpressway™ Headset
7. Ear Hook
8. Receiver Cover
9. USB Cord
10. Auto Charger
11. Wall Charger
7.
1. 2.
3.
4.
5.
6.
8.
9.
10.
11.
®Xpressway™
USER GUIDE
Convertible!
3 wearing
styles
SAFETY INSTRUCTIONS
Avoid hearing damage. Set volume at lowest comfortable
level. If you experience ringing in your ears or people sound
muffl ed, stop using the headset. Avoid turning up volume
to block noisy surroundings (it’s possible to adapt to volume
that is too high).
Check with local and state laws regarding cell phone
handset usage while operating a motor vehicle.
Do not immerse any part of this product in water.
Plastic bags and small parts may cause choking if ingested
Keep them away from small children and pets.
Use only the power cords included with this product.
Avoid temperatures exceeding 140°F.
TALK TIME AND RANGE
Range: Up to 66 feet. Certain conditions
and obstructions, such as wireless
devices, placing the phone on a metal
surface (such as the hood of a car),
walls, etc. can reduce range.
Talk Time Duration: 16+ hrs on a full charge
Standby Time Duration: Up to 150 hours
on a full charge
Multifunction Button
(MFB)
Volume Up Button
Volume Down Button
USB Charging Port
If the headband is too tight, pull
ends outward to widen the band.
Compatible with most Bluetooth phones & Bluetooth
enabled computers (Windows® or Macintosh®)